Question about Subaru Impreza

1 Answer

2001 impreza Abs light on and cruise control not working

The abs light on my 2001 impreza occasionally comes on and the cruise control doesn't work also. Are the two related?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

From what I have read the flashing cruse light is to get you to fix the problem. Any cel will throw the cruse light and cruse will not work. Get your abs checked out and cruse will work again when fixed.

Posted on Mar 31, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: cruise control won't engage

most likely the clock spring is not the problem because when u push the button the dash light cruise comes on.wich means that you do not have an open circuit.with a light tester check to see if you are getting power to the cruise control servo.if you are then replace it.if no power you will need a new cruise control stick on the steering column.

Posted on Jan 08, 2009

  • 6 Answers

SOURCE: Brakes tend to catch, release, and catch again when coming to full stop. ABS light comes on and then brakes work fine again. Also...probably non-related? Oil pressure light will come on occasionally o

abs computer sounds no good,check for short in wire to oil sender wire might be grounding out to turn light on

Posted on Jun 03, 2009

  • 14036 Answers

SOURCE: abs light problems

I HAVE SEEN A BAD BRAKE LIGHT SWITCH CAUSE THE ABS AND BRAKE LIGHTS TO COME ON.BUT TAKE IT TO A DEALERSHIP.BECAUSE YOU COULD BE HAVING BRAKE FAILURE THE.ABS BRAKES MAY NOT BE WORKING.LET THE GARAGE OR DEALERSHIP SCAN IT. AND FIX.

Posted on Sep 13, 2009

emissionwiz
  • 75797 Answers

SOURCE: 1997 MB C280 ABS light -replaced stop

Hello
The ABS warning light only comes on and stays on when a fault exists in the ABS system, when the fault is repaired the light will be turned off by the ABS control module. There are many components in the ABS Brake system that can turn the light on when they malfunction, so when this light is on you will need the dealer to hook up a special tool called a scanner, it will read the fault code that is turning the light on in the dash display, then based on that code(s) the technican performs diagnostics and repairs or replaces the failed part. Guessing is not an option here as all the parts of the system are very expensive, so proper diagnostics are the only way to minimize the expense of repair.

Posted on Mar 10, 2011

bcyrsgallant
  • 11 Answers

SOURCE: ABS LIGHT AND BRAKE LIGHT STAY ILLUMINATED

i currently own 2 of these trucks, in total ive had 6 of them .. i know i must like abuse right..lol. on your cruise not working. try this the big flat panel on your dash under the steering wheel. remove it.now this is assuming you have a tilt unit. money bets you do. but anyways the main feed wire i think its called D3 goes out to the fuse box as well as many other wires and a very fine i think again green wire. the problem is that over time using the tilt under normal circumstances those wires start to break. the D3 goes right to the key switch. if that breaks while out on the road. you have 4200 pound paper weight. good place to start. as for your brake light and abs most likley its the abs card or trigger that is located on the center of the rear axle housing. alot of times just replacing the card. if it comes back in a week then its probobly the trigger. not that its broke. this thing goes thru the housing and reads the teeth on the ring gear. and any little wear or a slight chip and they dont read right.. i quit fixing this problem on mine.truth is this thing is the second most delicate thing on the truck... the junk transmissions are the first.. sorry had to say it

Posted on Feb 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Pontiac aztek cruise control stopped working along with the ABS


Cruise control fuse # 31 10amp located in the under hood fuse / relay box an HZDFL fuse # 40 15amp located in the center console fuse box . If you pull the plastic side panel off of the right side of the console there is a fuse box inside . If the fuse are good the control module could be bad . Could also be turned off because the ABS has a problem .
DTC P1554 - do you know what a diagnostic trouble code is ?

The powertrain control module (PCM) has the ability to inhibit cruise control operation if conditions exist that would make cruise operation undesirable. The following conditions may inhibit cruise control operation:
• The engine speed is too high or too low.
• The vehicle speed is too high or too low.
• The traction control has been active for longer than 1 second.
• The vehicle acceleration or deceleration rate is too high

If the ABS light is on ,there are DTC'S stored in the system . Your best bet , take it to a GM dealer or someother qualified repair shop.

Mar 03, 2017 | 2001 Pontiac Aztek

1 Answer

Which fuse controls cruise control on a 2009 Dodge Caliber


If there is a problem with the ABS the cruise control is disabled ! you have to fix the ABS problem for the CC to work !

May 29, 2015 | 2009 Dodge Caliber SRT-4

1 Answer

WHY DOES MY ABS AND BRAKE LIGHTS STAY ON?


brake and abs light check brake fluid level. The round float in the master cylinder directly controls the 2 dash lights.
The light is NOT directly controlled by the master cylinder float. The light is controlled by the ABS Module, which location depends on your vehicle. There are a number of different reasons the lights come on. If it comes on but shuts back off within seconds, don't worry about it, that occasionally happens when it gets a bad signal ("nonlatching error"). In rear-wheel-drive (RWD) vehicles, it is common for the differential speed sensor in the rear differential to go bad. You can pick up a Haynes manual to find if you can do at-home diagnostics (Temporarily grounding out the diagnostic lead will cause the ABS light to flash out a pattern indicating the error)


Check the Brake Pressure switch ( also known as SPEED CONTROL DEACTIVATION SWITCH ) which is located below the Brake fluid master cylinder for leakage. The leakage can cause both lights to stay on and also cruise control control not working

Sep 22, 2014 | 1998 Dodge Ram 1500 4WD

1 Answer

ABS light and all wheel drive light in 2009 impreza 2.5i


The common denominator here is a speed sensor. If your speedometer is working fine and your cruise control operates properly, then I'd guess you have a faulty wheel speed sensor. Rain will definitely aggravate a failing sensor, since they are only a few inches from the road.

Dec 04, 2013 | Cars & Trucks

1 Answer

Horn doesn't work,abs light on dash stays on and also cruise control does not work either


Typical reason for no cruise and horn is a bad clock spring underneath the airbag. Typically you have an airbag light on as well and not an abs light

Aug 21, 2012 | 1998 Nissan Quest

1 Answer

2006 Jeep Liberty Diesel, Cruise doesn't work. Cruise, ESP and ABS dash lights on


You must have the systems scanned for fault codes before any reason can for the problem can be given.

Jul 16, 2012 | Cars & Trucks

1 Answer

The cruise control on my 2001 just quit working i have checked the fuses and all are ok while driving i can engage the criuse control and the cruise light comes on for an instant almost like a flash any...


A vehicle speed sensor provides a signal for the cruise control and also for the ABS braking and the overdrive function. I would start with finding the fuse for the cruise control in your owners manual. Also some cruise controls have vacuum lines attached, if so, check for cracked or broken vacuum lines. Good luck.

Oct 07, 2010 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Random lights coming on in the dash and stalling occasionally


See if you can find out if there is a code for the check engine lite and the abs, those can be related if the speed sensor located on the top of the rear axle is intermittantly failing. That sensor sends the speed signal to the pcm and the abs controler witch will also turn off the cruise control.

Feb 17, 2009 | 2001 Dodge Ram 1500 Truck 2WD

2 Answers

Cruise control doesn't engage 1999 volvo s80 t6


not a volvo mechanic but on most american cars the abs and stc modules are in direct corilation with the cruise even though the cruise is most likely ran from vacume the disengagement is electrical.

Dec 06, 2008 | 1999 Volvo S80

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

186 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...