Question about 1994 Chevrolet K1500

1 Answer

After replacing fuel pump and filt truck wont start with started fuid

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

If this is a diesel you should not use starter fluid unless the glow plugs and glow plug controller is removed. If this is a diesel you most likely have air in the fuel system.When changing fuel filter on a diesel fill the filter container with clean diesel,screw the top of the fuel filter canister on open the bleed screw and turn the engine over until only clear fuel (no air bubbles)is bled from fuel system. Then you may have to turn loose the connector on the innjectors to bleed more air out of the fuel system.

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford f250 v10 4x4 1999 superduty.replaced the fuel pump filte still no start. I am not real familiar witit v10 and would like some info if available please and thank u


What kind of info . ? It's no different then any other engine , needs spark , fuel an compression to run ! Pull a plug wire an hold near ground (metal on engine ) Does it spark ? If it does , spray some carburetor cleaner in the engine through the throttle plate ,does it try to start ? If no check fuel pump electrical circuit . Plenty of videos on you tube , trouble shooting cranks no start conditions ! How to test fuel pressure , checking spark .

Sep 29, 2016 | Ford Cars & Trucks

1 Answer

2007 ford e350 van fuse for fuel pump location


Fuel pump relay or a FPDM - fuel pump driver module , or the inertia fuel cut off switch was tripped . F150 Expedition No Start P1233 Fuel Pump Driver Module How to test an electric fuel pump no fuel psi testing Ford

Battery junction box , under hood ! Fuse # F13 20amp. The fuel pump relay is in same box . Do you know what a relay is ?

Mar 24, 2016 | Ford Cars & Trucks

1 Answer

Sounds like it wants to start i add starting fuid and it starts then dieds out


Sounds like you aren't getting any fuel. Check/Change the fuel filter and check pump pressure.

Jun 21, 2015 | Cars & Trucks

2 Answers

My 2001 Tahoe ran fine going to work. When I got off work, I started it up and it ran for 20 seconds then shut off. started again and started to go home. It jerked twice then ran 100 yards then shut off....


Check the crank position sensor. Also it could be as simple as a bad coil or coil wire. It definitely sounds electrical if you hear fuel pump priming. Also check distributor cap and rotor. Hope this helps

Jan 24, 2015 | 2001 Chevrolet Tahoe

1 Answer

88 toyota camry....drove car...parked it....when I went to start it lil later it just turned over but wouldnt fire....checked spark at plugs and had spark...fuel pump is working...even used starting...


Depending on how long it sat you may have either a weak spark (which will not start the combustion) or a timing issue. The timing belt may have slack, caused by a loose tensioner.

Jul 13, 2014 | Cars & Trucks

1 Answer

Truck is a 98 Denali I drove out of town when I can back tried to start it up nothing after checking for spark its good then I tried to check fuel pressure I had 0 so I tryed replacing the fuel filt


Sounds like the fuel pump went bad, a test you can try , this is not a sure test just a quick check, have some one beat bottom of the gas tank while you try to start it, this sometimes shakes the pump and make it run again, if it does start the pump is still bad.

Nov 14, 2012 | Cars & Trucks

1 Answer

Ford mustang tries to start but will not continue running. We checked the battery, spark plugs, starter, and alternator. We believe the problem is either with the fuel pump driver module or the pump...


try spraying starting fuid into the throttle body and see if it runs then for a few seconds. If yes, check fuel pressure. It should be 34 psi with engine running, 40 psi key on engine off. More liley th pump in the fuel tank.

Sep 08, 2011 | 2001 Ford Mustang

1 Answer

The fuel pump keep running i change the fuel pump and filt and the relay box and i still have a runing pump please help.


Have you ever considered getting a wiring diagram of the
circuit your working on, BEFORE you start to diagnose
your issues

Apr 06, 2011 | 1994 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...