Question about 1983 Alfa Romeo Spider

1 Answer

Cranking problem sometimes the engine turns over to start, sometimes it just clicks.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Could b your starter

Posted on Mar 30, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sometimes starts,sometimes does not


Have the vehicle checked for DTC'S - diagnostic trouble codes !

Feb 22, 2016 | 2000 Saturn Ls 4dr Sedan

1 Answer

Cpk sensor ( crank position sensor)


could be cam or crank but more like crank sensor with no start. cam sensor fail engine can start and run in limp mode but crank it will not. but you should still have engine management light on. also there will be codes stored on ecu you can read to find a fault.

Feb 04, 2014 | 2001 Honda Civic

1 Answer

My 2003 Rodeo is having problems starting. Sometimes it turns on with the first try, other times on the second. But lately I have to try it 6-20 times before it starts. It varies. The noise it makes if...


need to load test battery, this vehicle will not start or power up engine ECU if battery voltage is dropping to 10 volts or below while cranking. so if starter is clicking some times due to low voltage engine will not fire up(start) but cranks over seemingly fine. also when not starting does check engine light flash at all?
check all earths after checking battery with load tester if battery is ok then there was problems with immobiliser modules causing this fault and there is a revised module for this as well as checking wiring for key reader to immobiliser, also are there any aftermarket electronics fitted to vehicle? which could be causing problem due to location and wiring into vehicle.

Aug 26, 2011 | 2003 Isuzu Rodeo

2 Answers

Engine do not start (no cranking), only the sound of clicking (relay??). All indicators are normal (lights up), battery good (tested by turning on headlights, blowing horn). Happens after turning off a hot...


Hi:) That sound like the solenoid is the problem it is located on the starter and if the solenoid is not working right it will do all the things you are explaining.And yes heat has alot to do with it and being ware out.If it is the original it is time to replace the starter anyways it's 16 years old.

Mar 08, 2011 | 1995 Toyota Corolla

2 Answers

Liberty will not turn over


Doesn't that jeep have an on board anti theft system that shuts of power to the startee and the fuel injectors. Im pretty sure it does thats where to start sometimes just turn the key to the on position for 30 sec. To 60 sec then crank the engine if that doesnt work turn off at least 10 sec try again tirn to on position without cranking motor for at least 30 sec then try cranking

Sep 20, 2017 | 2003 Jeep Liberty

2 Answers

Car will not crank sometimes unless you turn the key many times.


Check battery connections. Sometimes a weak connection will fail under very high loads like starting.

Feb 03, 2009 | 2001 Ford Escort ZX2

1 Answer

Engine will not crank intermitantly


Crank sensor can translate heat. Not allowing restart after the turbo heat radiates in the area. Try a wad of aluminum foil in front of the crank sensor(on the block behind the turbo) . It protects it from heat and its a cheep test. If this works you can make a better sheild or leave the foil.

Dec 21, 2008 | 2004 Saab 9-3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Alfa Romeo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

905 Answers

Are you an Alfa Romeo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...