Question about 2007 Suzuki Grand Vitara 4WD

1 Answer

Vibrating rear propellor shaft

Vibration in rear propellor shaft when pulling away uphill or with a heavy load

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Suzuki Master
  • 3,679 Answers

Could be worn axle bush's ,they hold drive assembly to chassis , if worm would cause they dive assembly to 'roll' back and forward esspecially when under most torque

Posted on Mar 28, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2002 chevrolet tracker vibrating in 4wd mode only. Any tips?

I suggest you begin by checking the propellor shaft(s) and universal joints.

Mar 16, 2017 | Chevrolet Cars & Trucks

1 Answer

There is a grinding noise in the rear end

Could be problems with the rear axle; final drive carrier bearings or crown wheel and pinion or the pinion bearings. Each of these can produce a load sensitive noise.

After a thorough inspection of the propellor shaft, axle mountings and so forth I suggest you draw an oil sample from the axle into a sight glass. If the sample is metalised the internal components should be exposed for further examination.

Jan 22, 2016 | Nissan Pickup Cars & Trucks

1 Answer


Check for a worn universal joint on the drive shaft going to the rear wheels.

Check your transmission fluid level. (Low level can cause vibration on acceleration.)

Check to see if your transmission filter needs changing.

Does it only vibrate under heavy acceleration?

May 04, 2015 | 2006 Honda Ridgeline RTL

1 Answer

Fh16 Volvo truck vibrating

There are many things that can induce a vibration in the truck, but it seems that most of the common vibration problems are centered in two areas, balance and wheel/tire defects.

Nov 28, 2012 | Cars & Trucks

2 Answers

Vibration when accelerating and at high speeds

could be a few things engine mounts gearbox mounts cv joints on prop shaft flex disks if it has any could be missing when under heavy load there are many things i have somthing similer on my mercedes think its the flex disks hope this helps

Aug 18, 2012 | 2005 Ford Escape

2 Answers

I have a 2006 chev 2500 HD. The steering wheel and 4x4 shifter shake very bad at 50mph. It has had a new transfer case put in, driveshaft balanced and all four tires checked. The vibration goes away if you...

u need to check rear end with the drive shaft removed vibration goes away would lead me to believe you have bad bearings in the rear end more than likely the pinion bearing
pull cover off (while fluid draining check to see if there a lot of metal in oil )
if you do see metal in fluid or laying in rear end you need rear end rebuilt or replaced
i wouldn't recommend doing the rebuild your self because with out the special tools and knowleage u can make matters worse

Dec 14, 2010 | 2005 Chevrolet Silverado 1500 2WD

1 Answer

Reg E220 Petrol . There is a humming noise / vibration from below the rear end while travelling betweeen 80-90 km , when you deacclerate.. I have changed the rubber joint and also check the propellor...

check any visual oil leaking from differential, if oil mark there check diff oil and adjust or replace oil, then get it for drive, if the problem same as before check rear wheel bearings.if no noise from wheel bearings possibly faulty transmission get it diagnose by transmission experts what's the fault in trans mission, is this information helped you?

Oct 19, 2010 | 1999 Mercedes-Benz E-Class

1 Answer


remove the rear drive shaft and redrive it. it could be the drive shaft or the angle gear (the front of the drive shaft bolts to the angle gear).

Feb 22, 2009 | 2003 Volvo XC70

Not finding what you are looking for?
2007 Suzuki Grand Vitara 4WD Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides