Question about 1999 Lexus RX 300

1 Answer

Rear brake pads are worn on 1999 lexus rx300 would like factory part number to find factory parts at cheaper price,other than dealer

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

You won't get factory parts cheaper but you can get after market parts that meet factory specification's You want semi metallic pads because they last longer and don't wear out the rotors as bad as lifetime composite pads do. Also don't get ceramic pads because they will squeal if you do not know how to set them properly. You will need to turn the rotors too and that can be done at any parts store that supplies the pads, also be sure to put anti squeal on the back side of the pads and put the metal plates on so you don't get noise from the brakes.

Posted on Jun 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is the factory spark plug gap for a 2000 lexus rx300

hi Ale.
this link should help you find out.but it does depend on the brand/type of spark plug you use.
Get the Best Priced Lexus RX300 Spark Plugs
or this one.
NGK Lexus RX300 Spark Plugs
or this one.
2000 Lexus RX300 Spark Plug

Nov 21, 2017 | Lexus Cars & Trucks

1 Answer

Rx300 1999 wheel vibration- mostly when do left hand turn

It sounds like it might be a bad hub,CV shaft,or even poor brakes.A good mechanic will be able to tell you within 10 minutes of taking off the front wheels.The rotors on a car should be free from any marks or grooves.This is an indication that your brakes are in need of immediate attention and service.It is possible that your brakes are worn out on all four tires.I cannot stress the need for IMMEDIATE attention to this problem.good luck

May 16, 2014 | 1999 Lexus RX 300

1 Answer

Brake pads

The part that is hitting it is the brake caliber. The piston needs to be pushed back in. Get a 4-inch clamp and a piece of wood and put the wood over caliber, then clamp and tighten and push the piston back in.

Jun 02, 2013 | Cars & Trucks

1 Answer

My 2000 Lexus RX300 had a leaky rear main seal. The shop went to repair it and said that the old seal had worn a groove in the shaft, and now I'm looking at replacing the entire short-block of the...

sounds about right, it is an expensive car and so are the parts. however ask the shop to find you a used engine, might be much cheaper. a dealer or autorecylcer should be able to tell you what other models and years have the same engine. a used engine can be had for a thousand and a thousand to put it in, save you 2000 dollars.

May 06, 2011 | 1999 Lexus RX 300

1 Answer

I've been told I have a defective brake fluid level sensor in my 1999 RX300. The dealer wants $200+ for the part and charges $100 to replace. Any where to buy that part cheaper? Is it hard to replace?

Most of your big name parts retailers can get the part for you a lot cheaper. An intermediate level of skill is needed to replace the part, but a trusted local shop will replace it for 40-60.

Dec 02, 2010 | 1999 Lexus RX 300

1 Answer

How to replace mirrow glass for 1999 Lexus RX300

its just a push fit into a ring can buy a stick on replacement that fits onto the broken mirror for 1/4 the price of lexus part.accesory shop...NOT LEXUS.

Oct 22, 2010 | Lexus RX 300 Cars & Trucks

1 Answer

I have a 1999 rx300 lexus,my brake lights are out, i went to the dealer without the car and asked them about it they said it may be a sensor. Could it be a fuse or brake switch instead?

Actually it is most likely either both bulbs burned out (you would be surprised how often then happens!) unless you have a light monitor on your car, or a brake switch or a fuse. Fuse first (and need to find the reason it blew), bulbs second, switch third

Aug 16, 2010 | 1999 Lexus RX 300

1 Answer

How do i reset brake ware indicator on my 1999 lexus ls400

The brake wear indicator is a small metal stone-like sensor that attaches to the brake pad. Once the pad wears down to a certain level, it begins wearing into the sensor, breaking the circuit open.

Once the light has come on, the appropriate sensor (front or rear) must be replaced to return functionality.
Factory brake pads usually come with new sensors. Aftermarkets do not, and often have no provisions for attaching them either.

Alternately, you can bypass the brake level sensors by splicing the two wires for the sensor together. You will no longer have brake level warnings if you do this however.

Sep 12, 2009 | 1999 Lexus LS 400

1 Answer

1999 RX300 Transmission fails to engage in overdrive (high gear)

U need a shopmanual..library sec629. Autotrans r so complex it may just b a bad connect etc. Get car scanned to show a datastream. It takes a factory a privateshop

Mar 20, 2017 | 2008 Lexus Rx 350

Not finding what you are looking for?
1999 Lexus RX 300 Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts


Level 3 Expert

81285 Answers


Level 3 Expert

918 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides