Question about 2007 Peugeot 307 1.4

Open Question

Abs sensor faulty

Sensor problem front

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Freelander abs


Sounds like the RF speed sensor is bad, normally you can set a multimeter to ohms and put it on the disconnected wheel sensor and see if you get a reading off the sensor. If you do, then the sensor is ok, and may be the ring on the drive shaft.
I would swap the sensor out and reset the codes.

Jun 17, 2013 | Cars & Trucks

1 Answer

Code B0100


Hi there:
DTC B0100 - Electronic Front End Sensor 1 Performance

The following can cause an intermittent condition:
  • A short between the front end sensor signal and low reference circuits
  • High or low resistance in the front end sensor signal and low reference circuits
  • Inspect the front end sensor signal and low reference circuits carefully for cutting and/or chafing
  • Verify that the correct front end sensor is installed in the vehicle


Hope helps.

Jun 03, 2013 | 2006 Pontiac Torrent

1 Answer

P0131 sabb 93 2001 po121 error codes


P0131 - O2 Sensor Circuit Low Voltage Bank 1 Sensor 1 (sensor is before the catalytic converter)

Possible causes- Front Heated Oxygen Sensor Bank 1 harness is open or shorted
- Front Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Front Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
P0132 - O2 Sensor Circuit High Voltage Bank 1 Sensor 1
Possible causes- Front Heated Oxygen Sensor Bank 1 harness is open or shorted
- Front Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Front Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks

I am not really sure what is going on here with the same O2 sensor giving these lean and rich codes, if nothing else is apparent and the engine runs well you may have a defective O2 sensor.

Sep 13, 2012 | Saab 9 3 Cars & Trucks

1 Answer

Front o2 sensor is needing to be replaced


The front sensor should be in front of the catalytic converter.

Jul 06, 2012 | 2006 Ford Focus

1 Answer

What is p1148


P1148 - Closed Loop Control Function Bank 1
This mean that the closed loop control function for bank 1 does not operate even when vehicle is driving in the specified condition.

The Powertrain Control Module (PCM) or Electronic Control Module(ECM) monitor the function of the Front Oxygen (O2) sensor or Air/Fuel (A/F) sensor by comparing the signal with the Rear O2 sensor.

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes:
- Harness or connectors Front Oxygen (O2) sensor or Air/Fuel (A/F) sensor 1 circuit is open or shorted.
- Front Oxygen (O2) sensor or Air/Fuel (A/F) sensor bank 1
- Front Oxygen (O2) sensor or Air/Fuel (A/F) sensor bank 1 heater

Possible solution:
- Repair harness or connector. If repair is needed
- Replaced Front Oxygen (O2) sensor or Air/Fuel (A/F) sensor bank 1


Then, possible causes are faulty harness or connectors to the air fuel ratio sensor, a faulty air fuel ratio sensor (1) or faulty air fuel ratio sensor (1) heater. Most likely yes it is just faulty sensor. Just replace this devices and reset the stored codes.

Keep us updated.

Feb 10, 2011 | 2005 Nissan Altima

1 Answer

I need a diagram of the exhaust system on a Mazda 626


0996b43f80203328.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart-2000 MPV

1 PCM 2 Mass air flow (MAF)/intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Fuel tank pressure sensor 5 Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) (front, RH) 11 Heated oxygen sensor (HO2S) (rear, LH) 12 Heated oxygen sensor (HO2S) (rear, RH) 13 EGR boost sensor 14 Power steering pressure (PSP) switch 15 Main relay


0996b43f8020330c.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart-2001 MPV

1 PCM 2 Mass air flow (MAF)/Intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Engine coolant temperature (ECT) sensor 5 Crankshaft position (CKP) sensor 6 Camshaft position (CMP) sensor 7 Knock sensor 8 Heated oxygen sensor (HO2S) (front, LH) 9 Heated oxygen sensor (HO2S) (front, RH) 10 Heated oxygen sensor (HO2S) (rear, LH)* 11 Heated oxygen sensor (HO2S) (rear, RH)* 12 EGR boost sensor


0996b43f8020330f.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart- 2002-06 MPV

May 22, 2010 | 2004 Mazda MPV

3 Answers

Were on exaust is oxygen sensor in 1999 subaru impreza auto sport


On the SOHC engine the front (A/F) oxygen sensor is located in the front section of the front catalytic converter. The rear oxygen sensor is located in the rear section of the front catalytic converter. On the DOHC engine the front oxygen sensor is located in the front section of the exhaust system, just past the crossover pipe. The rear oxygen sensor is located in the front section of the catalytic converter.

Oxygen sensor location-Baja 2.5L SOHC engine
c3fce0b.jpg

Oxygen sensor location-Baja 2.5L DOHC engine
7aac75e.jpg


On the 2.0L engine the front (A/F) oxygen sensor is located in the front section of the exhaust system, just past the crossover pipe. The rear oxygen sensor is located in the front section of the rear catalytic converter. On the 2.2L engine the front (A/F) oxygen sensor is located in the front section of the front catalytic converter. The rear oxygen sensor is located in the rear section of the rear catalytic converter.

Oxygen sensor location-Impreza 1998-2001 2.2L engine
a5973e4.jpg


moz-screenshot.pngOxygen sensor location-Impreza 1998-2002 2.5L SOHC engine
3a84717.jpg
I hope helped with this; remember rated this help. Good luck.

Nov 20, 2009 | 1999 Subaru Impreza

2 Answers

Code p0133 on 2004 deawoo matiz please is it the oxy sensor and if so front or rear one thank you


O2 Sensor Circuit Slow Response Bank 1 Sensor 1
this is the sensor that is located in the exhaust just off the engine and before the cat converter, so it is the front sensor.

Oct 20, 2009 | 2002 Daewoo Nubira

1 Answer

Crank sensor


CRANKSHAFT POSITION SENSOR - 3.9 - 5.2 - 5.9L ENGINES
REMOVAL

The sensor is bolted to the top of the cylinder block near the rear of right cylinder head

Note: The sensor is accessed by removing the right front fender liner

Remove right front tire and right front wheelhouse liner.
Disconnect crankshaft position sensor pigtail harness from main wiring harness.
Remove two sensor (recessed hex head) mounting bolts on the Crankshaft Position Sensor
Remove sensor from engine.

INSTALLATION
Position crankshaft position sensor to engine.
Install mounting bolts and tighten to 8 N·m (70 in. lbs.) torque.
Connect main harness electrical connector to sensor.
Install right front tire and right front wheelhouse liner.

Feb 07, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
2007 Peugeot 307 1.4 Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...