Question about 1999 Honda Odyssey

1 Answer

Turns off when put in reverse or drive

Turns off when put on drive or reverse 2 min after works fine

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    Uploaded 5 video answers.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 69 Answers

First and most economical repair to help or fix this problem- clean the throttle body. Auto parts stores sell an aerosol intake cleaner that'll help, and perhaps fix this problem.

Posted on Dec 21, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My back up camera on my 2013 Malibu lt vehicle was working fine and now when I reverse it's turns yellow and line a goes across

Contact dealer for recall issue. This looks like a program issue. Try un hooking the battery for 5 mins. and see if it will go thru reset mode.

Mar 13, 2015 | 2013 Chevrolet Malibu

1 Answer

My 1993 Toyota 4 runner 2wd wont work but my 4wd does .. in 2wd the drive or reverse wont go but will in 4wd

Hi do check gear linkages or cable adjustments.otherwise possible gearbox malfunction.

Jan 05, 2015 | 1993 Toyota 4Runner

2 Answers

2003 altima dash fuse blows when i put in reverse and alternator stops working

It is electrical, could be initiated by mechanical (shift lever mechanics are pinching a wire in reverse) or a shorted wire or solenoid in the reverse light system or transmission solenoid circuit. Need a detailed wiring diagram to determine path of circuit for that fuse. That is where you need to start. Try your local library or dealer for a service manual. Look Online also.

Nov 02, 2013 | Cars & Trucks

1 Answer

My pontiac firebird turns on fine but after a 5-10 min drive it idles low then turns off then i turn it back on and it idles fine for like 5 seconds then turns off again i even press on the gas but it...

Sounds like a venting problem with the gas tank. There is a vent for the tank that could be blocked and not allowing pressure to equalize.
Like sucking milk from a bottle without allowing it to vent.
The vent could involve the canister purge system.

Jan 08, 2013 | 1991 Pontiac Firebird

2 Answers

1991 buick regal 3.8 turns on just fine bt when i go to put it in drive it doesnt turn over? it works in reverse and sometimes i hae to put it in drive2 to switch it over to drive forward bt it doesnt work...

if you are having a proublam with the transmission shifting when you put it in drive
the modgulator valve is what makes the transmission shift it is located at the rear
of the trans its round with a vacume line hooked to it the only thing that holdesit in
is 1 -- 1/2 bolt if this is not the proublam please let me no bob...

Oct 14, 2011 | 1991 Buick Regal

1 Answer

When putting my '04 Mountaineer in reverse or drive, with the steering wheel turned, the car fights very hard to move. Driving straight if fine. Any ideas?

Hello, Yes, It sounds like it is in 4 Wheel drive mode. Your vehicle will not make as sharp of a turn when in 4x4. You should be in 2 wheel drive on dry pavement. If you have the other system called All Wheel Drive, yours would be binding when it should not.

Check your Range Selector for the different settings. When in 4x4, the vehicle is made to take gradual turns so you don't flip it on a hill. Sometimes people mistake the Range knob for the Fan Blower switch.

Jul 03, 2011 | 2004 Mercury Mountaineer

1 Answer

Engine turns off when put into reverse,its

Check timing. Belt may have jumped a cog.

Sep 09, 2009 | 1996 Volkswagen Golf

3 Answers

My truck turns on but does not move forward

Make sure your transmission fluid is up to level, if it is, put a little bit on your fingers from the dipstick, does it smell burnt? if your unsure rub it between your fingers if it looks more black than red and feels gritty its burnt, try changing fluid and filter if that doesnt help your forward clutches are out, ive had some luck with trans-X in situations like this but its rare that it helps and almost never lasts hope i could help

Mar 14, 2009 | 1988 Chevrolet Silverado 2500

Not finding what you are looking for?
1999 Honda Odyssey Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides