Question about 2003 Kia Sedona

1 Answer

Remove Having trouble removing my driver side axel on my 2003 kia sedona With abs. The axle came out but the part that goes into the transmission came off the boot and wont come out

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 180 Answers

You will have to get a pry bar in between the Trans and half shaft/ axle and use pushing force to remove. I've used leg power on certain cars to remove axle

Posted on Mar 31, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 83 Answers

SOURCE: my kia sedona wont start just click when turned on

Couple of things to try.

1. Check that the battery connections are both clean and tight on the battery.
2. Check water level in the battery is above the plates that you can see in the filler holes.
Caution:
(Handle the battery with care as the water in the battery has been charged and becone sulphuric acid which will burn your skin. Do not get this in your eyes.)

3. Turn the headlights on then start the vehicle, and if:
a) the lights dim the battery is not connecting properly or faulty, or:
b) the lights stay on full it would the starter motor relay or solenoid (part of the starter motor).

Posted on Sep 23, 2008

ghost4548
  • 776 Answers

SOURCE: how do i remove the drivers side cv axle on a kia.

The answer is NO... you do not pry it 'OPEN." I'm assuming you've already removed the cotter key and the 1 1/4" nut from the axel hub? The DOJ (Dual Offset Joint) that is inserted into the differential side of the trans has a retaining ring which "COMPRESSES" when you pry the DOJ out using a large pry bar or extra large screwdriver. The same 'COMPRESSION' happens to the ring when you install the new axel.... once fully inserted, the ring 'EXPANDS' inside the differential splines creating enough tension to keep the DOJ in place.

Posted on Jun 20, 2009

  • 1986 Answers

SOURCE: kia sedona outside door handle replacement

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on

Posted on Sep 15, 2009

  • 4793 Answers

SOURCE: We cannot remove 2nd seat in our 02 Kia Sedona. We

move seat completely back.take off head restraint,tip backrest forward flat to seat, then, grab the pull cord and pull backward so that seat tips forward then grab bars on front of underseat and squeeze together and lift.be careful these seats ARE HEAVY.

Posted on Feb 22, 2010

drsinister69
  • 2317 Answers

SOURCE: kia sedona automatic transmission gearbox

To fill the transmission fluid, you need a funnel that fits into the dipstick tube, add fluid there. If the fluid is black and smells burnt, that's bad. I would have the fluid changed. These transmissions don't have a filter, probally a bad idea.

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove wing mirror cover drivers side from a 2005 Kia Picanto LX


kia-rio-side-mirror removal-04 - atomia.ir - YouTube

? 0:25
www.youtube.com/watch?v=GWIcTycQFYI
Feb 16, 2013 - Uploaded by Arash Soltani
rio-side-mirror removal-04 - atomia.ir. ... Drivers Side MirrorReplacement ' Kia Sedona ' Other Makes ...

Kia Picanto Forum [Archive] - Kia Forum - Kia-Forums.com

www.kia-forums.com > Kia Forum > KIA Models
[Archive] Life is more colourful with Picanto. ... Picanto 2007 auto transmission abrupt start problem · Driver side door lock problem (2005 picanto) · Picanto 1.0 lx ...

Oct 14, 2015 | Kia Cars & Trucks

1 Answer

How do i change cvc axle on 2003 kia sedona driver slde van


Jack up vehicle and secure it on a jack stand. Remove the tire,brake caliper,pads and rotor. Remove the large spindle nut on the end of the axle and push the axle through the bearing. Then remove the bolts from the strut where it attaches to the steering knuckle. Pull the axle out of the bearing and the using a pry bar, pop the axle out of the transmission. Install in reverse order of procedure.

Feb 23, 2015 | 2003 Kia Sedona

1 Answer

How to remove front left drive axel 2004 cadalic deville


front left is the drivers side. remove the wheel, remove the axle nut, disconnect and separate the ball joint, remove the axle from the spindle then pull the axle out of the transmission, you will loose some transmission fluid.

Feb 01, 2015 | 2004 Cadillac Deville

1 Answer

Remove axle


if you need to remove the axle from the spindle side then you need to take the axle nut off which you have to remove the rim n tire and it will be dead center approx 1in size nut or bigger not sure exact size

second have to remove the nut on the lower ball joint n seperate the lower control arm and strut. will need a ball joint fork which you can get at any parts store and a pry bar to push down on control arm once ball joint is broken loose to seperate the strut. this will allow you to push the axle back troungh the spindle to remove it.

last but not least where the axel goes in to the transmission you will need a small pry bar to pop it out from transmission. jus put it between axle n transmission and apply pressure till it comes out. the axel has a oring style clip which holds it in place so not able to pull it out by hand. caution when you pull the axel it will leak out some fluid so make sure you have a drain pan .

to install jus follow the process backward jus make sure the axel pops back in place securely other wise when you go to drive it you risk it poping out. good luck n hope this helps you

Jul 12, 2012 | 2000 Hyundai Elantra

2 Answers

Kia spectra transmission removel?


Sometimes the axles on these do hang up. The best way to remove these is to take 2 pry bars to place on either side and very sharply, pull quickly and the axle should break free. You should feel it pop. Do not pull on the other end of the axle. It can disconnect the joint from the inside and the you have to remove the clamp and reset the joint.

Apr 18, 2010 | 2001 Kia Spectra

1 Answer

I want to remove front axel driver side please


Basically, you loosen the axle-nut (could be pretty tough, so spray some lubricant on it) and the wheel nuts. Jack up the car and support it on jack-stands.
Reomve the brake calipers and tie it up to frame. Remove the two bolts holding the struts bracket and steering-knuckle. Push down/sideways to separate both strut-bracket and steering-knuckle. Use large screw-driver or pry bar to pry off axle from side of transmission. Block-off transmission fuild with a nylon rag or similar; take out axle-shaft. Installation is reverse of removal.

Nov 09, 2009 | 1997 Ford Escort

1 Answer

How do i check my manual transmission fluid in a 2003 kia rio


there will be a fill plug on the trans near the axle on the drivers side. remove the plug and put your finger in the hole, if you get oil on your finger, youre good.

Nov 03, 2009 | 2003 Kia Rio

1 Answer

Can't get the bearing hub out to replace the bearing


You'll need to remove the 2 strut bolts holding the hub to the strut, remove the axle nut. Pull the hub towards you and try taping on the axleshaft to try to push it out. You might try spraying some WD-40 where the axleshaft goes thru the hub.

May 24, 2009 | 2006 Kia Sorento

1 Answer

I need to remove the outend of the drive axle and am having troubles getting the axle out of the hub. Every other place has indicated that it just slides nicely out with little or no force. However on this...


Put the axle nut back on backwards (flat side out, so flat is even with the axle end...give it a sharp blow with a decent sized hammer and it will break loose.

Apr 01, 2009 | 2001 Kia Rio

Not finding what you are looking for?
2003 Kia Sedona Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...