Question about Cars & Trucks

1 Answer

Cuts out on highway?

Idles and runs great in town

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Hello Rick
I am short on information here as far as type of car or truck engine etc.
But I will start by saying it sounds like a plugged fuel filter to me and the engine is not getting the fuel required at the higher rpm highway speeds. That would be the first thing I changed if I were you.
I see this post is a little old so I hope this helps.
Be safe.
Mark / aka RagenRat

Posted on May 12, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2002 Sable sedan choke/missing/sputtering intermittent


The PO 316 is still misfires om first 1000 revolutions
so the shop did a poor job for you on resolveing the
cylinder misfires

Try a diffferent shop

Have to clean the MAF Sensor & replace upstream
oxygen sensors if over 100,000 miles

Need the correct oem spark spark plugs/any brand

No reason the gas filter should be clogged unless it was in
the car for 10 years

Fuel pressure should be checked

Need to check for cylinder misfires on a road test of 20
miles or more with professional software in Mode#06

Jan 17, 2013 | 2002 Mercury Sable

1 Answer

2000 malibu overheats on highway but not in town or when idling


check the tension of the fan belt. also make sure there is no debris on the radiator.

Aug 26, 2012 | Chevrolet Chevy Cars & Trucks

1 Answer

My 2003 Ford Focus dies when idling after a little road trip.


have the check engine light checked at a parts store its usuall free. I would bet its the idle air control motor. This controls the fuel air mixture at idle

Apr 18, 2012 | 2003 Ford Focus

1 Answer

My 91 Pontiac 6000 LE, V-6, 3.1 engine, will start good, go great on the highway but then when I slow down, it stalls out. Starts up but acts like it is choking out and dies again. When it does go, it...


You have a bad idle air / idle sensor. Your car believes that you are in idle at all times so when you come to a stop the engine floods. When the fuel evaporates you can drive again. Drove me crazy when it happened to me.

Sep 12, 2011 | 1991 Pontiac 6000

1 Answer

2001 Chrysler Town and Country has 149,000 miles. Had rear brakes put on and rotors turned, now going down road you might get a ****/hesitation and then when you put on brakes to stop it does a lot of...


Hard to say without a visual inspection. Have them rechecked by the shop that did the install. You may need new rotors. The rotors may have been cut beyond discard allowance,

May 28, 2010 | 2001 Chrysler Town & Country

1 Answer

I have a 1990 chevy truck, it Idols high - low in town


You may have an Air Idle Solenoid and or Idle Speed Motor. Not familiar with you vehicle. Check that out.

Apr 15, 2010 | 1990 Chevrolet K1500

1 Answer

Starts/stalls won't run until pedal tapped, 2 miles in town, 6 miles highway, then1000-1500 idle. shut down 9 hours, start/stall tap pedal runs return 6 mi. highway,2miles town same high idle. checked code...


Check your IAC motor (Idle Air Control) It could be sticking open.
Ps. Might be called Idle Speed Control motor it depends on the make and i forget what chevy calls theres.

Mar 11, 2010 | 2000 Chevrolet Malibu

1 Answer

Engine runs rough after about ten minutes /idles really low


Just trowing some suggestions out there, but, I would check the idle air control valve (solenoid) or the throttle position sensor. If they check out then my last guess would be the map sensor or the vaccuum to the map sensor. Hope I was able to help. Best wishes.

Jan 16, 2009 | 1991 Plymouth Laser

2 Answers

Have a 96 camry 4 cyl auto. After highway driving, the idle becomes rough and wants to stall. The problem eventually goes away after driving a city speeds. Around town, it runs all day just fine. Help ,...


Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve and throttle valve, they get full of gunk over the miles and cause idle issues (stalls) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Dec 05, 2008 | Toyota Camry Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...