Question about 2008 Skoda Octavia 1.9

Open Question

Crank sensor location 2001 navistar dt466.

Remove and replace instructions crank sensor dt466

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 hyurdai xg300 how to replace crankshaft sensor


crank sensor is located on the front of the engine behind the
timing belt covers and is mounted to the front of the engine block. the alternator has to be moved to feed the harness down the front side of the block to replace the crank sensor it has a tone wheel that may have to be moved the remove and replace sensor

Mar 26, 2017 | 2001 Hyundai XG300

1 Answer

How do i replace a crank shaft sensor on a 2001 buick lesabre


The crankshaft sensor is located behind the harmonic balancer. There is a special tool you can rent/loan from your local auto parts store in order to remove the harmonic balancer. Once it is off 2 bolt hold the crankshaft position sensor in place. Note there could be many other factors causing your engine to stall or not restart; but those crank sensors do tend to go out on those engines.

Sep 21, 2014 | 2001 Buick LeSabre

1 Answer

My engine stalls?


The crank sensor is located behind the crank pulley on the 3.8 liter. The crank pulley must first be removed. A 15/16" socket, three very long 8 x 1.0 bolts (pretty sure that is the size, some large washers, and a crank pulley pulley will be required.

With the crank pulley removed mark the bracket where the old crank sensor is located so that the new sensor can be placed in exactly the same position. Failure to do this will result in the new sensor and/or the crank pulley being severely damaged.

Then it's as simple as removing the old sensors and installing the new one.

Good luck and let me know if you have any questions.

Sep 21, 2014 | 2001 Buick LeSabre

1 Answer

How do i replace crank sensor on 2000 olds alero 3.4 and where is it located


It depends on which crank sensor you are wanting to replace. There are two of them. The 24X sensor is located behind the front crankshaft pully and the crank pully must be removed to change it. The 7X sensor is located in the engine block on the right bank (firewall side) near the rear of the engine. This one simply pulls out of the block after disconnecting the electrical connector and removing the single bolt that holds it.

Dec 13, 2011 | 2001 Oldsmobile Alero

2 Answers

Where is the crank shft sensor located on a engine 3.5 2001 oldsmobile intrigue


the crank sensor is located just above and behind the starter motor. accesable after removing the starter.

Jul 10, 2010 | 2001 Oldsmobile Intrigue

2 Answers

Where is the crank sensor located on a chevy malibu 2001


It should be down near the crankshaft pulley. Remove the the right front wheel and the splash shield, it should be there next to the pulley.

Dec 20, 2009 | 2001 Chevrolet Malibu

1 Answer

Looking for the location of the crank position sensor and the knock sensor for a 2001 chevrolet silverado with a 4.8 8cylinder engine


Crank sensor; right (pass.) side of block above the starter. You may have to remove the starter to remove the crank sensor.

Knock sensor: There may be 2, a front and a rear. Both would be UNDER the intake manifold on top of the engine block one behind the other about 8 inches or so apart. The manifold and associated item may or may not need to be removed to access the sensors.

Aug 10, 2009 | 2001 Chevrolet Silverado

1 Answer

How do i replace crank sensor on 2001 olds alero 2.4 and where is it located


the crank sensor is located beneath the intake between the starter and oil filter it has one small bolt in it remove the bolt and pull the sensor out and just stick the new one in put the bolt back in it and plug it up but make sure you disconnect the battery before you do anything that bolt is probably a 10mm or a 5/16 i hope this helps

Jul 11, 2009 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2008 Skoda Octavia 1.9 Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Skoda Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Brad Brown

Level 3 Expert

15441 Answers

Frank Magliocca

Level 3 Expert

1038 Answers

Are you a Skoda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...