Question about Cars & Trucks

Open Question

Where is the purge solenoid located on a 1999 buick century limited

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel purge valve located on a 1999 Buick Century?


Brent, Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

Canister Purge Valve

Mar 21, 2016 | Buick Cars & Trucks

1 Answer

Where is the location of the Vapor Canister Purge Solenoid on a 2006 Buick Rendevous


Here is a link for locating/replacing the canister purge solenoid on a 2006 Chevy Impala. I couldn't find a video for your Buick, but I suspect it may be located in the same area - near the fuel filler neck. How To Install Evaporative Emissions Canister Purge Solenoid 2006 12 Chevy...

Jan 11, 2016 | 2006 Buick Rendezvous

1 Answer

V6 3.1 L engine. Where is the EVAP purge solenoid valve located?


The purge solenoid should be attached to the backside of the bracket that the coil pack is mounted to. Find the coil pack and then look behind and down. It will be a black plastic piece that has two hoses connected to it. If i remember right the connector is red on that one. It is not easy to see or replace.

Jun 04, 2015 | 1996 Buick Century

1 Answer

I have a 1996 Buick Century...Having codes P1651, 1652, and 1655 come up...can clear the codes and will drive for about 4 days...then either have to clear codes again OR have to figure out where these...


fan 1 and 2 relay, and the 1655 is evap purge solenoid, the fan relays going bad can cause the car to run hot or overheat, check for broken vacuum lines and replace the purge solenoid if needed.

Oct 16, 2012 | 1996 Buick Century

1 Answer

Location of torque converter control solenoid on 1999 buick century


Under the big side cover on the transmission valve body on the drivers side of vehicle.

Oct 06, 2011 | 1999 Buick Century

1 Answer

I am getting P0440 EVAP Control System Malfunction for my Buick Century 1999 and need to know how to fix it thanks


A code P0440 could mean one or more of the following has happened:
  • The gas cap is not installed or working properly
  • The purge solenoid has failed
  • The canister is plugged and not working properly

Possible Solutions: with a P0440 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:
  • Remove and reinstall the gas cap, clear the code, and drive for a day and see if the codes come back.
  • Inspect the EVAP system for cuts/holes in tubes/hoses
  • Inspect for damaged or disconnected hoses around the Evap purge solenoid
  • Check and/or replace the sensor
  • Check and/or replace the purge valve
  • Have a professional use a smoke machine to detect leaks

Keep us updated.

Nov 15, 2010 | 1999 Buick Century

1 Answer

Where is the EVAP emission control system


The EVAP control system includes the fuel tank, fuel filler neck, gas cap, charcoal cannister, evap diagnostic solenoid, purge solenoid, all of the connnecting hoses/lines, ECM and related wiring. Anything that contains fuel that may evaporate (EVAP).
Does the vehicle have a P code for some EVAP problem, like large or small leak, or vent path blocked? Do you have a problem filling the fuel tank or is the Check Engine/ MIL lamp illuminated? If there is a larg or small leak the best way to identify where the leak is located is to use a smoke machine which creates smoke and introduces it into the system and you look for the leak.You will need to close the evaproative diagnostic solenoid using a scan tool or a jumper harness.

Oct 29, 2010 | 1999 Buick Century

1 Answer

Where is the solonid in the transmission of a 1999 buick century located?


Replace the idle air solenoid. This sensor controls airflow into the engine to regulate idle speed. You will find the unit around the throttle body. Unplug the electrical connector and remove two or more mounting screws or bolts using a Phillips screwdriver or ratchet and socket.
Step 2Unplug the electrical connector to change the EGR solenoid. This unit controls the introduction of exhaust gases back into the engine through a valve. They come in different configurations. Depending on design, vacuum hoses may be attached to the unit or to the assembly if they share the housing with other components. You may find the solenoid on top and to one side of the engine or by the firewall. Unscrew the mounting bolts using a wrench or ratchet and socket, and disconnect the vacuum hoses.
Step 3Remove the vacuum hoses and unplug the electrical connector to remove the canister purge solenoid. This solenoid uses vacuum flow to carry fuel vapors from the fuel tank into the engine for burning. This small unit may comes in different configurations. Some are cylindrical in shape and may be located almost anywhere around the engine compartment. Follow the vacuum hoses connected to the back of the throttle body to find the unit. Some purge solenoids may be mounted in place with a bolt while others may be just hanging loose on the engine compartment.

Aug 14, 2010 | Buick Century Cars & Trucks

1 Answer

2001 Buick Century shift solenoid


It is in the side cover on the valve body. The transmission needs to be removed to access the solenoids.

May 03, 2009 | 2001 Buick Century

1 Answer

96 Buick Century won't pass imisions code P1441


code is evap system flow during non-purge
check the hoses for holes or broken disconnected hoses also check the fuel cap emissions diagram under the hood will give u the location of the evep purge solenoid if all checks ok then replace the soienoid and clear the codes
rank & vote my solution

Dec 11, 2008 | 1996 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...