Question about 1992 Jeep Wrangler

1 Answer

Shift patterrn need shift pattern for recently purchased 92 yj with np231

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

5 speed 1st top left 2nd bottom left 3rd top middle 4th bottom middle 5th top right reverse bottom right
4wd 2wd top 4high one click down neutral shift to right then push down 4low bottom lowest point

Posted on Apr 23, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 393 Answers

SOURCE: 92 yj front axle

it actually moves a shift fork onto a spline. try moving fork by hand.

Posted on Nov 16, 2008

dttech
  • 4803 Answers

SOURCE: speedo 95 yj conversion 350 with 350 turbo trans

The vehicle speed sensor is located in the transfer case housing. To get your speedometer working you will have to connect the wires back to the speed sensor.

Posted on Nov 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What would make my np231 transfer case be stuck in 4 low


Year make and model? The switch, wiring, the module, the motor, or the shift fork is broken.

Aug 05, 2015 | Cars & Trucks

1 Answer

Transfer case diagram


the FSM has this, posted 100 times.here.
but this forum search engine sux.
here is 93 book , should do all that.

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Mar 26, 2014 | 1992 Jeep Wrangler

1 Answer

91 jeep wrangler YJ shifting problems


do you mean it wont go into gear ? if so what gears ? it could be the clutch going out , if the pedal is soft or easy to push down than it probably needs a clutch. next time it wont go into gear try pumping the clutch or putting it from 2nd to 1st or what ever gear it has problems with

Dec 18, 2013 | Cars & Trucks

2 Answers

Speedo 95 yj conversion 350 with 350 turbo trans and np231 transfer case 3.73 gears 33" tires wires cut off at transfer case and there is no speedo cable what do i need to get my speedo working


The vehicle speed sensor is located in the transfer case housing. To get your speedometer working you will have to connect the wires back to the speed sensor.

Nov 02, 2011 | 1990 Jeep Wrangler

2 Answers

My 89 Jeep YJ manual will not go in to reverse while running


Problem is likely either a worn shift fork or bad synchro (both inside the transmission) It's unlikely that you have a clutch problem otherwise the problem would be with first and reverse and shifting other gears would also be difficult.

Sep 01, 2009 | 1989 Jeep Wrangler

1 Answer

Missing factory throttle linkages on 1990 YJ jeep. Need Diagram


Go to any scrapyard and you can get the entire setup for next to nothing...and you can see how it's hooked up!!!

Jul 07, 2009 | 1990 Jeep Wrangler

1 Answer

92 prelude si (auto)


With normal acceleration the 1st to second shift point should be around 2500-3000 rpm. Most of your shifts under moderate acceleration will take place at this same point or when there a light load on the transmission. Under hard acceleration the RPMs will climp higher due to increased power needs and the computer will shift when less power is needed or the RPMs climb to an unsafe speed say5000-6000rpms (depending on where yours redlines). Also going up a steep hill will raise the RPMs higher and goind down a hill will cause a faster shift at lower RPMs. These can always be altered by an individual owner by adjusting shift points, using performance parts and if you have problems (low tranny fluid/trans issues). Your trans RPMS are fine and will vary depening on how your foot accelerates. The shift pattern should be the same every time you drive slow/medium/fast/, look for changes in those patterns you will also catch a problem early.

Jun 14, 2009 | 1992 Honda Prelude

1 Answer

1992 jeep yj transfercase swap


did you put transmission fluid back in the trans?

Feb 09, 2009 | 1992 Jeep Wrangler

1 Answer

92 yj front axle


it actually moves a shift fork onto a spline. try moving fork by hand.

Aug 05, 2008 | 2004 Jeep Wrangler

Not finding what you are looking for?
1992 Jeep Wrangler Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...