Question about 2000 Saab 9-3 Viggen

1 Answer

Saab ignition problem

Hello to everybody, I have a Saab 95 MY1998 and It all of a sudden started not starting. it turns over perfect but it just won't start. the engin rolls over but won't start. The car has this problem only when the engine is warm. I have to wait half an hour, then start perfectly...

Luca

Thank

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 314 Answers

It is definately the main relay. if you replace the relay then you will fix the problem. Over time the circuit board cracks and causes it to go bad.

Posted on Jun 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What makes a 1999 Saab from running great, to a sudden stop?


fuel pump relay or pump or may have immobilizer activated.

Mar 19, 2014 | 1999 Saab 9-3

1 Answer

My1998 explorer just quit it won't start i got new


The 98 explorer is equipped with a power surge system to protect internal vehicle wiring, what this means is that if there is a short in the vehicles wiring the alternator will disengage. A way to tell if it is faulty wiring is to pull all the fuses out of the fuse block and try to start it if the engine turns over the problem is internal wiring. If not then you have to put all the fuses back.

Jan 31, 2013 | Cars & Trucks

1 Answer

My remote didn't open doors, on my1998 Saab 900S, so I used key to unlock manually. The alarm went off, and car won't start. When I open the door the anti theft alarm goes off again. This is E


Replace the battery in the remote, then reset the system.

Resetting a Vehicle Anti-Theft System
This is how you reset an anti theft system if you have the anti-theft light on, or your car is cranking, but you have no spark.

Doing a full reset of the anti-theft system.

Disconnect both battery leads for at least two hours.
Hold the negative and positive leads together for 5 minutes to fully discharge any power.
Put the key in the ignition, but not turned on. VERY IMPORTANT!
Connect the positive lead.
Connect the negative lead in one swift movement.
Wait 15 minutes for the system to fully reset.
Resetting Vehicle Anti Theft System

Mar 06, 2018 | 1998 Saab 900 S

1 Answer

Our saab 2002 95 is not starting and only starts when gasoline is insterted under the hood


Hello and welcome to FixYa!

So the car only starts with starting fluid, is that it? If that's the case then the problem can be on your fuel pump. If the fuel pump is faulty it won't sip fuel from the tank to the engine. If that's the case, you will need to have it replaced.

Hope this helps and thank you for using FixYa! Have a good one!

May 02, 2011 | 2002 Saab 9-5

2 Answers

Car won't start. It turns, but doesn't start.


If you tolk about camshaft position sensor-YES.Located on a back side of the engine , next to the gear box.Have metal cover .Use diagnostic equipment to find the problem or code reader.I also had the same problem in my SAAB 95.In 6 monts time I have change two sensors.Made in China

Apr 28, 2010 | 1999 Saab 9-5

1 Answer

My saab wont start


Hello,1ºdesmount ignition coil and check if smeel burned,if coil is ok 2ºturn on ignition and listen if fuel pump is working(lift up back seat to listen better) or can be cranckshaft sensor(check with multimeter on OHM)

Feb 22, 2009 | 2000 Saab 9-3 Viggen

3 Answers

Saab 95 1998 - wont start


The most common problem is the Direct ignition cassette, followed by the crankshaft position sensor. I am assuming that it cranks, but won't start.

Dec 26, 2008 | 1999 Saab 9-5

1 Answer

Ignition switch on my 1987 Saab 900i


You may need to remove the ignition housing assembly to find out whats wrong inside. There are a series of small gears which connect the ignition barrel to the ignition switch & also operate the reverse gear lock mechanism. You'll need a special 3 pronged tool to remove the assembly - available from SAAB dealers.

Jul 13, 2008 | 1987 Saab 900

Not finding what you are looking for?
2000 Saab 9-3 Viggen Logo

Related Topics:

560 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Marvin
Marvin

Level 3 Expert

81294 Answers

derek oliveira

Level 2 Expert

85 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...