Question about 1992 Toyota Pickup

1 Answer

92 toyota pickup v-6, if i stab the gas pedal it will get up to 2500-2575rpms then feels like im pressing the break on and off over and over again. no engine light,replaced the tps,mafs,plugs,wires di

If i stab the gas pedal it will get up to 2500-2575rpms then feels like im pressing the break on and off over and over again. no engine light,replaced the tps,mafs,plugs,wires distributer,and cap,check the cat.,cleaned fuel rails and replaced the fuel injectors, pep boys had it for about 3 weeks and no one can figure it out!

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 2 Answers

Have you or anybody at pep boys changed the igniter and coil. if not try to find a used igniter and coil to test with, they're pricy. If it works replace with new parts.

Posted on Mar 30, 2014

  • cory tardiff
    cory tardiff Mar 30, 2014

    ignitor sometime called the ignition control module. make sure if this fixes the problem tha t you replace both the igniter and the coil

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 18 Answers

SOURCE: 1994 Toyota pickup 22RE with 121K miles

check for a air leak in you sistem, or check for aditional idle screw adjust in the another end af the accelerator propel

Posted on Nov 02, 2008

  • 141 Answers

SOURCE: bad stumble on acceleration pops through t- body.

Sounds like the fuel pressure regulator. Could also be that the timing jumped. But I'm leaning towards the pressure regulator. Hope that I could help. Best wishes.

Posted on Jan 17, 2009

slfowler29
  • 51 Answers

SOURCE: 2001 Toyota corolla hesitates on acceleration

Basically this means that an oxygen sensor in bank 1 detected a lean condition (too much oxygen in the exhaust).

Posted on Mar 27, 2009

  • 19 Answers

SOURCE: toyota seinna po440, po441, po446

you have to understand that there is a leak in the system other than the gas cap for the evaporative system. The system needs to be professionally closed, and smoke introduced into to find the leak, and a through component check, eg.. purge valve vapor canister vent solenoid all functioning correctly

Posted on Sep 01, 2009

c1apton15
  • 3400 Answers

SOURCE: I have a 93 Toyota pickup 22re engine that has

When was last healthy tune up? Plugs, wires, ALL fluids & filters? I'd start there, then check tire pressures to make sure they're up.

Posted on Mar 14, 2011

Testimonial: "My tire pressures were extremely low, like 10 psi. Like driving through sand everywhere i went. Thanks for the helpful feedback."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 toyota brake light switch location?


Near where the pedal is hinged on the bracket

Oct 20, 2017 | Toyota Cars & Trucks

1 Answer

93 toyota Camry 6 cylinder starts but dies when you touch gas pedal tried to check codes again but light won't flash did full tune up, coil, and throttle position sensor


It could be your air intake tube has cracks between the ribs. When you press the accelerator pedal, the engine rocks and opens up a giant vacuum leak. Duct tape will work in a pinch.

Sep 09, 2015 | Toyota Cars & Trucks

1 Answer

1994 toyota pickup. firm break pedal. the truck stops every time but the pedal is way to firm. If there is wet pavement outside is very easy for the brakes to kind of lock up. The problem is hit and miss....


it may be : the brake booster is lack of vacuum pressure and can't supply enough force when you push the brake pedal. we supply all kinds of Toyota brake boosters : feel free to contact if any interest

Oct 04, 2013 | 1994 Toyota Pickup

1 Answer

How to work a 1983 toyota 4x4 stick shift?


Simply press your left foot on the clutch pedal, and move the stick shift to the desired gear. When doing so, please go off the gas pedal with your right foot.

Aug 19, 2013 | 1983 Toyota Pickup

1 Answer

1990 toyota pickup v6 starts-up step on gas pedel motor then dies


does thr engine rev upwhen started than idels back down.try idel control switch and map sensor

Oct 27, 2012 | Cars & Trucks

1 Answer

1988 22r pickup have to pump the gas now before starting 15 to 20 times. i didnt use to have to pump the gas before every start if it sits more than 10 hours it wont start unless i start pumping the gas...


Seems like the choke is not turning on. The 22r uses a carb if I'm not mistaken. pump it a couple of times then try pressing the pedal completely down before trying to start it. Then press the pedal half way down. the point is to set the choke when you press the pedal all the way down.

Oct 31, 2011 | 1988 Toyota Pickup

1 Answer

I have a 91 yota pickup with the 22re. It is a 5 speed manual, over the last couple days i have started noticing a noise which is now much louder and more pronounced, at first i thought it was suspension...


These year models are known for fatigue crack on the upper clutch pedal bracket. This bracket is welded to the dash frame and holds the cluth pedal. To inspect, use a flashlight and point upward illuminating the steel plate. Use your other hand to press on the clutch pedal while observing for plate movement or cracks on the plate itself. If the plate has a crack, its allowing the entire clutch pedal to swivel reducing cylinder and slave travel. If damaged, it must be welded with additional metal plates for increase strength.

Aug 10, 2010 | 1991 Toyota 4Runner

1 Answer

Car starts fine, but stalls at stops and takeoffs occasionlly


Most likely it is running too ritch. should be around 7%. Mine did ecactly the same thing and I had several things done . Had the throttle body cleaned and installed a O2 senser.runs great now.

Hope this helps

May 14, 2009 | 1993 Oldsmobile Cutlass Supreme

1 Answer

92 toyota pickup 22RE


I would not change the igniter. It either works fine or it does not work at all. Lets take a look at the basics first: What condition are the wires in? Are they reasonably new? How about the spark plugs? Are they Toyota plugs, from a Toyota parts dept? Aftermarket plugs do NOT run well in a 22RE, no matter what the auto parts store tells you. Then, look at the tube from the air flow meter to the intake manifold. Is it cracked? An air leak here will def cause you problems. Pop the air intake hose off of the throttle body, look at the butterfly in the throttle body; is it dirty? Clean it with carb cleaner until it is nice & shiny. Let me know.

Sep 07, 2008 | 1992 Toyota Pickup

Not finding what you are looking for?
1992 Toyota Pickup Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...