Question about 2010 Chevrolet Malibu LS

1 Answer

2010 chevy malibu P0108

Car has been acting funny. when my seatbelt is in the car reads that it is not and it continues to beep for me to put my seatbelt on, also car charger does not work when plugged into front or rear cigar lighter, dashboard light seems to dim at times then returns back to normal, Serice ESC/ Traction also appears, and as well as the fact that the car seems to stutter and shake a little bit when i let it run for a while not to sure why it seems to shake when i do that but i have a feeling it has to do with the problem code, any help is greatly appreciated.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,250 Answers

P0108 - MAP Pressure Circuit High Input means that the map sensor bad pressure or sensor defect
test terminals connector for ground and current if ok map defect
hope it helps

Posted on Mar 27, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: 2008 malibu service esc traction control and eng

The torque converter clutch circuit may be at fault. The best way to determine the problem is to have a scanner/computer to read check engine codes.

Posted on May 06, 2009

  • 1201 Answers

SOURCE: Burning smell,check engine light-misfire, rough idle 96 cavalier

Sounds like there is a blown piston, to be sure have a compression test done on that #2 cylinder, if the reading is low, then you'll know.
A friend of mine had a 95 that did simular things only a little more,
it started smoking, dash lights flickered, etc. Finally, he had to get rid of it, the piston rod went through the engine block.

Posted on Feb 02, 2010

  • 68 Answers

SOURCE: 2008 chevy malibu. cannot unlock doors from dirver

Intermittent door ajar switch contacts.

Posted on Mar 05, 2010

  • 2 Answers

SOURCE: I have a 2005 Chevy Impala, the Traction light

The ABS control Module is going bad, that all, since the ABS and traction work together you will get both lights on. Take to a mechanic, expect to spend about $500.

Posted on Sep 06, 2010

  • 1 Answer

SOURCE: 1998 Chevy Malibu Fuse panel diagram

turn heater on nothing but cold air

Posted on Oct 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Service vehicle soon light comes on off and on and the lights and windows act funny. 2001 malibu


Sounds like bad grounds Grounds are at the steering column, under the dash, and behind the kick/side panels on both sides or the car.

Apr 06, 2016 | Cars & Trucks

1 Answer

2000 Chevy Malibu ignition will not stop beeping when car is turned off and key is out


Chevrolet Malibu Owners: Problems & Solutions - Edmunds.com ...

www.topix.com > Ohio > Franklin County > Blacklick
Apr 9, 2010 - Goes Beep beep and then stops for several minutes and does it again. ...The alarm/ignition module needed to be changed @ dealer ($500.00 ++++) ... weak, replaced and voltage ranged from 12.12 to a max of 13.8 at 2000rpm. ... i have a 1981chevy malibu and when i try to start it wont turn over and the ...

Nov 08, 2015 | Cars & Trucks

1 Answer

Why do I hear my 2000 Malibu beep 14 times on the drivers side of vehicle and then stops?


Could be just a glitch. The BCM controls the beep through the radio. Thats why you hear for the speaker/drivers side. There are three possibilities for the beep. Door ajar with the key in the ignition, turn signal on too long, and seat belt unbuckled with the car running. Check for lights in the dash. no door ajar light, no seatbelt light. That could be the problem.

Oct 10, 2014 | 2000 Chevrolet Malibu

1 Answer

2010 chevy Malibu, starts but dies, over and over. just happened all at once no prior problems?


this just happened to me this morning then the ecs light came on i had to use my son in laws car to go to work my 2010 chevy will not stay running whats wrong i just got this car in feb 2013 Help

Aug 12, 2012 | 2010 Chevrolet Malibu

1 Answer

2004 chevy malibu I constantly hear a beep inside my car. What can it be?


The beeps happen when speeding up and passing other car

Jan 18, 2012 | 2004 Chevrolet Malibu

1 Answer

When trying to put fuel in my car. my car whouldnt allow me to put fuel in it. it acted like it was full and ran out on the ground. what could be the problem? chevy malibu 1999


there is a metal flap inside that is spring loaded, make sure you are pushing the neck of the gas can (assuming you are using one) all the way in making the flap open up.

Jul 23, 2010 | 1999 Chevrolet Malibu

3 Answers

I have a 2005 chevy malibu, and one morning it just wouldn't start, the car never showed signs of anything wrong, and when I turn the key it just make a beeping noise.


I have a Chev 2004 Malibu and so does my cousin.. This is a problem that A LOT of these cars have, but Chevy does not see this as a SAFTY issue... so they will not fix it. This problem will continue to happen to you.. there is NO way to fix it or by pass it. Basically your ingition is not recognizing your key, and this is Chevy's crappy way of keeping your car from being stolen. You will notice when your car doesn't start, your THEFT SYSTEM light is BLINKING... What you need to do is, when this happens to you, leave your key in the ignition, and turn it to ACC. Leave it there for approximately 10 minutes, until the THEFT SYSTEM light is SOLID, not BLINKING anymore. Turn your car off, and then turn it back on. Your car should start right up. I had this happen to me EVERY SINGLE TIME I got in my car for 2 weeks! Then it stopped and I thought it wouldn't do it anymore. But just as you need to be somewhere and you are running late.. THE CAR KNOWS!!! And it will do it to you again! Good luck!

Dec 22, 2009 | 2004 Chevrolet Malibu

Not finding what you are looking for?
2010 Chevrolet Malibu LS Logo

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...