Question about 1997 Acura RL

1 Answer

How do i replace my axel

Im scared my axel is about to fall off. is it expensive to get fixed

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,114 Answers

There is a right and left CV axle assembly for the car. The parts can be purchased starting at around 50.00 for each side (R&L) and up. This does not include labor. Yes, it would be several hundred dollars to have the CV axles replaced, but that's better than a hospital bill !

Posted on Mar 27, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix cv axels on a 2002 hyundai accent


It's not worth it to fix the axel, it is wise to replace the axels
by jacking up the car secure the car with jack stands, then remove the wheels, the big center nut of the axel and the lower bolts on the ball joint, then pry the lower control arm down and pull the hubb aside. Now u could remove the axel easily, if stuck take a hammer and tap it lightly, remove it, replace with the new but make sure both ends r lubed with grease.

Feb 21, 2015 | Hyundai Accent Cars & Trucks

1 Answer

Oil leaking on top trans axel 1995 toyota corella xl


Probably a bad valve cover gasket. Just replace it. Not expensive.

Aug 17, 2014 | 1995 Toyota Corolla

1 Answer

Knocking noise


Probably a bad "CV" joint on one of the front axels. The CVs go bad every now and then and are not too expensive to fix. Any auto shop can/will do the repair. You will need a new axel for left or right front.

May 14, 2014 | Honda Civic Cars & Trucks

1 Answer

No left wheel speed sensor signal and light is on and 4 wheel drive light blinks


The sensor operates in conjunction with the TONE RING, located on the axel under the sensor. The tone ring is probably physically broken due to rust swelling. The tone ring resembles a gear and the sensor "sees" the notches on the ring. When the ring breaks, the sensor can't read it correctly. Part is 6 bucks from rock auto. Installation is quite involved(remove axel). There are instructions posted somewhere online. Search! Get ready because I think all 4 wheels have this ring and they WILL all break at some point. Oh when the right front ring goes bad, you will think the motor is falling out. Clunk, bang. losses power but new ring will fix.

Mar 12, 2014 | Ford Escape Cars & Trucks

1 Answer

98 Blazer 4WD front axel falling out of differential


I would dismantle the axle, fit new thrust bearings and anything else that is worn/damaged and reassemble/adjust clearance gaps to it, according to the service manual.

Mar 12, 2017 | 1998 Chevrolet Blazer

1 Answer

How to remove rear axle 03 chevy silverado


You will have to remove the rear end plate off of the back of the rear end. Then turn the carrier untill you see a big silver pin that goes through the spider gears. Those will be 4 small gears in the rear end carrier. If you look at the right side of the carrier were the pin goes through it you will see a small bolt head, That bolt goes through the carrier and holds the pin in place. Remove that bolt then reach up in the rear end housing and push the pin towards you untill it comes out. ( DO NOT TURN ANYTHING AFTER YOU REMOVE THE PIN) are the spider gears will fall out.


Now get someone to push the axel in while you are looking at the 4 small gears in the housing, when they push the axel in a C-clip will fall off the end of the axel and into the rear end, You will see it fall out. Then just pull the axel out.



When you put the axel back in, push it all the way in then slide the c-clip over the end of the axel and then pull out on axel and that will hold the clip in place untill you put the big long pin back in the carrier. I hope you understand, just watch what you are doing. GOOD LUCK.

Oct 09, 2009 | 2003 GMC Yukon

1 Answer

CREEKING NOISE CONTD


You have a damaged Strut And possible spring damage.should have been changed when the work was carried out.

May 28, 2009 | 2002 Chrysler Sebring

1 Answer

Subaru cv axle noise?


Do you know if this car has ever been recked? if your going thru that many axels makes me think something is not running true, a wheel bearing would not make a cv joint in a axel go bad. Did you replace the axels? or did you have them done at a shop, and did you see the old axels after they were replaced. You got bigger problems than a wheel bearing. From what i can gather some thing is bent or your getting bunch of bad axels witch i dought.

Feb 05, 2009 | 1987 Subaru Gl 4WD

2 Answers

Replacing the rear axles on my 1987 monte carlo


You will have to remove the rear end cover then turn over by hand you will see a metal pin going through the smaller spider gears in the center there should be a small bolt there with a 5/16 head remove the bolt and then the metal pin then push in ward on the axles and a c plip will fall out only do 1 side at a time and do not rotate the axles other wise the gears will fall out and you will have another problem.

Jan 07, 2009 | 1987 Chevrolet Monte Carlo

1 Answer

Weird thing going on w/ the gas pedal on a '89 camry


have the exhaust hangers checked, it is very much possible your exhaust is loose and that is what your feeling.

Oct 30, 2008 | 1989 Toyota Camry

Not finding what you are looking for?
1997 Acura RL Logo

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...