Question about 2007 Mazda CX-7

Open Question

How do you program tpms sensor

Tpms tir pressure sensor

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Low tire pressure light stays on even though theres enough air in tires


That should be in your manual it should tell you how to reset it

Oct 14, 2016 | Cars & Trucks

2 Answers

Why is tire pressure fault light blinking?


Could be low air,two pound less may light blinking.

Dec 14, 2015 | Cars & Trucks

1 Answer

Tire Pressure Warning is on and yet the tires are full of air


Hello,
Maybe we can help.

Set your tire pressure to the recommended factory air pressures. (to find this look at the placard that is located in your driver side door jam.) After setting all 4 tires to the correct pressure drive normally. If the TPMS (Tire Pressure Monitoring System) light doesn't turn off within 24 hours have the TPMS sensors checked at a local wheel and tire retailer or at the dealer. TPMS sensors have batteries in them that last an average of 5-7 years. If one of the batteries is dead it will trigger the system.

FYI, all of our stores can quickly troubleshoot your TPMS system and we stock most replacement TPMS sensors if you end up needing a new one. To find a local Discount Tire near you please visit www.discounttire.com/.

Nov 26, 2013 | 2008 Mercury Mariner

2 Answers

2005 Tahoe, getting a tire presure sensor error. What powers the sensor?


Battery inside tire pressure sensor

Check all tire pressures INCLUDING
THE SPARE TIRE

Jul 31, 2011 | 2005 Chevrolet Tahoe

1 Answer

Service tire monitor on what is the problem? how do you reset the system?


TIRE PRESSURE MONITOR SYSTEM
The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. If your vehicle has this feature, sensors are mounted on each tire and wheel assembly, except the spare tire. The TPMS sensors monitor the air pressure in your vehicle's tires and transmit tire pressure readings to a receiver located in the vehicle.

The TPMS is designed to alert the driver, if a low tire pressure condition exists. This system also allows the driver to check tire pressure levels using the Driver Information Center (DIC).

When a low tire pressure condition is detected, the TPMS displays the "CHECK TIRE PRESSURE" warning message on the DIC, and at the same time illuminates the low tire pressure warning symbol.

You may notice, during cooler weather conditions, that the tire pressure monitor light, located on the instrument panel cluster, and the "CHECK TIRE PRESSURE" message will appear when the vehicle is first started and then turn off as you start to drive the vehicle. This could be an early indicator that the tire pressures are getting low and need to be inflated to the proper pressure.

Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tire inflation pressure label. (If your vehicle has tires of a different size than the size indicated on the vehicle placard or tire inflation pressure label, you should determine the proper inflation pressure for those tires.)

As an added safety feature, your vehicle has been equipped with a tire pressure monitoring system (TPMS) that illuminates a low tire pressure telltale when one or more of your tires is significantly under-inflated.

Accordingly, when the low tire pressure telltale illuminates, you should stop and check your tires as soon as possible, and inflate them to the proper pressure. Driving on a significantly under-inflated tire causes the tire to overheat and can lead to tire failure. Under-inflation also reduces fuel efficiency and tire tread life, and may affect the vehicle's handling and stopping ability.

Please note that the TPMS is not a substitute for proper tire maintenance, and it is the driver's responsibility to maintain correct tire pressure, even if under-inflation has not reached the level to trigger illumination of the TPMS low tire pressure telltale.

The "CHECK TIRE PRESSURE" warning message and low tire pressure light (telltale) will appear at each ignition cycle until the tires are inflated to the correct inflation pressure.

The Tire and Loading Information label (tire information placard) shows the size of your vehicle's original tires and the correct inflation pressure for your vehicle's tires when they are cold.

Your vehicle's TPMS can alert you about a low tire pressure condition but it does not replace normal tire maintenance.

NOTICE: Do not use a tire sealant if your vehicle has Tire Pressure Monitors. The liquid sealant can damage the tire pressure monitor sensors.

RESETTING THE TPMS IDENTIFICATION CODES
Each TPMS sensor has a unique identification code. Any time you rotate your vehicle's tires or replace one or more of the TPMS sensors, the identification codes will need to be matched to the new tire/wheel position. Each tire/wheel position is matched to a sensor, by increasing or decreasing the tire's air pressure. The sensors are matched to the tire/wheel positions in the following order: LF TIRE (left front tire on the driver's side of the vehicle), RF TIRE (right front tire on the passengers side of the vehicle), RR TIRE (right rear tire on the passengers side of the vehicle), and LR TIRE (left rear tire on the driver's side of the vehicle).

You will have one minute to match the first tire/wheel position, and five minutes overall to match all four tire/wheel positions. If it takes longer than one minute, to match the first tire and wheel, or more than five minutes to match all four tire and wheel positions the matching process stops and you will need to start over.

The TPMS sensor matching process is outlined below:
  1. Set the parking brake.
  2. Turn the ignition switch to "RUN" with the engine off.
  3. Turn the headlamp switch from "OFF" to the parking lamps setting four times within three seconds. A double horn chirp will sound and the TPMS low tire warning light will begin to flash. The double horn chirp and flashing TPMS warning light indicate that the TPMS matching process has started. The TPMS warning light should continue flashing throughout the matching procedure. The "SERVICE TIRE MONITOR" message will be displayed on the Driver Information Center (DIC).
  4. Start with the driver's side front tire.
  5. Remove the valve cap from the valve cap stem. Activate the TPMS sensor by increasing or decreasing the tire's air pressure for 10 seconds, then stop and listen for a single horn chirp. The single horn chirp should sound within 15 seconds, confirming that the sensor identification code has been matched to this tire and wheel position. If you do not hear the confirming single horn chirp, you will need to start over with Step 1. To let air-pressure out of a tire you can use the pointed end of the valve cap, a pencil-style air pressure gage or a key.
  6. Proceed to the passenger's side front tire, and repeat the procedure in Step 5.
  7. Proceed to the passenger's side rear tire, and repeat the procedure in Step 5.
  8. Proceed to the driver's side rear tire, and repeat the procedure in Step 5.
  9. After hearing the confirming horn chirp for the left rear tire, check to see if the TPMS warning light is still flashing. If it is, turn the ignition switch to LOCK to exit the sensor matching process. If the TPMS warning light is not flashing, the five minute time limit has passed and you will need to start the process over beginning with Step 1.
  10. Set all four tires to the recommended air pressure level as indicated on the Tire and Loading Information label.
  11. Put the valve caps back on the valve stems. The spare tire does not have a TPMS sensor. If you replace one of the road tires with the spare, the "CHECK TIRE PRESSURE" message will be displayed on the DIC screen. This message should go off once you re-install the road tire containing the TPMS sensor. The "SERVICE TIRE MONITOR" message is displayed when the TPMS is malfunctioning. One or more missing or inoperable TPMS sensors will cause the service tire monitor message to be displayed.

Nov 23, 2010 | 2006 GMC Yukon

2 Answers

2007 yukon tpms keeps blinking to check tire pressure


The TPMS is a pain in the you know what. Have you changed tire sizes? There could be a bad sensor and may need replaced. We continually get problems all the time with the TPMS. We have reset then they reset again.

Sep 11, 2009 | 2004 GMC Yukon

3 Answers

Where is the low tire reset button located on 2005 ford freestar?


It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.

Mar 28, 2009 | 2005 Ford Freestar

6 Answers

Lexus sc430 tire pressure monitor


there is a reset button for the tpms either just above the accerlator or to the right of the glove box. press it and tah dah....you should be good to go.

Feb 08, 2009 | 2002 Lexus SC 430

1 Answer

TPMS


the TPMS stands for Tire Pressure Monitoring System,it will come on if the tire pressure becomes too low (or too high) check to see if the tire pressure is correct and if it is there may be a faulty pressure sensor

Oct 14, 2008 | 2005 Honda Pilot

2 Answers

TPMS on 2006 Chevy Impala


I have an 05 impala and there is a setting in the Radio to reset the oil life and TPMS system, I'd look in the owners manual to see how to access this feature on the 06 but it should be there.

Oct 03, 2008 | 2006 Chevrolet Impala

Not finding what you are looking for?
2007 Mazda CX-7 Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...