Question about 2006 Subaru Impreza 2.5i

1 Answer

Need to know how to connect the two wires socket in the back of my 2006 subaru impreza with manual transmission now i have a blinking check engine light

Cant find the place to connect the two wires socket in the back of the dash board ,the wire is add to the stereo harness and a ground wire connection to the stereo ,now I have a check engine light on

Posted by on

  • leodj
    leodj Mar 27, 2014

    i kwnow i did it already but i stil have the second conector loose and this is probably the reason to the check engine light on

  • leodj
    leodj Mar 27, 2014

    Add a Comment because this connector was unplug there was no check engine light on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Subaru Master
  • 3,679 Answers

Usually unplug wiring fromradio and plug one end of new harness into radio and the other into the original radio connector

Posted on Mar 27, 2014

  • steve Mar 28, 2014

    i've got you now ,the extra connector must be for an accessory ie car phone ,electric aerial ,it really should make any difference whether connected or not.Have you had tha OBD read might just need the code,if there is one, clearing,i'd try that before anything else as CEL codes can stay in memory until cleared .hope this is of helpf,


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: subaru impreza automatic transmission won t shift

Try replacing the transmission filter and the trannie fluid. Mine would only go in reverse, and now it drives pretty well. This year has a screw on filter. Hope this helps

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: wiring loom diagram for subaru 97 sti & 00 ra ?

can any1 help me as my interior light not workin with doors when i use door settings get nothing till i close the doors and it comes on dull

Posted on Sep 20, 2009

  • 3 Answers

SOURCE: Tow bar trailer socket wiring connection point to car wiring?

The connectors for towing wire harnesses on foresters are generally on the passenger side, below the rear taillight inside the cargo space. some require pulling up the foam block that is between the spare tire compartment and the taillight. Check where you replace the tailights from inside the car, if there isn't a matching connector hanging out there, check around the spare tire compartment, see if you can remove the carpeted foam block next to the compartment and find the plug under there.

Posted on Mar 03, 2010

  • 608 Answers

SOURCE: wiring diagram for a subaru impreza

There is no full wiring diadram for this model. All the schematics are divided into the various electrical systems on the car. There are around 50 charts to make up the set. Perhaps if you let me know what system you are interested in, I may be able to help.

Posted on Apr 01, 2010

  • 17970 Answers

SOURCE: 2006 subaru impreza wrx. has a p2096 code. what

This is Subaru's definition for this code... DTC P2096 POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1; check this diagram about muffler assembly...


Posted on Oct 09, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Manual transmission. What are the probable causes of DTC P0851?

code p 0851 refers to park/neutral switch (PNP)--input circuit low===causes ---wiring---short to ground---PNP switch---ECM/TCM
with the manual transmission there may be a pnp switch that prevents an engine start unless it is in neutral and in some scars the foot brake also has to be applied
check /replace the neutral switch and check the wiring and connections for corrosion

Nov 24, 2015 | 2005 Subaru Impreza 1.6

1 Answer

What year manual transmission fits to a 2004 Subaru Impreza WRX?

Pretty much any "EJ" transmission will fit any "EJ" engine, the only problems are whether the clutch is a pull or push type release bearing? That will also make a difference how the clutch slave cylinder mounts up. If it isn't a turbo model trans, it will not take the HP that the engine puts out for very long. The Impreza STI manual trans will bolt up, but there will be some exhaust fitment issues where the down pipe bracket connects to the trans.

Sep 09, 2014 | 2004 Subaru Impreza

1 Answer

I have 1993 Subaru impreza and I don't have transmission light and have a check engine :(

some time is the oxygen sensor .make sure put on computer first

Sep 03, 2012 | Cars & Trucks

1 Answer

2006 subaru impreza wrx. has a p2096 code. what does it indicate? also is there a way i can clear a check engine light?

This is Subaru's definition for this code... DTC P2096 POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1; check this diagram about muffler assembly...


Oct 09, 2011 | 2006 Subaru Impreza

1 Answer

Wiring diagram subaru impreza ej15 - gc1 -

For the 2.2 1997 Subaru Impreza:
Firing Order:

(back of engine)
_____ ....._____
(front of engine)

Ignition Connections:

Let me know if this helped, or if you have any additional information or questions. Feel Free to contact me at!

Feb 26, 2010 | 1997 Subaru Impreza

2 Answers

Engine light blinks on 1995 Model, already replaced spark plugs and wires

you need to connect the data link connectors underneath the steering wheel, then turn ignition on and count the flashes that the engine management light blinks..Post back

Aug 13, 2009 | 1995 Subaru Impreza

1 Answer

I have a 2006 impreza rs , the car started

the check engine flashing means the engine is misfiring and can cause catalyst damage ,have it looked at right away,lots of problems with ignition coils and ignition wires causing misfires

Aug 10, 2009 | 2006 Subaru Impreza

Not finding what you are looking for?
2006 Subaru Impreza 2.5i Logo

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides