Question about 2009 GMC Yukon XL

1 Answer

Rear lift gate washer out of fluid

Where do you refill the washer

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 5,571 Answers

The rear washer is fed from the same bottle that feeds the front washers! Normally the pipe comes off by the fuse box under hood! Lift hood and activate the rear washer.....if you hear the motor it's the pipe come off/blocked.....if no motor sound then it is the motor!

Posted on Dec 28, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does LGM #2 stand for on the fuse panel under rear seat?


If your vehicle has a powered liftgate, it stands for Lift Gate Motor.

Dec 04, 2015 | Cars & Trucks

1 Answer

Rear washer does not work front ok


The '97 Explorer XLT I owned had a widow washer reservoir (cap) that is visible only when you open the rear lift gate up. Just below window height on the..umm.. driver's side (if not - check the passenger side). Locate it and fill it with fluid.. as I recall my '97 held nearly a gallon.

Oct 08, 2015 | 1999 Ford Explorer

1 Answer

Power liftgate will not open with remote, instrument panel control or button in rear cargo on lincoln mkx


It can be faulty switch or its issue with lift gate latch.Its got stuck up hard or cracked inside.It has to be inspected.-----------
There are few help links with proper solutions for these problem.I suggest you to refer the links.
Click the link below:----
2007 Mercury Mountaineer: Liftgate will not Unlock or Open? http://whoisbyme.blogspot.in/2012/06/2007-mercury-mountaineer-liftgate-will.html
------------
Adjust Hydraulic Lifters? http://schematicsdiagram.blogspot.in/2012/04/adjust-hydraulic-lifters.html
-----------
How to open rear lift gate? http://repairhelpcenter.blogspot.com/2011/12/how-to-open-rear-lift-gate.html

--------- Power Liftgate Shuts Down http://whoisbyme.blogspot.in/2012/07/power-liftgate-shuts-down.html
------------ Power Lift Gate Will Not Remain Open http://whoisbyme.blogspot.in/2012/07/power-lift-gate-will-not-remain-open.html
----------- Power Lift-gate will not Operate http://whoisbyme.blogspot.in/2012/07/power-lift-gate-will-not-operate.html
------------- Liftgate will Not Stay Up Open? http://whoisbyme.blogspot.in/2012/07/liftgate-will-not-stay-up-open.html

---------------- Rear Door will not open http://whoisbyme.blogspot.in/2012/07/rear-door-will-not-open.html
------------ 2000 Toyota Corolla: Rear Door wont open from outside or inside? http://whatisbyme.blogspot.in/2012/05/2000-toyota-corolla-rear-door-wont-open.html

--------------

These details will help.
Thanks.

Nov 25, 2012 | 2007 Lincoln MKX AWD

2 Answers

The rear windshield wiper motor needs to be replaced. where is it and how can i get to it?


MARK THE POSITIONS OF THE WIPER ARM ON THE LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE OUT SIDE LIFT GATE, THEN THE BEZEL.BECAREFUL DONT DAMAGE PAINT.ON THE LIFT GATE.AND REMOVE THE UPPER AND LOWER LIFT GATE TRIM PANELS.DISCONNECT THE ELECTRICAL CONNECTOR AT THE REAR WIPER MOTOR, THEN REMOVE THE TWO MOUNTING BOLTS SUPPORT WIPER MOTOR WHILE REMOVING BOLTS.THEN INSTALL NEW WIPER MOTOR AND PUT EVERY THING BACK IN PLACE VISA VERSA.

May 26, 2011 | 1998 GMC Jimmy

1 Answer

Where is the hose for the rear window washer on my 2002 Chev Blazer?


The hose runs along the frame and up through the tail gate on the two piece tail gate, on the single lift gate the hose runs from the top where the hinge's is located that hold the lift gate. Common for the host to crack there, causing it to leak before it goes out to the wipers. Good luck and hope this helps.

Jan 14, 2010 | 2002 Chevrolet Blazer

1 Answer

How do I refill the wiper fluid for rear window?


That van only has the one washer bottle. You fill the front bottle and there are two pumps inside that bottle. If you don't have any fluid coming out the back end then check to see if 1 the pump works. If you turn it on and it you hear the noise then the pump works. 2 check to make sure that the rear line has not popped of the one way valve at the back.(you can seee the one way valve if you remove the body to gate rubber). 3 check to see if there is anything plugging the lines or rear nozel

Nov 10, 2009 | 2000 Oldsmobile Silhouette

1 Answer

Low Washer Fluid


The fluid refill is right in front of your battery and supplies fluid to both windshield and rear glass as well.

Mar 31, 2009 | 2005 GMC Yukon Denali

1 Answer

I need to refill my rear windsheild washer fluid on my 00 suburba


if i am not mistaken it uses the same reservoir as your windshield washers. if its not working it may be plugged or malfunctioning.

Mar 13, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

How do I refill the rear window washer. Is it the same reservoir?


if i remenber lift the back gate on the right side near the the light the filler there thanks pierre

Dec 15, 2008 | 2002 Toyota ECHO

1 Answer

Rear Window Sprayer not working.


Rear washer pump is located near bottom of washer reservoir, below the left front wheel house extension and between left inner and outer fenders. Have some operate the rear washer switch while you listen in this area to find out if the the pump is running. The hose from the pump routes up along side the reservoir filler neck, into the engine compartment. Just aft of the reservoir neck an in-line connector joins the hose to the engine compartment hose. The engine compartment hose travels the top left front fender wheel house to the dash panel, passing through a grommet into the passenger compartment. In the passenger compartment, another connector joins the engine compartment hose, and then up through the front driver pillar to the headliner, then above the headliner along the left roof to the rear of the vehicle. It comes out above the lift gate, in the hinge gap, and into the lift gate to the nozzle.

Not likely to be stopped up. First find out if the pump is running, and that there's fluid in the reservoir. Look for fluid running out somewhere near the reservoir. The pump isn't running, or the hose is disconnected around the tank. Look for leaks (when running the pump, and reservoir filled) at the lift gate hinge joint.

Jul 25, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2009 GMC Yukon XL Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...