Question about 1995 Honda Passport

2 Answers

Turn signal on right doesnt work but hazzards do

Left turn works so do hazards and bulbs are new and so is relay

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Whenever turn signals are doing things that make no sense the culprit is usually the column combo switch. It's about a $170 part and requires pulling the steering wheel to replace, however if you're skilled you can disassemble it and clean the contacts, that's all that's usually wrong with it. (I serviced mine without removing it from the truck)
If you do disassemble it be prepared for spring loaded ball bearings to want to escape as soon as you crack it open- lose them and you're screwed.
I have heard others have had success spraying contact cleaner into it. Be careful if you do, you'll want to disconnect the battery and most contact cleaners are not very friendly with most of the plastics in the vehicle- including the combo switch.

Posted on Apr 01, 2014

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had that same problem what worked for me first turn on hazard lights then turn on right or left turn signal while hazard lights are flashing now turn off hazards while turn signal is on this should reset itself may have to repeat these steps but it worked for me Good L

Posted on Mar 30, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 2000 Accord turn signal problem

either the front or the rear turn signal bulb is blown, that is why the flash frequency is high. replace the bulb and the problem will be solved. best to replace both the front and rear turn signal bulbs. good luck.

Posted on Sep 01, 2008

HondaAl
  • 72 Answers

SOURCE: turn signals and hazards dont turn on

The turn signals run through the hazard switch, I have replaced hazard switches for this problem.

Posted on Apr 23, 2009

  • 163 Answers

SOURCE: Turn signal problem

Check your turn signal flashers there are 2 one for turn and one for hazard lights.

Posted on Aug 27, 2009

MNfisherman
  • 11896 Answers

SOURCE: Turn signals don't work in 2004 honda civic lx.

The turn signal switch and 4 way flashers have the relays built inside. If fuses and flasher is good, then switch is bad.

Posted on Nov 18, 2009

wireguy212
  • 1627 Answers

SOURCE: turn signal relay buzz

Relays buzz when they are not getting enough power either due to a power wire with a high resistance in it or a ground with the same problem,check the harness manually to see if you can find a loose or corroded conecter or ground point.

Posted on Nov 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My right front turn signal on my 2001 ford ranger doesnt work and my inside right turn signal light on dash doesnt work and flashes really fast. Buld on right side was replaced and works when lights


was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

Dec 06, 2014 | 2001 Ford Ranger Regular Cab

1 Answer

04 Hyundai, Hazards Work But No Turn signals


Always check the bulbs first. Then check for power ant the bulb socket. If the fuses are ok( some have seperate fuses for right and left).......More than likely its a relay wich should be located on or near the fuse panel.The turn signal and hazards usualy have the same type of relay. Swap the turn signal and hazard relays. If the problem is then oposite of what you had before, then replace the relay....

Mar 29, 2013 | Cars & Trucks

1 Answer

Where can you locate the turn signal flasher unit on a 1992 plymouth acclaim


There are two flasher relays under the dash in the car. One for the hazards and one for the turn signals. They are next to the fuses under the steering wheel right by the hood release

Nov 05, 2012 | Cars & Trucks

1 Answer

My turn signals stopped working suddenly on my 1992 ford probe lx. Prior right side was blinking faster. Changed signal switch next to steering column changed turn sinal/hazzard flasher by the clutch...


If this is not working on the right side and is OK on the left side then one of the indicator lamps on the right side has blown out. The reduced load on the right hand indicators causes the flasher can to flash faster.
Try turning on the hazard switch then walk around your car to see which lamp has blown out.

Feb 24, 2012 | 1992 Ford Probe

1 Answer

My right side turn signal cuircut works but my left side doesnt ive checked the light bulbs but they're all good.


if hazard lights are ok and you can see all are working, you can tell that your signal lever switch is broken.

Nov 18, 2011 | Cars & Trucks

2 Answers

My hazards work. My blinkers do not work at all. No sound or light.


there is a separeate flasher relay for turn signals,usullay by hazzard flashers.turn on hazzards use sound to locate,turn flasher will be near.some will interchange to get you by till you can replace.

Feb 17, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Right turn signal does not work, bulb don't light, but the four way flashers do...... Thanks


Howdy, No Big Deal, Follow this, Common Power To Left and Right Signal , orange wire to flasher relay for left black wire for right, there are two relays inside flasher module 1 the left and right signal share the other is for the hazards. The is a common ground for the signal lights and hazard so if one side works good ground if the hazard works good ground...maybe power wire from 320 dollar turn signal unit maybe 160 on ebay....hope this helps keep smiling.....Doug in Clermont, Florida

Nov 20, 2010 | 1998 Buick Park Avenue

2 Answers

Right turn signal not working


if left is working then check bulbs in right side ,if bulbs ok then renew the hazard switch ,if it still doesnt work then renew the stalk control ,have wiggle of stalk to see if seems to click into place ,also check for feed coming out of stalk when right turn is selected .Then if it still doesnt work look for either the allusive magic multipurpose relay ,but if you cant find that then look for all in one does it all magical relay that covers it hiding place with fairy dust .

Jan 03, 2010 | 1990 Mazda Protege

2 Answers

Turn Signals Malfunctioning


If your hazard lights work you need a turn signal switch, If hazards do not work replace the Flasher module

Jun 10, 2009 | 2004 Honda CR-V

Not finding what you are looking for?
1995 Honda Passport Logo

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...