Question about Buick LeSabre

1 Answer

1998 LaSaber won't start, changed the ignition moduele ran for a day. Now won't start

Car would run then shut of or just won't start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 210 Answers

Defective crank angle sensor can cause this. No fuel, too. Check fuel pressure in rail. Perhaps fuel pump not running (bad pump). Clogged fuel filter a possibility if no fuel pressure.

Posted on Jan 14, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: seccurity light staying on car starts and shuts right off gas gauge shows empty

I had the same problem recently. Was quoted $400 - 500 for a fix, but when they got in there it was just a wiring issue. Still cost $220, but that was labor only, took about 3 hours to fix.

Posted on Jul 25, 2008

csmock132
  • 4669 Answers

SOURCE: i need to replace my ignition control moduel

What engine?

Posted on Mar 19, 2009

emissionwiz
  • 75197 Answers

SOURCE: car starts run's 3 seconds shuts down

Your car is equipped with a system called PASSKEY standard on all GM cars and light trucks, try the following procedure to reset the system, the battery being dead will trigger the system.

PASSKEY LOCKOUT RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key.

Posted on Mar 30, 2009

  • 55 Answers

SOURCE: CAR WON'T START. NOT BATTERY. CHANGED FUSE AND RAN

There are way too many possibilities for us to try to start to diagnose your car. . Id check all fuses and fusible links if I were you., Body shops often jump start cars that are in their shops for long periods of time, Jump starting can cause alot of issues.

Posted on Aug 25, 2009

  • 161 Answers

SOURCE: Changed the ignition lock cylinder

anti theft device has shut down car setup to do so if someone steals it...new key was not chipped.check with dealer on how to reset

Posted on Jun 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 gmc jimmy starts in AM fine won't start after sitting in sun all day


Can you jumper the fuel pump and make it start and continue to run ?
Have you checked to see if you are getting spark when it won't start ?
Could be a relay or coil, ignition module, or other component.

Aug 08, 2012 | 2000 GMC Jimmy

1 Answer

1998 sunfire ran for while after changing starter shut it off now it won't start


Check THEFT light on in dashboard, if YES, check disarm procedure in the Owners MAnual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 16, 2012 | 1998 Pontiac Sunfire

2 Answers

1998 chevy s10 driving along and engine shut down.after sitting 10 min.it started but was rough.went 100.ft and it shut off again.sat for a while.it started and ran a couple miles like nothing was ever...


if it shuts off while driving and will not start back up for at least 10 minutes, then it may be the crank sensor doing this. is check engine light on! if so get it scanned to find problem code. if no scanner, auto-zone will scan for free. if light is on. CPS symtoms are: car dies and won't re-start till it cools down, or won't start at all. good-day ! crank sensor timing will be out of sync. it controls timing and sends info to pcm.

Jul 19, 2011 | 1998 Chevrolet S-10 Pickup

1 Answer

My 98 monte carlo runs good for a while and then cuts off. i have changed the fuel filter,gas passes through the filter but it still cuts off.


Have you changed the ignition moduel When the y get warm yhey tend to shut off the engine preventing it from starting until they cool back down

Apr 05, 2011 | 1998 Chevrolet Monte Carlo

1 Answer

Truck will not start. New plugs , crank sensor , distributor , cap, rotor . ignition control moduel. Has fire to plugs but will not start.


Whats the fuel pressure like? Will it run on starting fluid? You may just have an Inertia switch that has tripped and shut off the fuel pump. Were all of these replacement parts done because it did not start or was it running before you changed parts?

Nov 17, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Day running lights do not shut down when the car ignition is off


They are ran by a relay timer that can go bad. You can go to autozone.com and register for full free online repair manual.

Sep 23, 2009 | 1998 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...