Question about 2004 Chrysler Sebring

1 Answer

Headlights and wipers do not work

Every thing works but the headlights ad wipers. Is there a fuse that needs to be changed. And if so. Where is that fuse located

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 3,679 Answers

Most likely to be a fuse follow this link may help
How to Replace the Fuses in Chrysler Sebring eHow

Posted on Mar 27, 2014


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 36 Answers

SOURCE: wipers stopped working, changed motor, control arm and fuses, wipers still not working, changed to other fuses and now car wont go past first gear, before i change the fuse it was driving fine now my

It is almost a sure thing that you have put a lower amperage fuse in a higher amperage socket.
To verify, look at the fuse box cover, it usually has a legend of what fuse goes where, and what the amperage is.
Make sure that you put 15A fuses in 15A slots etc.
Also make sure that the fuses are not burned out, look for the little piece of metal that make the connection, and make sure its intact.

Posted on Jan 07, 2014

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My high beams and front and rear wiper washer fluid dont work i replaced combo switch and still same problem but wipers and turn signals work

Have you checked all of the fuses for power ?
The headlights have fuses in addition to the main headlight fuse.
Same thing with the washer pump.

Mar 08, 2016 | 1999 Ford Explorer

1 Answer

What would cause the headlight to go out and then powersteeering and windshiels wipers.

easiest thing to check is your fuses. The signal light system may have a short in it and it may have caused some of your fuses to blow.

Feb 14, 2016 | Cars & Trucks

1 Answer

Have an 04 PT cruiser with 31,000 miles will not crank headlights do not work tomorrow does not work radio works Wiper works

Hi Jeff, Im AL the owner of Big As Auto Repair.
Jeff, the first thing you need to do is make sure the battery has a full charge. If it does have a full charge. The next thing is to check every fuse in the fuse box. If all the fuses are good. The next thing to do is make sure you have power at the starter with the key in the run position. Hope this help and please visit my auto-repair-website here:

Feb 03, 2016 | Cars & Trucks

2 Answers

Why don't the headlights, turn signals, and wipers work?

Check fuses. Replace the turn signal switch for the head lights. If the wiper fuse is good, Replace the turn signal switch first, then go after the wiper motor. Both run threw the turn signal switch.

Apr 03, 2015 | 1998 Volkswagen Beetle

1 Answer

Ford ranger 2003 short in truck

Inspect the fuse box assembly carefully looking for oily wetness from behind . If it is wet, its brake fluid that has permeated thru the pressure switch , into the wiring and saturated the fuse box assembly causing the short. The repair is to replace the brake master pressure switch with an updated part that comes with a new pigtail harness and a complete fuse box assembly from Ford that comes with all the fuses needed, just "plug and play". Also as an added precaution, you should isolate the wires that carried the brake fluid, strip off about an inch of insulation, solder the exposed area and re-tape exposed repair area.

Feb 22, 2014 | 2000 Ford Ranger SuperCab

1 Answer

Headlights and turn signals do not work. Wipers stay on.

I'm going to say you blew a major fuse or fuseable link wire you have not found yet.
The wipers need power from a battery source to stop, the headlights probably are on a battery circuit too. The turn signals would go thru the key switch but the hazard flashers would be also be direct battery.
You may need a wiring diagram (book) to find all of the fuses and circuits.

Jul 01, 2012 | Nissan Pickup Cars & Trucks

2 Answers


Just saw your post as I was having the same problem. The fuse that you need to look at is #37. I changed that fuse and everything was all good. Apparently the headlight washer pop-ups can freeze up in cold weather and blow the fuse.

Dec 19, 2010 | Audi A4 Cars & Trucks

1 Answer

I have a 1991 dodge stealth r/t 5 speed. theres a few things that i need help with. Headlights wont pop up or turn on at all. They popped up once when i had the light knob turned all the way forward and i...

The headlights must have a vacuum hose unhooked, or they are catching on something. Can you crank them up by hand? Your lighter wipers and cruise is probably a fuse problem, or two or three fuses. Are the headlights powered by vacuum or electricity? Let me know.

Aug 11, 2009 | 1991 Dodge Stealth

1 Answer

My headlights,windshield wipers, and turn signals wont work

check all your fuses. replace any and all bad ones. if fuse blows again u have a short somewher

Jul 02, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2004 Chrysler Sebring Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides