Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.
The ohter is under the dash and above the pedals, this one is much tougher to access.
Your Owner's Manual should tell you where the fuses are that you need to access.
Posted on Oct 20, 2008
There's a lever that connects the driver-side rear shock to the Automatic Level Control module (the air compressor and the ride-height sensor). Disconnect the lever from the shock and rotate it up and hold it. The compressor should kick in when you hold in place after a few seconds. If it doesn't kick in, make sure your fuses and relays are good. Otherwise, you may have a failed ALC module/burned out air compressor (from the shocks being shot). After you replace the shocks (and after you recouped from the heart attack you had when you shelled out $500+ for each shock), replace the ALC module/compressor (it's all one unit), and test it - it should kick on when you rotate the lever up again.
Figure about $350 for the ALC module from your dealer, and make sure the part numbers match! Your truck came with an upgraded ALC module from the 2001-2004 module, which were prone to water damage.
Posted on Dec 30, 2008
At the bottom of your transmission there is a large square/rectangular pan (depends which trans you have). Have a large drain pan to catch 5 to 9 liters/quarts of transmission fluid. Undo all of the retainer bolts and carefully lower the pan (this can get messy for the unexperienced) .
In some cases the rear transmission mount may need to be undone and the rear of the trans lifted to allow clearance for the pan to be slid past the crossmember.
Replace the trans filter too!
Posted on Oct 31, 2009
There is no p01001, it's either p0100, or p0101.
Anyway, it's the mass air flow sensor that's bad. The p0171 and p0174 is a lean condition on bank 1 and bank 2, which are the oxygen sensors. Change the mass air flow sensor and that should take care of the p0171 and 74 codes.
The mass air flow sensor can cause the 02 sensors to read lean.
The u1301, is a class 2 circuit short to battery. That, you have to test wires to find with a voltmeter/continuity tester.
I would try and find that short before changing the flow sensor, you don't need the new one shorting out, they are not that cheap.
Posted on Nov 17, 2009
Tips for a great answer:
Jun 17, 2014 | 2006 GMC Yukon Denali
May 05, 2014 | 2008 GMC Yukon Denali
Apr 17, 2014 | 2007 GMC Yukon Denali
Jun 12, 2011 | 2004 GMC Sierra Denali
Jan 13, 2010 | 2003 GMC Yukon Denali
Aug 05, 2009 | 2006 GMC Yukon Denali
Jul 25, 2009 | 2006 GMC Yukon Denali
Jun 15, 2008 | 2004 GMC Yukon
15 people viewed this question
Usually answered in minutes!