Question about Cars & Trucks

1 Answer

My toyota camry 1995 200i brake light keeps coming on brake fluid levels are fine please help

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,679 Answers

Try adjusting brak light switch located above brake pedal usually just have to disconnect the wires screw the switch roundanti clockwise a full 360 degress refit wire and test if still on repeat process,let me know how you get on

Posted on Mar 31, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


SOURCE: 1992 toyota camry tight steering

yes , i am sure you checked for leaks on the rack at the boots on both ends near the wheels. if none try adding a power steering conditioner to the pump . drain the fliud from the reservoir first by taking off one of the hoses the more conditioner the better. this may not work but it is an easy and cheap way first. there is also a relief valve in many pumps that might be stuck not allowing pressure to build.

Posted on May 31, 2008

  • 2 Answers


Check the trunk wire harness right by the left side trunk lid hinge for broken wires. This is a common problem on these cars. If the wires are broken you will have to repair them. The best way is to add short lengths of wires to the breaks and solder them back together. Use electrical tape to recover the harness.

Posted on Feb 01, 2009

  • 1861 Answers

SOURCE: 2003 Toyota Camry - Both Brake lights not working

Lok in the trunk on the left side, behind the carpet for a small plastic box with a bunch of wires going to it. Look to see if there is brake light powe coming in with the pedal depressed. If so, and no power is coming out, you need to order and replace the "taillamp failure sensor".

Posted on Jul 16, 2009

  • 2004 Answers

SOURCE: 1996 Toyota Camry question. If the brakes start

Not at all.

Posted on Sep 28, 2009

Testimonial: "Thanks!"

  • 1986 Answers

SOURCE: How to change a third brake light bulb for 1993 Toyota Camry?

open the trunk and look up along the top of the bumper and you should see two screws / nuts that secure the light assembly.

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Camry Brakes

hi . if the abs light is on its usually a sensor that's gone down.if so will need to be changed. before light goes off. after reset.

Jan 01, 2014 | 2011 Toyota Camry Hybrid

1 Answer

The break light warning sign comes on when i turn the lights on, even though all the back lights are working

It's not on when the lights are off?? Check your brake fluid level....You COULD have a bad fluid level sensor......If nothing else pans out, make sure your E-brake is completely released.

Nov 09, 2010 | 1998 Toyota Camry

1 Answer

My brake light came on in my 1995 toyota camry

The first thing to check is the brake fluid level. If it is low than top it off with brake fluid only!!!! The light should go out. The next thing to do if this is the case is check the brakes. Low brake fluid is a good indicator of either the brakes getting worn out or a leak in the brake system.

If the fluid is full make sure the emergency brake is not on. This will also cause the brake light to come on.

I’m happy to assist further over the phone at

Oct 27, 2010 | 1995 Toyota Camry

1 Answer

When i press on the brakes the warning light comes on even though my brake lights work

Check if the level of fluid in the pump the brakes this bien.Cuando alo minimum level is reached that will produce

Jan 14, 2010 | 1999 Toyota Camry

1 Answer

Why is My Brake Lights Are On In My 92 Toyota Camry...

add fluid then recheck for the light, also when fluid level goes down it means the brakes are nearly worn out.

Apr 23, 2009 | 1992 Toyota Camry V6

2 Answers

When brake is applied,the rear light on the panel come on.

You might wanna have your rear brakes checked along with the rear brake calipers or cylinders, as well as the rear drums or discs, depending on weather your car has rear drum brakes or rear discs brakes. Some cars come equipped with brake sensors that let you know when theres a problem. It would also be a good idea to check you brake fluid level.

Mar 12, 2009 | 1990 Toyota Camry

1 Answer

My Brake Light on My dashboard is coming on when I brake, but the fluid is above the minimum level, and I had my brakes looked at less than a year ago. the dashboard brake light comes on intermittently...

You hava very common issue.
The brake fluid contracts when it is cold. The level may be "above the minimum", but being there allows the sensor to activate when it is cold, due to the contraction aspect of the brake fluid...
Add 1 ounce of brake fluid, and you problem will disappear.
A FixYa rating for my assistance would be greatly appreciated.

Feb 01, 2009 | 2003 Toyota Camry Solara

1 Answer

"Brakes" light periodically coming on

hi how are you the fluid resivor is located on the drivers side under the hood just under windshield. will be squear or roundish in shape with a cover/cap.

Jan 29, 2009 | 1997 Toyota Camry

1 Answer

Break light coming on and off

There is a sensor in the master cylinder reservoir, that measures the amount of brake fluid in the reservoir. As the pads wear, the fluid level drops proportionally. When the pads are near the replacement interval, the fluid level is lowest, and the sensor trips the light. Best advise: Get the front brakes checked, they may be due for replacement.

Jan 15, 2009 | 2002 Toyota Camry Solara

1 Answer

Brake light comes on and off

Your brake master cylinder is low on fluid. There is a sensor that measures the level of the brake fluid. As the brakes wear, the fluid level drops proportionally.

Jul 03, 2008 | 1999 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides