Question about 1999 Chevrolet Silverado 1500

1 Answer

1999 Cheverolet silverado reverse slowly went out

Reverse slowly went out checked fluid was clean and no metal particles or trash found

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 443 Answers

Rebuild time, when they go it usually has a broken reverse band ..

Posted on Jun 26, 2014


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 396 Answers

SOURCE: 1999 chevy silverado service 4 wheel drive light

I had a similar problem with the Service 4 Wheel Drive light which came on intermittently then became more consistent in the message center display. It would go into 4 wheel drive if the message center did not display the Service 4 Wheel Drive message in the message center, but not when the message was displayed. I found the transfer case switch module in the dash was defective, and it has been working with no other problems for three years.

Posted on Jul 22, 2010

  • 134 Answers

SOURCE: 1999 Silverado with 139000 miles,

I believe you are on the right track.. Since you do not have a meter.. take a trip to your local auto parts store such as Autozone, Oreilly etc.. They will test you battery free of charge!!.. Best of Luck.

Posted on Aug 19, 2011

  • 22 Answers

SOURCE: 1999 cheverolet silverado check engine light

You will have to have the code [s] read from your ecm, A scaner is requird to access the code[s]

Posted on Dec 09, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

5.3. Where is the 3-2 shift sensor located?

There isn't one. It is a piston in the valve body. It is spring loaded. PCM monitors it threw the Pressure control sensor on the bottom of the valve body. Pull the pan and drain the fluid in a clean container. Check the magnet and fluid for metal flakes. Metal flakes in the fluid, you have other problems. If there isn't metal, check wires first then replace the sensor. The sensor is about 4 inches long and 2 inches wide. 5 bolts hold it on. 2 short ones, 3 long ones. one electrical plug.

Aug 22, 2015 | 1999 Chevrolet Silverado 1500

1 Answer

Where is the throttle pedal sensor located on a 2002 cheverolet silverado

There is a throttle valve positioner sensor located at the end of the throttle valve shaft on the right hand end of the shaft, the sensor then bolts to the throttle body as you face the engine from the front. A defective sensor will set the check engine light and give hesitation during acceleration.

Jun 29, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

My 1999 silverado will not drive or go in reverse

If you truck will not go forward or backwards you might want to check the transmission fluid. If there is none in there add some and if there already is enough fluid on the dip stick then you more then likely have a bad transmission.

Mar 09, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

My car won't go in reverse

check fluid levels first..look for any gunk in the fluid like black or metal shavings..if found replace filter and fluid..then retry.. if still no gear, time for a rebuild.....

Jan 27, 2013 | 1999 Ford Escort

1 Answer

1999 cheverolet silverado check engine light

You will have to have the code [s] read from your ecm, A scaner is requird to access the code[s]

Dec 08, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

Car wont move when in gear

Check the transmission fluid first to make sure there is enough in the transmission and it is not leaking out. Look at the fluid on the dipstick and smell it. If the fluid is not red in color or smells burned the low/reverse clutch pack in the transmission could be worn out. Wipe the fluid off of the dipstick onto a clean white rag, if you see a grey looking stain on the rag there may be metal particles in the fluid possibly indicating a failed planetary/sun gear set in the transmission. . .good luck.

Feb 26, 2010 | 1998 Oldsmobile 88

1 Answer

O/D light started blinking?

you need to change your tranny fluid and check for debrise' in the pan.. metal shavings and disk particles sounds like your reverse high clutch pack and maybe your toruque convertor clutch solenoid or screen has trash or the tranny is just wearing out

Jan 14, 2010 | 1997 Ford Explorer AWD

1 Answer

Ford Taurus won't go into gear but will go in reverse

I would check the fluid level because low fluid can cause this problem. If the fluid is full, when was the last time the ATF was changed? If the fluid has not been changed regularly then you may have some sludge or particles fouling a valve in your valve body.

May 19, 2009 | 2000 Ford Taurus

1 Answer

1991 chevy silverado lost reverse

just have someone look at it. like aamco or someone that does a free diagnostic. the tranny will probably have to be rebuilt.

Jan 02, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides