Question about 2003 Chrysler Voyager

1 Answer

Need to know where the egr valve is on a 2003 Chrysler Voyager. 2.4 engine

Would like to know why I can't find the EGR on the said vehicle. Or, what is used in its place ?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

On some 03 they did not have one,if it does it should be behind altnator ,also look at scamatic underhood it should tell you if it is egr complaint

Posted on Mar 31, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

captaynkyrk
  • 170 Answers

SOURCE: EGR valve

Get a repair manual for about $25 at Auto Zone for your make and model. It will show you where it is and step by step instructions with pictures to repair or replace just about anything on your auto.

Posted on Jul 06, 2008

  • 412 Answers

SOURCE: 2005 Chrysler T&C EGR valve solenoid problem

YOU NEED TO DISCONNECT THE BATTERY FOR 5-10 MINUTES FOR FAULTS TO CLEAR COMPLETELY..HAVE SEEN THIS PROBLEM BEFORE AFTER REPLACING AN EGR VALVE..IT WAS A TECH TIP FROM CHRYSLER ENGINEERING..THE EGR VALVE WAS THE PROBLEM,BUT THE PCM WOULD NOT LET THE CODES GO EVEN AFTER CLEARING THEM WITH SCAN TOOL..ALSO CHECK CONNECTIONS AT EGR CONNECTOR FOR SPREAD PINS

Posted on Jul 26, 2009

  • 172 Answers

SOURCE: EGR valve

You dont, carb cleaner only removes gunk, where an EGR valve is full of hardened carbon.

Posted on Aug 12, 2009

  • 280 Answers

SOURCE: I have a 2002 Chrysler 300m diagnosed with a

The valve passage maybe clogged. You can take the valve off and clean it out (kerosene and a brush/rag and that MAY help. You should be able to get the EGR at Auto Zone or NAPA-but it will most likely be costly.

Posted on Mar 11, 2010

MNfisherman
  • 11896 Answers

SOURCE: How do you replace the egr valve on a 300

Heat up the exhaust pipe to egr with torch and spray with knockitloose or wd40 when not hot. Then remove that pipe. Then remove vacuum hose and the 2 bolts that hold it on.

Posted on Mar 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hi can you help me please, ive got a 2003 2.5 crd chrysler voyager, i can drive the car but then there is no acceleration pedal,


cleaning egr may not have fixed problem --test it for correct function also if previous owner had altered the vehicle that could have failed need to test and or correct the altered component
EGR Backpressure Sensor Help
How To Test An Egr Valve Yahoo Video Search Results i would also check cat converter ,and fuel filter

Oct 19, 2016 | Chrysler Cars & Trucks

1 Answer

Where is the egr valve and fuel filter located?


Egr valve is located on the passenger side of the engine bay on top near the back. Fuel filter is on the same side behind the front tire, or between the tank, and the rear suspension.

Sep 12, 2013 | 2001 Chrysler Voyager

1 Answer

I brought it to advance auto for them to check it.Diagnostic said Malfuctioning egr valve.Can this cause the vehicle to idle alittle ruff & Hesitate on acceleration?Any advice would help alot ty.


Absolutely. The EGR controls the air to gas ratio in the sense that recycling unspent gas vapor is a large part of the engine's combustion. If it is faulty, expect hesitation or shuddering. Also, the EGR valve is cheap and easy to install on most vehicles.

Nov 10, 2012 | 2001 Chrysler Voyager

1 Answer

How do i chang the egr valve?


The easiest way to change it is from underneath the vehicle. Safely jack up and secure the passenger side of the vehicle. You will see the egr on the back side of the passenger side of the engine . There will be a couple bolts for the egr pipe and a couple for the egr. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 05, 2012 | 2005 Chrysler 300

1 Answer

The computer on the truck says to have maintenance performed. Checking the owners manual, it says the EGR valve needs to be replaced. Where is the EGR valve, what does it do and where do I get the part?...


Are you sure that the Owners Manual is telling you to replace your EGR Valve or is it simply telling you to check it? Does the light on the dash say "Maintenance Required"? or is your Check Engine light on? If your vehicle is equipped with "Maintenance Required" light, the vehicle usually does not need anything. You simply check the systems that are listed by the manufacturer to check, make repairs only as necessary, and reset the light. Chrysler did some goofy stuff with Maintenance Required lights back in the 80's where they recommended replacemet of a whole bunch of parts that the vehicle didn't need to have replaced. We used to just reset the light and send the vehicle back to the customer. I haven't seen one of those for a while. If your 2007 has one of these, it means Chrysler is up to some old stuff for 2007.
On the other hand, if it is the "Check Engine" light that is on, the computer needs to be scanned for fault codes and diagnosed and repaired accordingly. Also EGR valve failures are pretty rare. When the Engine Computer sets a fault code for the EGR system it usually is not caused by the EGR Valve itself. Your 2007 is OBDII compatible, which means if you are having a problem with your EGR System the Check Engine light will be on and fault codes will be stored in the Engine Computer.

Jan 22, 2011 | 2007 Dodge Ram 3500 Quad Cab Laramie

3 Answers

Need to find out where my egr valve is located on my 2003 impala


see pics below. Please let me know if you have more questions.

3.4Liter engine:

4754371.gif

3.8 Liter engine (#1 below):

460df7a.gif
part look like this:

5a8d5ae.jpg

Oct 30, 2010 | 2003 Chevrolet Impala

3 Answers

Location of EGR valve for 4.6 liter engine? how do you remove the EGR valve?


a887903.gif
EGR VALVE IS #2.

Please wait for second post to answer your second question....comes with a few pictures.

Nov 16, 2009 | 1992 Ford Crown Victoria

1 Answer

EGR valve


Get a repair manual for about $25 at Auto Zone for your make and model. It will show you where it is and step by step instructions with pictures to repair or replace just about anything on your auto.

Jul 06, 2008 | 2000 Chrysler Grand Voyager

Not finding what you are looking for?
2003 Chrysler Voyager Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...