Question about 1995 GMC Sonoma

1 Answer

What would it cost a mechanic to install motor mounts on a 1995 gmc sonoma 4.3 litre 4*4

What would it cost a mechanic to install motor mounts on a 1995 gmc sonoma 4.3 litre 4*4 ,I dont have a cherry picker

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Welcome Back:

    Visited the website for 2 consecutive days.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Im sure your 95 is no different then my 01 sonoma 4x4 u shouldn't need a cherry picker to do the engine mounts a small block of wood and a floor jack to support the engine from underneath and take a little bit of the load off the mount should work you dont have to lift the engine out to do them its not easy this way but is possible and cost less money working for a gm parts department and a former tech you would be spending and average of 75 to 100 an hour labor wise depending on what shop u take it to and what shop labor rates at like near you I would estimate an easy 2 hours labor but it all goes by book time thats or determined at the shops

Posted on Mar 28, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 1995 gmc sonoma ignition key worn out

You have to remove the stering colum covers and in the ingnition key drum on the side there is a little hole, press the inside pin and pull the key ccylinder out, you can buy on autozone or pep boys.

Posted on Jul 18, 2009

ZJLimited
  • 17970 Answers

SOURCE: how do I install starter for 2000 GMC Sonoma

e
Removal & Installation
2-Wheel Drive
- 2.2L Engine

  1. Remove or disconnect the following:
    Negative battery cable Front exhaust pipe, if necessary for access Starter heat shield, if equipped Brace rod from the front of the engine and the bell housing Drivers side wheel to access the starter motor wires and the starter motor attaching bracket-to-engine bolt through the opening in the wheel well Wires from the starter solenoid Attaching bracket-to-engine mount bolt Starter-to-engine block bolts. When removing the last bolt, be sure to support the starter to keep it from falling and possibly injuring you. Starter and shims (if equipped) from the vehicle Bracket from the starter assembly, if equipped

    e12f2d1.jpg

    Fig. Starter motor and related components - 2.2L engine

To install:
  1. Install or connect the following:
    Bracket to the starter, if removed. Tighten the bracket nuts to 97 inch lbs. (11 Nm). Starter and shims (if equipped) into position in the vehicle and thread one of the retaining bolts to hold it in position. Bracket-to-engine mount bolt (loosely), if equipped Starter mounting bolt, then tighten all mounting fasteners to 32 ft. lbs. (43 Nm) Wiring to the solenoid Brace rod and tighten the retainers Front exhaust pipe and tighten the fasteners, if removed Starter heat shield, if equipped Driver-s side wheel, if removed Negative battery cable

Hope helped with this (remember rated this help) Good luck.

Posted on Nov 18, 2009

ftw1952
  • 10319 Answers

SOURCE: 1995 GMC Sonoma ideals a little rough like it is

as time goes on yes so the idle speed control is wearing out

Posted on Mar 03, 2010

SOURCE: how to change motor mount

You will need an engine hoist, jack stands, jack. ratchet set, and new engine mounts. Jack up the front end of the Sonoma with a floor jack and rest the front end on a pair of jack stands. Open the Sonoma's hood. Connect the engine hoist to the front-right and left side of the engine. Slide under the front end of the Sonoma and locate the right and left motor mounts. Remove the bolt that is securing the mounts in place using the ratchet set. Raise the engine using the engine hoist enough to take the weight off of the engine mounts. Pull the engine mounts off of the frame. Slide the new motor mounts into there fittings. Lower the engine onto the engine mounts. Make sure that the holes in the frame, mounts and engine all line up with each other. Replace the securing bolts to the mounts. Tighten the securing bolts using the ratchet set. Disconnect the engine hoist from the engine and close the hood. Use the jack to lift the front end and remove the jack stands. Lower the front end to the ground.

Posted on Nov 21, 2010

vetteman3002
  • 2299 Answers

SOURCE: 1995 GMC Sonoma - blower motor works

There is a relay under the dash on the passenger side that operates the fan. You can bump the dash on the under side passenger side. And the fan should come on. If so the relay needs replaced.

Posted on Dec 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will i have to remove motor to replace oil pan gasket on a 2001 gmc sonoma 2.2l 5 speed


You may have to loosen the transmission also to get enough room to remove it without taking the motor out. Make sure your pan is not cracked first. Also be careful when lifting the motor as to not damage anything on top of the engine.

Nov 29, 2015 | GMC Cars & Trucks

1 Answer

How many quarts does a 2.5 liter 4 cylinder GM motor hold


Whats a quart please ,i would imagine that this engine holds about 4.5 litres with a oil filter.

Aug 07, 2014 | 1992 GMC Sonoma

1 Answer

Motor mount


put a jack under motor to support the motor then replace. Might want to put a 2x4 and some rags or blanket between motor and jack to prevent damage

Mar 27, 2014 | 1995 GMC Sonoma

1 Answer

Is my 1995 GMC Sonoma 4x4 a half ton truck


small trucks like that are considered 1/4 ton. silverado 1500 1/2 ton an silverado 2500 3/4 and up. same goes for gmc

Apr 06, 2013 | 1995 GMC Sonoma

1 Answer

Where is the ignition module on a 1995 gmc sonoma


It is in the distributor under the cap and rotor.

Sep 01, 2012 | 1995 GMC Sonoma

1 Answer

I have a 1999 gmc sonoma 4cyl 2.2l. While driving on the freeway it looks like my truck turns off for a split second. All the lights in the dash and all the guages reset as if starting the truck for first...


Your friend could be right, bad grounds can cause all kinds of electrical problems. Chech battery to motor and battery to body ground. Also check motor to body ground strap for corrosion under mounting bolts. It may not be visble until you remove the bolt. Good luck

Sep 06, 2010 | 1999 GMC Sonoma

1 Answer

Cannot find fuel filter on my gmc sonoma 1995 4


On my 1996 it is mounted near the inside of the left frame rail just behind the drivers door. Hope that helps.

Jul 26, 2010 | 1995 GMC Sonoma

1 Answer

I JUST NEED A DIAGRAM OF THE SPARK PLUG FIRING ORDER ON A 1995 GMC SONOMA. GOD.


1995 GMC S15/T15 Sonoma P/U 2WD 2.2 liter L4 VIN "4"

fe2eb79.gif



1995 GMC S15/T15 Sonoma P/U 2WD 4.3 liter V-6 VIN "Z"

fd99af5.gif



1995 GMC S15/T15 Sonoma P/U 4WD 4.3 liter V-6 VIN "W"

38d92c6.gif

Hope help with this (remember rated and comment this).

Mar 28, 2010 | 1995 GMC Sonoma

1 Answer

Oil pressuse dropson 1995 on sonoma pickup gm truck


how many miles on the truck ? when was last oil change what weight oil do you use ?

hope 2 help shack

Apr 15, 2009 | 1995 GMC Sonoma

Not finding what you are looking for?
1995 GMC Sonoma Logo

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...