Changed Break pads now service break light is now on
SOURCE: brakes
Most likely your vacumn power brake booster has failed. It is not rebuildable. You will need to buy a new one.
SOURCE: Parking break light is on & Chimming When P. Break is released
On your parking brake assembly is a single wire switch. You can unplug it, but you will have to remember not to drive with it set. To replace the switch the whole assembly will have to come out. The switch is about $20 and labor should run about two hours. Good Luck
SOURCE: Rear disc brakes drag after installing new pads
Just did my rear brakes this weekend, Monday had a very slight drag. Noted that when I installed new pads I had to tap them on. That shouldn't be. When brakes are released, there should be enough play to allow the pads to back off the disc. Tonight, I removed the pads and filed down the ends of the tips that go into the top and bottom channels until I could install and remove them with fingertips, that gives them enough play to grab and release. Drag disappeared; the old girl ran like she should.
SOURCE: 1999 chevy Lumina's break lights
I have a solution for you and it is your turn signal switch. I replaced mine and all of the lights work now. It is a pain to put in since you have to take off the steering wheel to replace ti but it will work after that. The switch is less than sixty dollars but ti will save you from getting a ticket
SOURCE: I have a '06 Chevrolet
You can reset the computer by turning the key to the on position. Don't start the engine. Press the gas pedal to the floor and release it all the way. Press all the way to the floor and release. Press all the way to the floor and release. After the third time it will reset the computer.
PLEASE RATE! Check the 4 thumbs up.
Thanks! Have a GREAT DAY!
59 views
Usually answered in minutes!
×