Question about Cars & Trucks

1 Answer

Ford taurus SE 2007 model wont start after bumped to barrier

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 44 Answers

Open the trunk of your car. And on the left side close to the hinge that holds your trunk lid open there will be a small round opening. Look inside the opening and you will find a red button. Push in to reset. This is called the inertia switch. Which was designed to cut off your gas source to your vehicle in a collision. If you do not find it there refer to your owners manual. Once it starts , if it cuts out again easily replace the switch. It can be a headache if you just keep resetting it...

Posted on Mar 31, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 18 Answers

SOURCE: 1999 ford taurus

check the fuel pump itself.. if no fuel going through lines... injectors won't work.

Posted on Oct 26, 2008

  • 3 Answers

SOURCE: 2001 ford taurus wont start and anti-theft light is blinking

Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start

Posted on Feb 05, 2009

SUPERMAN_B_1
  • 294 Answers

SOURCE: where is the power control module located on a 2002 Ford Taurus

hello, its under your drivers side dash , under the steering wheel.

Posted on Mar 30, 2009

  • 93 Answers

SOURCE: diagram of a serpintine belt on a 2007 ford taurus se car

Accessory Drive Belt adobe.gif Printable View (140 KB) Removal and Installation

  1. Using a suitable belt tensioner release tool, rotate the drive belt tensioner clockwise and remove the accessory drive belt.
  1. NOTE: Refer to the illustration for correct accessory drive belt routing.
    To install, reverse the removal procedure.
    n0020203.gif

Posted on Jun 02, 2009

roniecon
  • 6927 Answers

SOURCE: Power window on Ford Taurus SE will not work and

Check the fuses and the power seat module under the dash.

Posted on Apr 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can cause my ford taurus start then immediately shut off it will start but shuts right down


Often caused by security system, but sometimes a bad fuse or relay. Need the year to help more, please.

Jul 28, 2017 | Ford Cars & Trucks

1 Answer

I am looking for 2007 Ford Taurus SHO or SES


Ford didn't make the Taurus sho in 2007. The sho were made between 1989-1999 and then 2010-present. In 2007 the Taurus was only offered in SE and SEL trim.

Nov 28, 2015 | Ford Cars & Trucks

1 Answer

What is the problem of ford taurus that bump in the barrier and wont start


Many cars have a fuel cutoff switch that is tripped on impact. On my Taurus the reset button is accessible through a small hole on the left side inside the trunk. It is described in the owners manual.

Mar 30, 2014 | Cars & Trucks

1 Answer

2005 Ford taurus SE won't run. It will turn over.I have replaced the fuel relay. The battery, lights, horn, etc. are working. Any other suggestions?


Fuel filters plug up. Check it. If the car has had a hard bump it's possible the fuel shut off valve has closed off the fuel supply.

Feb 21, 2014 | 2005 Ford Taurus SE

1 Answer

2007 ford fusion wont start solutions


The Inertia switch. Located either behind a front kick panel or in the trunk, this part has a reset button on it. If the right frequency is felt by door slamming or trunk closing, a Parking lot bump, etc. this part will disconnect the power to the fuel pump.

Jan 31, 2014 | 2006 Ford Taurus

1 Answer

2007 ford taurus w/ locked steering wheel and car won't start


try pulling the steering wheel slightly to one side and turning the key to unlock the steering wheel

Jul 28, 2013 | Cars & Trucks

1 Answer

I hit a bump in my 1993 ford taurus and it died and now it wont start what could it b


Inspect the sump and see if it hasn't been bashed up against the crank shaft. Check engine mounts for cracks. Check lines are not squashed or kinked.

Feb 10, 2013 | 1993 Ford Taurus

1 Answer

2007 Ford Taurus Theft Light on when attempting to start, won't start with original key. Can it be reset to start?


You will need to have the Ford dealer or a well equipped locksmith program the keys again. As this takes a special electronic scanner to access the module to recode it you can't do it at home.

Dec 12, 2011 | Ford Taurus Cars & Trucks

2 Answers

1999 ford taurus


check the fuel pump itself.. if no fuel going through lines... injectors won't work.

Aug 16, 2008 | 1999 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...