Question about 1991 Buick Park Avenue

1 Answer

I figured out my starter relay is clickin and fuel pump relay is clickin, my security light blinks no way to turn it off but this light has blinked for a while,never had any starting problems,i have tried turning it off by unlocking the driver door,does this sound like i can maybe get a programmable remote to control my security,

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

Starter solonoid is on the starter. Remove battery cables and clean them and the battery. Replace bolts to cables.

Posted on Jun 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 95 3.4 camaro replaced fuel pump crank sensor fuel relay fuel filter starter. still wont start will turn over but wont start spray fluid in breather and it starts but then dies please help


With anoid light (special light for testing) check injector connector if the anoid light blink has you crank engine, if yes check fuel pressure.

Aug 14, 2013 | Chevrolet Cars & Trucks

1 Answer

How to check the theft deterrent relay on a 1999 oldsmobile delta 88 car? starter good, fuse good starter switch good, new battery.


Not starting?
If not, try this. Turn the key to on. Security light blinking? If yes, let it blink for 10 minutes + it will stop blinking. Remove key, then insert key and start car. Computers went bad on these often.

Jul 17, 2010 | 1999 Oldsmobile Eighty Eight

3 Answers

I cant seem to get the van to start its not fuel we tried that at least we think we hear in kicking on but it seems no to getting any fire????


just cause you hear a fuel pump does not mean it works it can work but not be pumping the correct amount of fuel pressure

Oct 19, 2009 | 2001 Chevrolet Venture

2 Answers

2001 grand am gt 3.4 v6, has fire and fuel cranks but wont start


check to see if the security light is blinking, if it is. thats an easy fix.

Oct 18, 2009 | 2001 Pontiac Grand Am SE

1 Answer

No fuel pressure. Changed fuel pump, checked fuses and relays. Jumped fuel pump relay and got fuel pressure. Checked cps sensor(not sure if checked right).


Security light on or blinking?

Passlock system on these cuts fuel pump signal if the key isn't sensed or there's a problem with the system. If you have a remote starter then that's a good thing to start focusing on. Inside the column there's two wires they tap on the right side coming out of the top of the ignition cyliner. If the taps wear out and break the wire, or cause too much resistance in the wire, then that could very well be your issue. Again, security system problems?

Also CKP sensor, if you're using a scan tool it will read as putting out something even if it's not right. If you have a reason to suspect a bad sensor then I'd start considering replacing it.

Oct 03, 2009 | 2001 Saturn L-Series

2 Answers

Car ran fine night before...next morning would not start. Replaced fuel pump, filter and switched relay but still had no luck. What else should we do?


CHECK TO SEE IF SECURITY LIGHT IS STAYING ON WHEN YOU TURN THE KEY TO RUN POSITION(NOT START) NORMAL OPERATION IS SECURITY/ANTI THEFT LIGHT ON FOR A FEW SECONDS THEN SHOULD GO OFF. IF ITS STAYING ON VEHICLE IS IN THEFT MODE WHICH WILL DISABLE THE FUEL INJECTORS BECAUSE CAR THINKS ITS GETTING STOLEN. MOST LIKELY CAUSE FOR THIS IS PASSLOCK SYSTEM(SENSOR IS LOCATED IN STEERING COLUMN)

Sep 02, 2009 | 2001 Oldsmobile Alero

1 Answer

Simmilar to ur problem


clean battery cables all of them.

Jun 15, 2009 | 1991 Buick Park Avenue

1 Answer

1994 gmc safari


Sounds like your Passlock security system went into the tamper mode. If your dashboard security light blinks when the ignition is turned on, your Passlock security system is disabling the injector module, preventing the car from start. Try this:
1- turn the ignition on and just touch the starter, without getting the motor to fire, then leave the ignition in the "on" position. The security light will blink for about 10 minutes. When the light stops blinking, turn the ignition off and leave off for 3 minutes.
2-repeat the step #1, 3 or 4 times. You will know that is fixed when you turn the ignition on and the security light does not blink, then the car will start. Make sure to stay inside the car when you're doing this, as opening the doors will trip the security tamper mode on again. Once the tamper mode is off, the car starts and opening the doors will not trip the Passlock tamper mode.

Aug 06, 2008 | 1994 GMC Safari

Not finding what you are looking for?
1991 Buick Park Avenue Logo

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...