Question about 1999 Bentley Arnage

1 Answer

Rear shocks I have a 99 bentley Arnarge, the shocks are not working properly. The car bounces constantly and when I had it checked, I was told the hydraullics were pumped all the way up and not adjusting! Any advice before I go to another Bentley dealership?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,162 Answers

This the wrong place to ask that question.bet there is not 1 in 1 million on here that has one

Posted on Mar 30, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
crayzeetrayn
  • 837 Answers

SOURCE: I'm looking for a bentley continental GT 2005 repair manual

Here are some

Posted on Mar 11, 2009

  • 2 Answers

SOURCE: 2006 bentley continental w/dead battery. How can

Normally if you use the key and turn it to the left and then to the right the car will start on the resident battery and all will be well. Do not use the start button. If all lelse fails then put a battery charger into the two cigar light sockets for 1 hiur at max 10 amp with ignition turned of and with wires trapped in closed door to switch all coutesy lights off and then there will be enough for the trunk lock to energise. If it is later spec there will be a handle in the trunk accessible thru the centre arm rest by an arangutang!""

Posted on Jan 06, 2011

  • 357 Answers

SOURCE: how to replace rear gas

These are Spheres, and should be changed with knowledge about the hydromatic system.

Pressures of 500 to 2,700 psi in the system. Spheres are pressurized to 2,700 psi new with nitrogen gas. Expected life, 6 years.

Call ALBERS of Zionsville for parts and information.

Posted on Jan 14, 2011

  • 869 Answers

SOURCE: How much will it cost to repair the rear

u might need to check the pricing with ur dealer of bentley.

Posted on Feb 02, 2011

WhiteRussian
  • 167 Answers

SOURCE: I have a 2000 Bentley and I can't remove the rear set to pull the manual trunk release

If I am not mistaken, you have to remove the head rests, remove the bottom bench, fold down the armrest and remove the bolts behind it (Note: At the bottom, the bolts for the seat are held in by a clip... You just take a flathead screwdriver and pry it forward and it will then release. Make sure you dont let the seat-belts retract; it be difficult to get it back.) Typically, it takes about 2 hours to remove the seats. You will also need a metric set of Allen and Socket Wrenches to remove the bolts.

Posted on Nov 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shocks


On the hydro suspension system there are spheres which act as shock dampers. These are pumped up by the engine pump and run around 2400psi max.

As the wheels move up and down the 'ram' you would call the shock absorber displaces fluid into and out of the sphere/s. If these spheres are more than 6 years old, they go hard, because the nitrogen gas in them has leaked away. ( Gaseous Physics. They all do it. Nitrogen has a smaller molecual than the rubber trying to contain it.)

This nitrogen gas pushes a thick rubber diaphragm towards the hydraulic fluid acting as a spring. The small orifice the fluid has to pass through into and out of the sphere acts as a damper to the wheels movements up and down. A sensor on the axle/s keeps the pressure in the system at the correct ride hight.

You need new spheres if they have never been replaced.

Mar 29, 2014 | 1999 Bentley Arnage

Tip

When should I replace my shocks and or struts When a vehicle is brought into an...


When should I replace my shocks and or struts
When a vehicle is brought into an auto repair shop for routine vehicle maintenance, the auto technician may suggest that the vehicle shocks or struts need to be replaced. Learn the function of a car or trucks shocks and struts. Find out why the shocks and struts need to be replaced and how someone can tell if they’re bad.

The Purpose or Function of a Cars Shocks and Struts

Shocks and struts serve the same purpose. They’re main function is to keep the vehicle from bouncing. A vehicle has front and rear springs to cushion the vehicle over rough road conditions. If there were no shocks or struts the vehicle would continue to bounce excessively. The shocks and struts prevent the car from bouncing by damping the springs.

What’s the Difference Between Shocks and Struts?

Shocks are usually used to dampen leaf springs, where as a strut is used to dampen coil springs. Shocks are usually a single cylinder in the open where as a strut is normally surrounded by the coil spring and are more massive and complicated.

That’s why struts normally cost a lot more to replace than a shock. On a car the front suspension usually has struts and the rear usually has shocks. Some trucks have shocks on the front and rear. Other than those distinctions, shocks and struts serve exactly the same purpose.

Why Should the Cars Shocks or Struts be replaced?

Keeping in mind that the purpose of shocks and struts is to keep the vehicle from bouncing, the following is some of the reasons why they should be replaced.

* An excessively bouncing car can be an uncomfortable driving experience.
* The vehicle can be harder to control leading to an unsafe condition.
* Excessive strain can be put on other vehicle components causing premature failure.
* Bad shocks or struts will cause the tires to bounce and create spotty or choppy wear on the vehicles tires.

How to Tell if a Cars Shocks or Struts are Bad

1. Shocks and struts can be oil or air filled. If they are leaking oil or air they need to be replaced. Consumer beware, some dishonest auto repair shops will squirt oil on the shocks, show the customer the leaky shocks and tell them they need to be replaced.
2. Another method is the bounce test. Put all your weight on the front or rear of the vehicle and push down on the vehicle. Let go of the vehicle and stand back to see of it bounces. If the vehicle comes back up without bouncing, the shocks are probably in good shape. If the vehicle bounces a few times, chances are the shocks or struts need to be replaced.

Shocks and struts are wear items, not maintenance items. There’s no set mileage or time limit when they should be replaced. If the tires seem to have a choppy wear pattern or the vehicle bounces excessively over bumps, the shocks need to be checked.

Look at the struts or shocks and see if they’re leaking. Perform the bounce test and see if the vehicle bounces. Replacing the vehicle shocks and struts when they’re bad will create a safer and more comfortable driving experience, not to mention saving money in the long run.

on Dec 14, 2009 | Honda Accord Cars & Trucks

1 Answer

I have a 99 bentley Arnarge, the shocks are not working properly. The car bounces constantly and when I had it checked, I was told the hydraullics were pumped all the way up and not adjusting! Any advice...


If just bouncy like riding in a wheel barrow, gas springs are the most likely fault.

If the rear is jacked up high then also look at the height control valve linkage in case it has become dislodged, damaged, moved. If not check the height control valve.

Rolls Royce Wales Bentley Wales

Mar 29, 2014 | 1999 Bentley Arnage

1 Answer

Suspension soft


I would say you probably need new rear shocks as they take out the spring oscilations.

Jan 03, 2013 | 1996 Bentley Brooklands

1 Answer

Bouns with hard ride


re arnarge hard ride you willreq 2 rear suspension spheres then bleed hydrolic suspension oil for this is rh5000

Sep 12, 2011 | 1999 Bentley Arnage

1 Answer

2003 jetta the rear tires are wearing on the inside.I have had it lined up and was told there is no reason for this to be happening. Can the rear tires be shimed out?


If the proper alignment was set,the only thing that could be an issue would be the tire pressure. I would put 35 pounds of air ,in the tires and see if that might help. Also try to lighten the load on the rear of the car. Clean out the trunk ,ect,.. If that doesnt help ,maybe the rear shock absorbers are weak and need replaced. You can test by bouncing the rear of the car and it should only bounce one time. Even have a freind help bounce the car hard and it still should return back .Let me know if that helps

Mar 27, 2011 | 2003 Volkswagen Jetta TDI

1 Answer

Need to reset service light on my 02 arnarge


same as a voltswagon procedure i think ,hold trip button in and turn ignition on and see what happens

Mar 07, 2010 | 2002 Bentley Arnage

1 Answer

HOW CAN I STOP ONE OF MY BENTLEY ARNARGE HEADIGHTS MISTING UP?


It is misting up because there is a leak in the housing somewhere. The solution would be to find the leak and sealing it with RTV. This would usually require removing the headlight assembly from the car to inspect it.

Aug 09, 2009 | 2000 Bentley Arnage

1 Answer

99 Deville rear air shocks not working.


This is an expensive repair sometimes and you may want to replace this system with inflatable air bags that fit inside the rear coil springs and then are inflated. I think they cost about $80.00 or $120.00 depending on the car.

Jul 14, 2009 | 1999 Cadillac DeVille

1 Answer

Shocks


Remove the rear covers from the head light unit. Put these cover in the bin. After 2 days the head lights will be ok? I had this problem with my Arnage and it's never happened again. I have had this one now 3 years

Apr 08, 2009 | 1999 Bentley Arnage

Not finding what you are looking for?
1999 Bentley Arnage Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bentley Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

Are you a Bentley Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...