Question about 2007 Jeep Compass Limited

Open Question

Battery disconet TCM internal

Code p161B

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I solve a problem on my 2013 jeep compass with error code p161b


I use a software called autodata and there is no P161b code listed.
I did find
P016b- closed loop mixture control , limit reached - system too rich
P0161- heated oxygen sensor bank 2

Jun 03, 2017 | Jeep Cars & Trucks

1 Answer

My 2016 jeep compass error code P161B came up on check engine what is this


car is in warranty
ask them.
the dealer. the fix is free.
the code means the cars battery read low.
did leave head lights on. parked?
are you in alaska, and its -50F out side.
did someone fool with the battery

Jan 06, 2017 | Jeep Cars & Trucks

1 Answer

How to repair p161b on a 2016 jeep compass


P161b is not a valid fault code. Please recheck.

Oct 24, 2016 | Jeep Cars & Trucks

1 Answer

2007 Compass. What are the probable causes of DTCs P161B and P0700?


which engine? first year is 2007
which one? errors very by , ENGINE!
2.0 L World I4 (gasoline)
2.0 L VW I4 (turbo diesel)
2.2 L OM651 I4 (turbo diesel)
2.4 L World I4 (gasoline)


p07 means transmission errors,. and need a real scan tool to read them ALL full codes, 700 means (have errors in trans scan me the correct and full way)
P161b (p1 means jeep factory codes, power train)

not B161 or P1618
are you sure, it matters.
this means the battery was low
the battery was disonnected
or while cranking at -40F starter overloaded a weak or discharged battery.... (heard the starter run slow, did you?)
it means battery voltage discover too low for any reasons.,.
P161B-BATTERY DISCONNECT / TCM INTERNAL

16be68b4-e970-47f6-b47f-99709fbee501.jpg

Feb 16, 2016 | Jeep Cars & Trucks

1 Answer

07 Aveo error codes p2110 and p161b. Can this be a bad battery?


code p2110 refers to throttle actuator control (TAC) system-forced limited rpm mode (limp mode)===causes wiring--tac motor- APP sensor--ECM
it also refers to heated oxygen sensor(HO2S) 1 bank 1 implausible signal===causes wiring .--short to positive-- short to ground--HO2S sensor---ECM
Check/replace the HO2S sensor and check the APP sensor and TAC motor.

Nov 02, 2014 | 2007 Chevrolet Aveo Sedan

1 Answer

WHAT IS CODE P161B


2009, what engine there, and transmission?>
gas engine, or diesel and what size engine,?
in what country? must i guess, that too?

p161b
P means power train.
1xxx are factory codes, 0xxx are fed standard codes.
so that means, only jeep books are accurate here.

where did you see that, (in the cluster) ???????????
or someone scan tool> or someone yelled it over shoulders, and said it wrong./????????????
was it really? and 8? or b? (kinda matters, no?) accurate inputs.
P1618-SENSOR REFERENCE VOLTAGE 1 CIRCUIT ERRATIC
P161b ( see how easy it is to get the code wrong)?

rumor has it as
P161B: Battery disconnect/TCM internal.

clean the battery terminals,
or battery weak, voltage not 12.6vdc rested
or alternator dead, and not charging battery.

to find it, login to Mitchell.
and see all codes
http://www.eautorepair.net/Marketing/Default.asp


or you disconnected the battery while key was on?
or failed to clear all DTC first
then see if the code comes bacK>?

Jul 05, 2014 | 2009 Jeep Compass

2 Answers

Help.. I have an 2002 dodge caravan witha 3.3. The codes pulled from it are P0700and P0605 which i know is with the Tcm but I have no power to the tcm plug unless you take the negative off from the battery...


HI, the actual p700 is an indication of a stored code that exists within the TCM module. The actual code will be the p0605, which is an internal failure alert that exists within the actual tcm module board sector. There may be board level damage to the internal layout which is causing a major short or misdirection or power to the vital circuits needed to provide necessary direction for the transmission. You will need to replace the module at this point. It is not repairable, unfortunately, due to the state of its design. Once it is replaced, it will need to be re-calibrated by a dealer scan tool before normal speedometer function will resume.

In conclusion, replacing the TCM will correct this issue. I would also inspect all connecters for faults before installing the new module.

Oct 08, 2011 | 2002 Dodge Caravan

1 Answer

P1621


Trouble code P1621 means: Engine control module engine immobilization input circuit malfunction The Transmission Control Module (TCM) contains various types of memory to gather and share information internally. At shut down, the TCM stores information in memory to prepare for the next ignition cycle. When the TCM cannot communicate internally, DTC P1621 sets. DTC P1621 is a type A DTC.

DTC PARAMETERS
DTC P1621 will set if the TCM cannot communicate internally for a proper shut down.

DIAGNOSTIC AIDS
The suggested repair is TCM replacement. Remember to program the replacement TCM with the correct software and calibration.
however Ive know loose positive battery cable to toss out that code, so check your connections


May 21, 2011 | 1992 Jaguar XJ6

1 Answer

My car will not start starter will not turn over. i took my car to a mechanic and he ran the fault codes for me and came up with P161B P0700 P0113 electrical shifting isnt working at the moment


Possible causes:

WRONG VEHICLE CALIBRATION FUSED B(+), TRANSMISSION CONTROL OUTPUT, AND/OR GROUND OPEN TRANSMISSION CONTROL MODULE (TCM)

Jul 04, 2009 | 2008 Jeep Compass

Not finding what you are looking for?
2007 Jeep Compass Limited Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...