Question about 1992 Cadillac DeVille

1 Answer



Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 210 Answers

Idle speed controller

which sits under driver side dash (RHD)

Posted on Mar 29, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Idle screw location, 1982 mercedes benz 380sec

Not in less than 25 words, but for your reading pleasure - here you go...There is no "idle screw" on your model mercedes. It is a fuel injected (in other words, not an older normal aspirator type carbuertor), computer controlled idle/air mixture. There is an idle/air speed control valve part (see picture ) that connects to the idle/air control unit (another programmable computer - one of about 20 in this model) that determines idle speed and air/fuel mixture. Mercedes is top of the line, but really too complicated for the average joe to work on. Best to pay the man and take to a mercedes specialist shop.493db71d-2619-442c-8065-798539caa300.jpg

Apr 20, 2014 | 1992 Cadillac DeVille


How to remove the door panels on Mercedes Benz?

1) First of all you need to remove the triangular panel near the rear view mirror. The mirror is fitted with clip under it. You will first need to unlock the clip. For this you will require a standard screwdriver.
2) Then there is a screws holding the black metal cover .this screw is fitted on door jamb. Remove this screw.
3) Then its time to remove the air bag badge .the air bag badge is fitted exactly above the door handle. Under that badge you will see a screw. Remove that screw.
4) Now you can pop the bottom of the door panel with a flat screw driver.
5) Once the door panel is pop out. You can wiggle it by pulling the handle and then you can lift the bottom of door panel to make it loose and come out.
6) Once the door panel is out. Take care you don’t pull it as there are wires connected to it. So remove the wires from the door lock.
7) After the wires are removed fit the new door panel assembly and reconnect all the wires to their respective positions.
8) Then reconnect all the other parts which you removed in this procedure.
9) Fix all the screws to their positions.
10) Then check out the door panel.

on May 21, 2010 | Mercedes-Benz E350 Cars & Trucks

1 Answer

I have a 1982 380sec it has sit for 4 years it ran when I parked it no fuel to motor?

replace the fuel filter and the fuel pump . check for fuel pressure . The injectors may be rusted up in the tips and wire connections may be corroded up and not working

Jan 05, 2014 | Mercedes-Benz 500-Class Cars & Trucks

1 Answer

Location of idle control valve 89 mercedes 300e

The 'idle control' on the 300e is bolted to the second intake tunnel and is a large zylinder with a 2 pole wire connection on one end and a hose connection on the other end. It is NOT ADJUSTABLE.

Apr 11, 2013 | 1988 Mercedes-Benz 300

1 Answer

How to adjust idlefor 1992 mercedes benz 190 e 2.6

do you want to adjust the idle up or down? If your car has too high of an idle, you probably have a vacuum leak. buy a can of starting fluid. Start the car and lightly start spraying starter fluid all over the intake. You will hear the engine change RPMs. When it does, that is where you have a leak. If you want to idle your car up, you will need to adjust your throttle plate. Where your throttle hand moves when you rev your engine, it has a little screw that you can adjust to make the throttle arm stop sooner, allowing more airflow into the engine.

Jan 10, 2012 | 1992 Mercedes-Benz 190

2 Answers

Timing problm

engine timing could be off.for the mercedes benz inline 6 cylinder ignition timing 7 - 11 degrees before top top dead center with idle set speed 650- 700 rpm. make sure engine tuned up before adjusting ignition timing.replace spark plugs and wires,replace distributor cap and rotor.change fuel filter and air filter and clean fuel injectors.if engine still stall out have fuel pressure checked should be 77 - 80 psi. if your car have the EZL CONTROL UNIT ADJUSTS TIMING AUTOMATICALLY NO ADJUSTMENT IS POSSIBLE.

Jan 03, 2012 | Mercedes-Benz Tamiya 1/10 Mercedes Benz...

1 Answer

82 benz trunk wont open dead baterry

If you use the key to lock all the doors, the trunk locks also, so if you have a dead battery, you probably don't have vaccuum to open the locks, because all the locks are vaccuum activated. Charge or change the battery and start it up, after a few minutes you should be able to activate the door locks, thus unlocking your trunk.

Good luck...

Jul 17, 2011 | Mercedes-Benz 300-Class Cars & Trucks

2 Answers

Need belt Fan diagram for a 2000 model mercedes sprinter van

The serpentine belt routing diagram for a 2000 Mercedes-Benz Sprinter 208 CDI, 2.2 liter, 60 kW (82 BHP) OM 611.987 engine code:

1. Without A/C (Air Conditioning) system:


2. With A/C (Air Conditioning) system:


Please do rate my response. Thanks!

Jan 06, 2011 | Mercedes-Benz Sprinter Cars & Trucks

1 Answer

I need to adjust the air/fuel mix on my carburetor

Theese are NON SERVICE Items If there Is a Problem From them The PART NEEDS REPLACED You will Only Make it Worse

Aug 04, 2009 | 1990 Mercedes-Benz 300 Diesel

1 Answer

Replaced dist. and don`t know ignition timing specs.also don`t know how to determine what motor i have. no info under hood, thank you(82 mercedes 380sl)

hello, in your registration paper they write engine number or try to look your engine number, in upper engine block,start with 116.9_ _ ,you can use this number to all your inquires,pls. post your engine,so i could post your inquires,ty

Apr 16, 2009 | Mercedes-Benz 190-Class Cars & Trucks

Not finding what you are looking for?
1992 Cadillac DeVille Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides