Question about 1988 GMC K2500

Open Question

Fuel problem on 1988 gmc 2500

Getting too much gas

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fixincars
  • 335 Answers

SOURCE: fuel line problem 2500 gmc suburban 1999

You likely are over filling the tank and the evap system cannot vent

Posted on Sep 06, 2008

Ad
psds4
  • 293 Answers

SOURCE: 2001 gmc serria 2500 hd 4x4 fuel system

check your power nad ground at fuel pump plug if power and ground are ok you have a defective pump

Posted on Oct 13, 2008

  • 5 Answers

SOURCE: Engine not getting fuel

your fuel pump needs to be replaced. i had the same problem but i had a full tank of gas in it. so the easiest thing for me to do was to pull back the carpet and cut a hole. instead of dealing with the weight of the 36 gallons. they tend to go every 100,000-150,000

Posted on Jun 22, 2009

  • 3 Answers

SOURCE: how to remove fuel pump on 1988 gmc s 15 pickup

to remove the fuel pump you need to unbolt the tank and the lines to drop down the gas tank. then turn the ring on the top of the tank and unplug the wires and remove the fuel pump

Posted on Jul 20, 2010

  • 447 Answers

SOURCE: 1999 gmc sierra 2500 6 liter ran out of gas now won't start

If you are at or near the 100,000 mile mark then your fuel pump may have failed. If you remove the fuel filler cap and listen carefully at the filler neck while someone turns the ignition key to "run" [don't actually crank the engine] you should be able to hear the fuel pump buzz for about a second and a half as the key is turned On. If you don't hear the pump buzz then odds are your pump is dead. Your pump may have actually failed making it appear as though you ran out of fuel. Not to uncommon. Hope this helps and good luck!

Posted on Nov 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is latest model throttle body can be installed on 1988 gmc sierra 2500?


You will need to ask the dealer parts dept this question, we have no way to reference this here at fixya.

May 25, 2012 | 1988 GMC K2500

1 Answer

Where is the fuel filter on a 1988 gmc suburban 2500 with a 454


Hi it's under the vehicle on the left side(driver side) below seating area,near fuel tank,mounted on frame rail in fuel line..... hope this helps,don't forget te rate this if it helps you... Thank You for using FixYa..... iluv2fish.....Ray

Jun 24, 2010 | 1988 Chevrolet Suburban

1 Answer

1988 chevy truck 2500 5.7 engine. After engine starts it runs like it is running lean until the engine warms up. On cold start you can spray ether in the throttle body and the engine clears up while...


EATHER IS NOT GOOD , ITS FOR COLD COLD MOTORS.. CHECK YOUR FUEL PRESSURE AND GAS FILTER .YOU MIGHT HAVE A BAD FUEL PUMP ITS IN THE GAS TANK!!! . USE CARB & CHOKE CLEANER ..PARTS MASTER # 1736 ..ITS NOT AS HOT AND WONT POP A HEAD GASKET .IF'N I WAS ANY HELP AT ALL PLEASE VOTE.. JAY

May 25, 2010 | 1988 Chevrolet Silverado 2500

1 Answer

II have a 1989 F250 with a 460 gas motor, it starts but after 1


Fuel pressure regulator/fuel pump most likely.

Apr 18, 2010 | 1988 Ford F 250

1 Answer

My 88 chevy 2500 3/4 ton runs, but when given gas


check your fuel filter under the left side of the vehicle on the frame. if this proves to good, your next step might be checking your catalytic convertor. have you checked all of your vacuum lines? one thing you can do is have your friend inside to start the vehicle and while it is idling and the air cleaner is off, look inside at the fuel injector and you throttle it and see if the injector is spraying fuel.

Nov 09, 2009 | 1988 Chevrolet C2500

1 Answer

My 1988 chevy 2500 has been so reliable until it stated to stall.


Could be. But more then likely it's the gas. The gas you get these days from the pumps will gunk up after around 30-40 days. I'ld change the fuel filter see if that works. If not you might have to take the tank out to clean off the pickup sock. It's a small filter type on the end of the fuel pump. Of course, you should do a pressure test to see first.

Oct 10, 2009 | 1988 Chevrolet Silverado 2500

1 Answer

2000 GMC 2500 Fuel Pump?


check for power too the pump first with a test light if you have power too it then the pump is bad if not youve got a short some gms also have a fuse check for that also

Feb 23, 2009 | 1985 Chevrolet Chevy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...