Question about 1997 Chrysler LHS
Have replaced the low beam bulb on my 97 Chrysler LHS a few times and at first it lasted about two weeks but now will not work at all. Can't figure out where the wire leads to to check it either.
I thought I sent this in earlier but you didn't say which side the light is bad. The light on the drivers side works different than the right side, it has it's own power and ground. the one on the right side has it's own ground but the power comes through the day time running module. Check the ground on each side and the fuses for each side
Posted on Apr 17, 2014
When you replace bulb did you touch glass will your fingers ? the acid from your fingers will destroy globes easily . try putting new globe in using lint free cloth , do not touch any glass with your skin . if so wipe clean before using .
Posted on Mar 29, 2014
Testimonial: "Nope, did not touch it and it has been replaced a few times...."
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: changing headlight 300m
lift the hood. the light are down behind the light assembly. simply turn large black ring and it will come out. be carefull not to touch the glass on the new one. oil from your skin will cause it to prematurely fail.
Posted on Mar 11, 2009
This can be done buy popping the hood and removing the bulb from the rear of the headlight housing. don't screw with the housing because, its leveled for optimal sight range.
Posted on Jan 28, 2009
Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.
Posted on Apr 18, 2009
open hood, remove radiator suport bar that has the hood latch on it. in the center above the grill there are 2 10mm bolts and 3 plastic fasteners with a pin in the center of them, pull pin up and remove fasteners. there are 2 plastic fasteners on each side of center piece i broke them off and replaced the with fasteners with push pin from auto store. remove 10mm and 13mm bolts holding the center support bar and 2 long 7mm bolts holding headlight assembly lift bar up and set on engine. be carefull not to scratch fenters or anything else with th end of bar. there will be just enough room to remove bulb. after you've done it once it takes ten minutes 2nd time. i just did my wifes 2 hrs ago. thanks gary j.
Posted on Feb 01, 2010
Tips for a great answer:
Jan 24, 2016 | Cars & Trucks
May 11, 2015 | 2002 Mercury Grand Marquis
Aug 22, 2014 | Cars & Trucks
Jan 24, 2014 | 1996 Ford Ranger SuperCab
Dec 29, 2013 | 1997 Chevrolet Blazer
Nov 29, 2013 | 2006 Honda Civic
Nov 18, 2013 | 1999 GMC Jimmy
Jan 31, 2013 | 2001 Hyundai XG300
Mar 24, 2017 | 2002 Buick Rendezvous
Nov 18, 2010 | 2000 Honda Odyssey
78 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: