Question about 2013 Buick Verano

Open Question

Oil light on

Just trying to reset it

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oldsmobile intrigue oil light reset how to m?


The oil light comes on when oil pressure is too low. Oil level too low or defective oil pump in the engine. But the most common problem is a defective oil pressure sending unit sensor on the engine. The only way to reset the oil light, is by fixing the problem. There is no reset button.

May 22, 2014 | Cars & Trucks

1 Answer

How to get change oil light to go off


Instructions:1) Check the oil. The light is a warning signal that you are low on oil or that the oil is not flowing properly. If the oil level is fine then the issue may be a reset button. Two different methods will allow you to reset the oil light.2) Turn the key to the on position. Do not turn the engine on. Press the accelerator pedal down three times in a five-second period. Turn the engine on. If the oil light goes off you have successfully reset the oil light. If it stays on you need to try the second method.3) Find the fuse box. This should be under the dash in between the steering wheel and the door. Open the fuse box and look for the reset button. Press the button until you hearing a beeping sound. It will beep three times. The oil light should be reset. Turn the engine and see if the oil light goes off. If the oil light stays it still has not been successfully reset.
4) Read the manual. The two methods above are the two most common ways of resetting the oil light. Your car may have additional options to try. If none of the methods resets the oil light then there is a different problem such as a non-functioning oil sensor. At this point you need to see a mechanic.

Parts Of BMW.


May 30, 2012 | 2005 Dodge Magnum

2 Answers

How do i reset the oil change light in a 2003 olds alero


turn key on (dont start engine) floor gas pedal 3 times 1,2,3. turn key off, now start engine it should go off, if not try it again.

Aug 03, 2011 | 2003 Oldsmobile Alero

3 Answers

I had the oil changed but the change oil light is still on, how do i reset the computer? 2000 oldsmobile alero


How to Reset the Change Oil Light

After changing the engine oil, the system must be reset.

With the ignition key to ON, push the RESET button

located in the driver's side instrument panel fuse block. The

CHANGE OIL light will start to flash, press and hold the

RESET button again. The reset is complete when you hear
the chimes sound and the CHANGE OIL light goes out.

Oct 25, 2010 | 2000 Oldsmobile Alero

3 Answers

How to reset check engine light and change oil soon light


You should not reset the ck eng light until you have repaired the problem. Its just going to come on again, unhooking the battery MAY reset it. To reset the change oil light, turn the key on and floor the gas pedal 3 times, that should reset the light.

Nov 11, 2009 | 2005 Buick Century

2 Answers

How do i reset my oil light? my husband changed


TURN THE IGNITION KEY TO RUN WITH THE ENGINE OFF.FULLY PRESS AND RELEASE THE ACCELERATOR PEDAL THREE TIMES WITH IN FIVE SECONDS.YOU HAVE TO DO THIS MORE THAN ONE TIME.ITS NOT GOING TO RESET FIRST TRY BUT DO THIS PROCEDURE.UNTIL THE CHANGE ENGINE OIL LIGHT WILL FLASH WHILE THE SYSTEM IS RESETTING.TURN THE KEY TO OFF.WAIT A FEW SECONDS.START CAR UP TO SEE IF CHANGE OIL LIGHT COME BACK ON.IF YES YOU HAVE TO TRY THE RESET PROCEDURE AGAIN.

Sep 26, 2009 | 2006 Chevrolet Equinox

2 Answers

How it reset service engine light


Is it the "oil change req." light? Your owners manual will have the process for reseting the oil change light.
If it is "service engine soon" light, the vehicle will need to be scanned with a professional scanner.

Jun 20, 2009 | 1996 Dodge Caravan

2 Answers

After an oil change the change oil light remains on


Press the setup button until "press reset at oil change" is displayed.
Then press and Release reset button until "hold reset to confirm" is displayed.
Now press and Hold reset button until "oil life set to 100%" is displayed.

Apr 13, 2009 | 2005 Ford Five Hundred

1 Answer

How do I reset the oil change light in a 2008 Chevy Suburban


Try this: turn the key to the RUN position (don't start it), press the accelerator to the floor 3 times within 5 seconds. The oil life light should flash twice, indicating that it's been reset.

If you have steering wheel controls, you can navigate to where it says Oil Life and then hold the arrow down, that should also reset the oil life.

Mar 30, 2009 | 2008 Chevrolet Suburban

Not finding what you are looking for?
2013 Buick Verano Logo

Related Topics:

10 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...