Question about Cars & Trucks

Open Question

How do you remove the front seats 40/40/20 from a 2000 F250

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I chance front passenger seat window on a toyota avensis 1999?


First, you have to remove the internal door upholstery or siding. Then you can access the window riser mechanism. From there, you can remove it but you need to make some maneuvers. Your best bet is to have a auto glass shop replace them for you. But if you are a DIY, you may try it yourself.

Sep 03, 2013 | 1992 Ford F250

1 Answer

How do you tear down front hub on 4 wleel drive truck?


FRONT DRIVE AXLE Manual Locking Hubs DISASSEMBLY AND ASSEMBLY Fig. 1: Three screws retain the cap to the hub body 91197g48.gif
Fig. 2: Remove the lockring seated in the groove of the brake rotor assembly 91197g49.gif
Fig. 3: Remove the hub body assembly from the brake rotor assembly 91197g50.gif
  1. Raise and safely support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the three screws retaining the cap and remove the cap from the hub.
  4. Remove the lockring seated in the groove of the brake rotor assembly.
  5. Remove the hub body assembly from the brake rotor assembly. To install:
  6. The installation is the reverse of the removal.
prev.gif next.gif

Oct 12, 2010 | 1997 Ford F250 SuperCab

1 Answer

How do you remove the Hub and Rotor on a 97' F250 with Auto 4 wheel drive? I can not get the rotor to come off. I know that the hub must come with it. However, I am not sure what I have not removed in...


Section 05-03C: Wheel Hubs and Bearings, Front Wheels, 4-Wheel Drive 1997 F-250/350/Super Duty Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 05/17/2000 Locking Hubs, Manual

e9801b.gif


Item Part Number Description 1 3A329 Halfshaft 2 3C132 Rolling Diaphragm Seal (Axle) 3 3299 Integral Spacer Needle Bearing Seal 4 3123 Bearing, Caged Needle 5 3105 Front Wheel Spindle 6 1190 Wheel Hub Grease Seal 7 4221 Inner Wheel Bearing (with Bearing Cup 4222) 8 1102 Front Disc Brake Hub and Rotor 9 4221 Outer Wheel Bearing (with Bearing Cup 4222) 10 - Pin (Part of 1195) 11 1195 Inner Lock Nut 12 1198 Lockwasher 13 1197 Outer Lock Nut 14 - Steel Thrust Washer
(Part of 3B458) 15 - Plastic Thrust Washer
(Part of 3B458) 16 - Splined Thrust Washer
(Part of 3B458) 17 3B457 Snap Ring 18 1K105 Hub Body 19 - Lock Ring (Part of 1K106) 20 1K104 Cap 21 1K104 Capscrew A - While Rotating Front Disc Brake Hub and Rotor, Tighten Inner Lock Nut to 68 Nm (50 Lb-Ft) to Seat Bearings. Back Nut Off 90 Degrees (1/4 Turn). B - Tighten to 217-278 Nm (160-205 Lb-Ft) C - Tighten to 4-6 Nm
(35-53 Lb-In) Removal
  1. Separate cap assembly from hub body by removing the three Torx® head capscrews.


    de0460a.gif



    de0285a.gif

  1. Remove the lock ring seated in the groove of the front disc brake hub and rotor (1102).


    f4658c.gif

  1. Remove the hub body assembly from the front disc brake hub and rotor. If the body is difficult to remove, install two capscrews and pull the body assembly out of the front disc brake hub and rotor.


    f4659d.gif

Installation
  1. NOTE: Do not pack the hublock body assembly or cap with grease. Excessive grease can cause excessive dialing effort and hub failure.

    Follow removal procedure in reverse order.
  1. Tighten three Torx® head capscrews to 4-6 Nm (35-53 lb-in).

Oct 04, 2010 | 1997 Ford F250 SuperCab

1 Answer

How to take out rear seats in a 2000 ford f250 lariat


crew cab,use a 50 torx in front bolts ,15mm on a ratchet on back bolts slide seat belt buckles throu seat crack ,fold rear of seat down ,lay seat with hinge toward floor slide out door (note watch brackets ,will scratch door pannals)

Aug 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

How do I put the front right rotor back on the spindle after a wheel bering replacement? I can't get it on far enough to get the spindle nut on. 2003 F250 2WD


Make sure you remove all the rust from the spindle and rotor. Make sure the bearing races are all flush. Use a rubber mallet,not a hammer
to properly seat the rotor. Good luck.

Apr 01, 2010 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

How to remove front fender on 2002 ford f250 super duty .


take off the fender bolts and the wheel well bolts take out headlight bolts behind the headlight then it should come off

Mar 28, 2010 | 2002 Ford F250 Super Duty SuperCab

2 Answers

Can not find fuel pump reset switch 1995 F250


have you looked in the passenger front seat right next to your right foot on the side kick panel. most of them are there with a little cutout for you to reset the fuel pump if it trips

Jan 26, 2010 | 1995 Ford F250

1 Answer

Remove front seat


SECTION 501-10: Seating 1998 Escort/Tracer Workshop Manual REMOVAL AND INSTALLATION Seat —Front Removal
NOTE: Driver side seat shown, passenger side seat similar.
  1. Slide the seat to its rearward position.
  1. Remove the front seat track to floor front bolts.
  1. Slide the seat to the forward position.
  1. Remove the front seat track to floor rear bolts.
  1. Disconnect the safety belt warning indicator switch electrical connector.
  1. Remove the front seat.

Dec 06, 2009 | 1998 Ford Escort

2 Answers

1997 f250 front headlight assembly replacement proceedure -


How do you remove the chrome headlight door on a 97 f250 powwerstoke

Sep 24, 2009 | 1997 Ford F250 SuperCab

1 Answer

F 250 brakes


Does the red break light come on the dash like when the park break is applied?
If so the check your proportioning valve if the truck has an abs system then the valve will be called a rabs valve.( located on the frame rail under the driver side seat) Check the break lines on the front calipers to see if they are damaged they may have been pinched so bad that they will not release. Also check to see If the master cylinder was changed , if the break lines were connected to the master cylinder incorrectly or the wrong master cylinder was installed the breaks will apply themselves…please rate this if it helped thx…

Oct 25, 2008 | 1997 Ford F250 SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...