Question about 2004 Hyundai Santa Fe

Open Question

I have an 04 sante fe it will start eight up but it dies i have to keep my foot on the gas to make it idle i replaced the tps and when i got it scanned it came up code p1193

It wont stay running when i take my foot off the gas.i unplugged the mas air flow sensor and it stayed running

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: What did the dealer say?

We went to Wilkins Hyundai in Elmhurst, IL
Just as we were told by the Tech at NTB (where we thought it was a battery problem) that it was the Crankshaft Indicator - and it needed to be re-timed. This is what Wilkins found out (after about 3 days of waiting):
FOUND CODE: P0335 and P1372
REPLACE CRANKSHAFT POSITION SENSOR AND RESET CODES
TOTAL COST: $169.03
It was NOT an recall item.
The back hatchdoor latch issue was quoted to me but we didn't fix it. (the latch sticks in an open position) That cost was about $217...reeedonkulous!!!
It seems to be operating fine - to me it still sounds like it's racing a bit, but that's the way it always felt.

Posted on Jan 04, 2009

Ad
  • 65 Answers

SOURCE: how much does it cost to replace a fuel pump on 04

fuel pumps are kindda expensive, especially on import vehicles. Number one cause for fuel pump failures is heat. When your rinding with the fuel below half, the pump is party exposed inside the fuel tank and when exposed for periods of time it tends to heat up and then gradually burns out cause you to replace it. It's ok to go below half but not to often, I hope it helped abit.

Posted on Aug 18, 2009

  • 1 Answer

SOURCE: input speed sensor 2001 Sante Fe

that's actually the output of the vehicle speed sensor.
The input of the speed sensor is actually on the right front wheel assembly. It's the little electrical knob looking thing right behind the control arm.

Posted on Aug 23, 2009

  • 115 Answers

SOURCE: 04 Sante Fe 2.4L no spark no rpm pulse

rpm is regulated by the crank position sensor in all hyundai cars did one today

Posted on Sep 04, 2009

ghost45
  • 1280 Answers

SOURCE: how to replace crankshaft sensor on 2004 sante fe

Insufficient information. There are three different engines installed in the 2004 Santa Fe. Each one is different.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What would be wrong when my car has gas, but no spark?


2001 Sante Fe Won't Start, Cranks But No Spark. - Hyundai Forums ...

www.hyundai-forums.com/...santa-fe/112601-2001-sante-fe-won-t-start-...
Jul 23, 2010 - 10 posts - ‎3 authors I have a 2001 Hyundai Sante Fe that died on me while driving down my street. ... Thecar has many other unrelated problems and I am not sure I want to ... may be causing my two cylinder no spark and alleged fuel problem? 2006 Santa Fe 2.4 Engine swap-no spark
10 posts
Sep 24, 2012
No Start 2.4L Engine 2004 Manual
10 posts
Nov 26, 2011
Good Crank/Have Fuel pressure/NO IGNITION
10 posts
Oct 9, 2011
Car Cranks But Will Not Start
10 posts
Jan 16, 2008
More results from www.hyundai-forums.com

Engine cranks but won't start.What should I do. - YouTube

? 9:37
https://www.youtube.com/watch?v=jsQcLya1YLQ
Jan 24, 2014 - Uploaded by jimthecarguy
No Start Cranks Ok No Injection Pulse 2002 Hyundai Accent Easy Step By Step ... and car cut off, but would not restart. it sounds like it is starving for fuel. ... hi nice video man . i have no sparkno fuel .u think its the main? it was ...

Nov 26, 2015 | 2001 Hyundai Santa Fe

1 Answer

Dies out when stopping or idling


4.9 clean throlle body / tps adjustment and or replace / minuim idle air adjustment and idle control motor adjustment and or replace
4.6 clean throlle body /adjust idle control motor and or replace

Jan 14, 2014 | 1994 Cadillac Seville

1 Answer

1999 toyota 4runner, 140K miles: for 2 weeks, have problem starting when cold in morning. takes 3-4 clicks and foot on gas pedal to start. now also problem starting when warm after driving for 30mins....


Sounds like a sticky throttle if you can't keep idle. It won't hurt to try.... you can try a quick cheap trick by spraying a little carbon remover (buy at any auto store i.e. autozone, oreiley's) inside the throttle, open the valve, spray just small amount, close it back up and rev it a few times and repeat. It removes the carbon film after long use. fixed my idle issue in my cars. If its really bad you might have to clean it thoroughly but i highly doubt you have to do that.

https://www.youtube.com/watch?v=41yFXjibtLY

Sep 08, 2017 | 1999 Toyota 4Runner

1 Answer

It starts but will not idle. if you take your foot off the gas it dies. sometimes it will run good and i take it around the block it will die when i come to a stop unless i put it in neutral and keep my...


Possible areas of concern are:
  • faulty MAF (Mass Air Flo) sensor
  • bad EGR (Exhaust Gas Recirculator
  • bad TPS
It's most likely a combination of the 3 but the main cause would normally be the TPS (Throttle Positioning Sensor) which regulates engine idle speeds under different conditions.

Mar 20, 2011 | 1995 Dodge Intrepid

1 Answer

2001 nissan maxima gle it bogs down when i press on the gas,idles low at .5 rpm,dies when i start it i have to keep my foot on the gas,lights run dim when i come to a full stop it has 155,000 miles


Hi and welcome to FixYa!

As a first course of action, I strongly suggest that you replace the MAF (mass air flow) sensor and the TPS (throttle position sensor). If the MAF and TPS is faulty the RPM tends to go down or goes erratic. The MAF and TPS is located at the throttle body which is secured by small screws or bolts. It is visible which can easily be seen.

Once replaced you'll be good. Hope this helps and thank you for using FixYa! Have a good one!

Feb 27, 2011 | 2001 Nissan Maxima

1 Answer

Truck Starts but won't stay running


if the battery voltage gets low the computer will lose its memory...the idle air control is not ure what to do.. drive the vehicle for a while ...you may have to 2 foot it but eventually it should idle

Aug 11, 2008 | 2000 Dodge Dakota Quad Cab

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...