Question about 1999 Isuzu Rodeo

2 Answers

How in the hell do you remove the spark plugs on a 1999 isuzu rodeo 4cyl 2.3l??? I have removed the wires, but I can't remove the housing over the plug. It seems that it is connected or pushes against part of the fuel injector? I can't believe I am the only person having this issue.

Posted by on

  • donald_dillo Jun 15, 2009

    2.2L 4 cyl, sorry this is my first foreign 4 cyl and I am not impressed so far. I read a post earlier where they talked about plugs being under a plastic cover on top of the engine, though I have not got to it yet, as its a star socket and I need to go out and pick up a set. checking the autozone web right now.



2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

I would need engine size to be able to tell you. You can view a full free online repair manual for your rodeo at

Posted on Jun 15, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same exact car you have. you have the plate off the top of the motor, spark plugs are under that. hope that helps.

Posted on Jun 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to change starter on 2000 Isuzu rodeo

like all cars. youtube it.
1: REMOVE battery neg lug.
2: remove the wire to starter solenoid.
3: remove the bolts, holding it to bell housing.
bam its out.
reverse above to put back.

Aug 21, 2014 | 2000 Isuzu Rodeo

1 Answer

I would like to know how to change the spark plugs on the 1999 Isuzu Rodeo 3.2 liter

unplug the connectors for the ignition coil packs, then unbolt coil packs, remove coil packs (all 6 are interchangable) then remove and replace spark plugs. There is a row of three coil packs behind the oil fill cap on the valve cover and three on the other side.

Apr 25, 2012 | Isuzu Rodeo Cars & Trucks

2 Answers

The right headlight and right taillight are both out on my 1999 isuzu rodeo. Can changing the fuses help?

No if the bulbs are out, then you have to change the bulb just like you would in a lamp in your house. Take it to your local autozone and they can help you get the right bulb for your car

May 02, 2011 | 1999 Isuzu Rodeo

1 Answer

How do you replace the starter on a 2001 Isuzu Rodeo 4cyl 2WD?

Remove the battery earth cable. Engage parking brake and chock the wheels. The starter is on the lower rear left hand side of the engine. Remove the starter supply cable by undoing the 13mm nut on the rear of the solenoid. Unclip the start wire on the side of the solenoid by squeezing and then pulling the connector plug. Undo the mounting bolt on the top of the starter first. and remove. Then the bottom one. Doing it this way round will make it easier to undo the bolts by hand once loosened.
Pull the starter to the front of the car and remove.

Aug 21, 2010 | 2001 Isuzu Rodeo

2 Answers

Where is the crank sensor located at on 1999 isuzu rodeo?

Where Is The Camshaft Position Sensor Located On A 1999 Isuzu Rodeo?

Jan 10, 2010 | 1999 Isuzu Rodeo

2 Answers

Replaced starter when battery was connected it started sparking and smoking.

Sounds like he may have pinched a wire or hooked it up backwards or has the power wire touching the starter housing.

Jun 02, 2009 | 1999 Isuzu Rodeo

1 Answer

1999 isuzu 3.2 misfire

This could be a problem with the spark plug wires. If resistance is high or the boots have carbon tracks, they could be causing spark to go places it shouldn't. Distributor cap?
Make sure places like that are clean and dry. Check for grease or dirt inside spark plug boots. If all else fails, open the hood in the dark and look for sparks jumping around the engine when you rev it up. If so, replace the plug wires.

May 19, 2009 | 1999 Isuzu Rodeo

1 Answer

Replacing Cam Sensor in a 1999 Rodeo

it probably screws in can you put a wrench on it. if not it may have to be removed from the inside

Oct 23, 2008 | 1999 Isuzu Rodeo

2 Answers

Is my '99 Isuzu Rodeo a single OR a dual cam? How can I find out?

1999 Isuzo Rodeo. 3.5 L or 3.2L V6. Is a DOHC. Double over head cam.
and the engine 2.2 L 4cyl. SOHC, single over head cam.
The angibe 2.3 L 4cyl. Is DOHC.

OK.. I hope this help on your question.

Thank you for use fixya...

Aug 07, 2008 | 1999 Isuzu Rodeo

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

Related Topics:

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

82313 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14438 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides