How to reset service light
I think the following will work:
1 . Insert key into ignition barrel.
2 . Press and hold the Reset switch
(located on the Trip Computer Switchpack).
3 . NOTE: The reset switch has to
be released immediately after the ignition is switched 'ON'. This is critical to
enable the rest of the procedure.
Turn the key to Ignition position II and at
the point of entering Ignition position II (i.e when a click is heard),
instantaneously release the Reset switch.
4 . Wait one second.
5 . Press
and hold the Trip switch (located on the end of the left-hand side stalk).
. Wait one second.
7 . Press and hold the Reset switch (whilst still holding
the Trip switch).
8 . The cluster should display (within three seconds) the
warning message 'RESETTING SERVICE MODE'.
9 . Keep both buttons pressed until
the warning message changes to 'SERVICE MODE RESET' (after ten seconds).
Once the message is displayed the buttons may be released â€" sequence is now
11 . If a Service Required message was displayed prior to the reset
sequence, cycle the ignition to 'Off' and then back to Ignition position II and
check that the message is no longer displayed.
Jul 12, 2011 |
2005 Jaguar S-Type