Question about 1994 Ford Crown Victoria

1 Answer

Heat doesn't work on 1994 Ford Crown Victoria. I have no voltage to the connector to the water control valve. What should I be checking?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 128 Answers

I would check fuses and relay's first .

Posted on Mar 28, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 58 Answers

SOURCE: 2006 crown victoria - no heat

I would change the thermostat in the vehicle first and go from there. Hope this helps......Dan

Posted on Jun 21, 2008

CLEONTI
  • 33 Answers

SOURCE: need wiring diagram for 2008 ford crown victoria

Hello,

You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.

Hope this helps,

Chris

Posted on Mar 23, 2009

  • 108 Answers

SOURCE: 2005 Crown Vic climat contr fan not working Fuses good Motor good

does it have a digital control panel? As this uses an electronic blower speed controller located at the engine compartment (rear engine block) fix on ac phlenum try to shake the connector or wire while the system is on.

Posted on Jan 31, 2010

drsinister69
  • 2317 Answers

SOURCE: How to change spark plugs and coil connector wires

Each coil mounts on top of the spark plug and is bolted down to the intake manifold with a 8mm bolt. You'll need to unplug the electrical connector to the coil, remove the 8mm bolt and pull the coil and boot up off the plug and out of the motor. You'll need a 5/8 inch spark plug socket, a ratchet and a 6 inch extension. Also a telescoping magnet with help getting the plug up out of the hole.

Posted on Apr 26, 2010

  • 45 Answers

SOURCE: 1994 Ford Crown Victoria power front window will

if it sounds kind of grinding the regulator is bad, it is cable driven and
whenit goes bad the window wont move but the motor still runs

Posted on Aug 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

In 1994 crown victoria, briefly heard a quick clicking sound. When this happened, the voltage went down also.


If it has air suspension. the air pump could be turning on. If it was idling slow, the A/C pump could reduce rpm if step-up circuit did not stabilize rpm. Lower rpm can mean lower voltage.

Jul 30, 2014 | 1994 Ford Crown Victoria

2 Answers

How to repair 2004 Ford Crown Victoria A/C will not blow from dash vents


its either a bad air control panel or u have a bad damper valve in your dash

May 01, 2014 | 2004 Ford Crown Victoria

1 Answer

No hot air working with heat on only cold air blowing in my ford crown victoria


CHECK THE RADIATOR WATER. SOMETIME IT CAN ALSO MAKE A DIFFERENCE

Oct 14, 2012 | 2001 Ford Crown Victoria

1 Answer

Where is the heater control valve on 2006 crown vic


This car doesn't use a heater control valve.

Oct 03, 2012 | 2001 Ford Crown Victoria

1 Answer

Crown victoria Climate control is stuck on heat


ned to remove the radio and look at the blend door actuator on top of the hvac box. the actuator goes bad and doesn't move the door from hot to cold. if you see the actuator moving but still no cold air then the blend door could be broken.

Aug 01, 2011 | 2001 Ford Crown Victoria

2 Answers

THE AIR FROM THE HEAT SYSTEM WILL NOT GET HOT PUT IN NEW HEATER CORE THE FAN IS RUNNING BUT NO HOT AIR


Check to see that the heater control valve is operating when you turn the temperature knob. It should be located under the hood close to the heater box.

Jan 20, 2011 | 1994 Ford Crown Victoria

1 Answer

Power windows are not working what can i do ?


Check the voltage to the window unit. If power is not present check back to the fuse box in the power windows section/ break in wires in the harness.
If present then the main controller is faulty, see for voltage to the main unit .

Sep 11, 2010 | 1994 Ford Crown Victoria

1 Answer

2005 Crown Vic climat contr fan not working Fuses good Motor good


does it have a digital control panel? As this uses an electronic blower speed controller located at the engine compartment (rear engine block) fix on ac phlenum try to shake the connector or wire while the system is on.

Jan 31, 2010 | 2005 Ford Crown Victoria

1 Answer

I feel heat coming from my car when my heat and ac are off


Heater control valve wont close all the way and is allowing hot water to flow into the heater core ad thats why you feel the heat.

Sep 24, 2009 | 2000 Ford Crown Victoria

1 Answer

Air intake makes noise 1994 crown vic


change the idle air control valve and this will stop.

Jul 12, 2008 | 1994 Ford Crown Victoria

Not finding what you are looking for?
1994 Ford Crown Victoria Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...