Question about 2013 Ford Ford Focus ST

Open Question

Remove rear passenger carpet on Ford Focus Hatchback

How do you remove plastic latch pins from rear cup holders?

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ford focus 1998 seat belt

hi mate just pull at cushions forward and bck forward undo the 4 screws from theluggage side trim unclip the cover on seat belt then undo mounting bracket thats what i done i hope it helps.

Posted on Oct 24, 2008

  • 1986 Answers

SOURCE: How do you remove the rear light cover in order to

Open the hatch and look to the side of the housing, there should be a tab sticking out of the side of the assembly with a screw securing it in place (It's between the trim seal and the assembly). Then in the inside of the hatch, look up to where the assembly would be, and there should be a long cylindrical nut (it's made of plastic and will have a metal center for the threads). Remove this and then you can pull the entire assembly off. You won't have a lot of room though because the wires are relatively short.

Posted on Oct 19, 2009

  • 634 Answers

SOURCE: Ford Focus 2006 Hatchback How to remove Rear wiper motor.

I would suggest getting a chilton or hayes repair manual for about $25-30 dollars online or store with pictures, illustrations and directions. too much information to simply post and the ministrations will greatly help you, by the way did you check the fuses first and test the wiper power wire to see if the motor is getting power when switched on?

Posted on Jun 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove center console 2006 ford focus


remove the cup holder and then the screws there will be 2 screws at front area of console lid,there will be nuts at rear of console towards the end ,then put gear shift in into 2or 1 pull up on ebrake handle should come up if not there maybe some bolts or nuts inside console also ,good luck

Feb 28, 2015 | 2006 Ford Focus

1 Answer

How do you replace drive indecator light


1. Lift the little carpet in the console rear to the automatic gear shift. Pry with a small flat screwdriver will do the job.2. Remove the three Philips head screws.3. Remove one Philips head screws on each side of the rear console, they are located at the bottom front of the rear console panel. You may have to move the driver and passenger seat back to see the screws.4. Grab the back of the rear console and gently wiggle, pull backward and lift upward. Pull the hand brake so it is easier to remove the loosened rear console panel. 5. Use a flat head screwdriver to pry the rectangular 'cushion' around the automatic gear shift. Gently pry at various spot and the rectangular 'cushion' will come off easily.6. Now you are just one more plastic cover away from the burned bulb. The plastic cover that has those 'P'ark, 'R'everse, 'D'rive letters is held in place by four snap on latches. Use a small flat head screwdriver and gently push the black latches inward in a downward motion, once the screwdriver head gets inside the grey latch holder it will free the black latch. Work on each of the four latches in turn.7. Wiggle the plastic cover until it is completely loosened from the four latches. Gently lift the plastic cover up. The automatic gear shift will stop the plastic from being lifted out completely. You still have enough room to work with. You will see the little burned bulb directly below those 'P'ark, 'R'everse, 'D'rive letters. Gently pull the bulb out. I got my replacement bulb at Canadian Tire, Motomaster instrument replacement bulb 194LL (clear, long lasting, 2 bulbs for $2.99Cdn). It is a push-on bulb.8. Test the bulb by starting your car and dash lights.9. Snap back the plastic 'P'ark, 'D'rive cover. Put back the rear console panel and finally the rectangular 'cushion' around the automatic gear shift.

Dec 17, 2011 | 2006 Toyota Corolla

1 Answer

I need to remove nearside rear door window from Ford Focus 2003 , it has electric motor gear but I am unable to get the peg to push out from the plastic block which holds the window glass in, how do I get...


SECTION 501-11: Glass, Frames and Mechanisms 2003 Focus Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/24/2003 Rear Door Window Regulator and Motor adobe.gif Printable View (208 KB) Removal and Installation
  1. Remove the rear door speaker. For additional information, refer to Section 415-03.
  1. Remove the side impact bolster.
    e0001157.gif
  1. Position the door latch release handle aside.
    e0001156.gif
  1. ani_caut.gif CAUTION: Do not touch the adhesive surface, as re-bonding will be impaired.
    Remove the watershield.
    e0001158.gif
  1. Connect the window operating switch electrical connector.
    e0001851.gif
  1. Align the regulator clamp with the access hole.
    e0008374.gif
  1. Remove the window glass from the regulator clamp.
    1. Push out the pin.
    1. Push out the sleeve.
    1. Remove the window glass from the regulator clamp.
    e0001854.gif
  1. ani_caut.gif CAUTION: Make sure the window glass is adequately supported at the top of the opening.
    Using suitable hooks, raise and secure the window glass.
    e0001855.gif
  1. Disconnect the window operating switch electrical connector.
    e0001851.gif
  1. Disconnect the motor electrical connector.
    e0001856.gif
  1. Remove the bolts and the motor and window regulator.
    e0008353.gif
  1. To install reverse the removal procedure.

Jul 26, 2011 | 2003 Ford Focus

1 Answer

Ford Focus 2007 Drivers carpet wet. Water coming down bulkhead. Could there be a drain blocked in the bodywork If it has a drain where is it and what do I need to do to access it Thanks Dave


Carpet wet on passenger side is likely a plugged drain for the a/c evaporator. It should drain on the ground out a small, short rubber hose sticking out of bulkhead on pass side. Or a poorly seated grommet for the evaporator drain. Also check the rear washer hose if it goes through the cowl area to the back wiper.

Apr 30, 2011 | 2007 Ford Focus (3 Door) Hatchback

2 Answers

How to remove rear door panel ford focus 2007?


How To Install Replace Remove Rear Inside Door Panel Ford Focus 00-07 1AAuto.com


Jan 06, 2011 | 2007 Ford Focus (3 Door) Hatchback

1 Answer

How to Remove Center Console on 1975 GMC Midas RV


If the van has a cup holder on the doghouse you should not have to remove it to get doghouse out. There are 2 latches on the sides of the dog house, one on driver side and one on passenger side about halfway between the floor and the dash, un hook these. Pull the carpet back from around the bottom of the dog house, there will be 2 clips held down with bolts, remove these. The doghouse should slide back, and out from under the dash, it might be necessary to remove the passenger seat to get the house out of the vehicle.

Apr 17, 2010 | GMC Vandura Cars & Trucks

1 Answer

Cannot unlock hatchback on Ford Focus 2005 LX


lock acutator in rear door stops unlocking does it work with key if not remove iner plastic panel to open

Apr 04, 2010 | 2005 Ford Focus

1 Answer

Replace the rear signal light bulb


Should be accessable from inside the trunk, behind the panel. Turn bulb holder counter clock wise, and remove from socket.

Oct 18, 2009 | 2000 Ford Focus

1 Answer

I'm dont able to remove rear drum on ford focus 2005


the bearing needs to come apart remove the silver cap you should see a cotter pin holding the spindle nut remove the pin then the lock shield for jam nut then remove jam nut be careful as bearing may fall out there is a washer between jam nut and bearing then you should be able to remove drum

Aug 18, 2009 | 2007 Ford Focus (3 Door) Hatchback

1 Answer

How to replace passenger mirror on 2007 Ford Focus


it has 2 screws. remove the pblack plastic triagle shaped cover for access. inside of the door.

Jan 18, 2009 | 2007 Ford Focus (3 Door) Hatchback

Not finding what you are looking for?
2013 Ford Ford Focus ST Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...