Question about 2006 Pontiac Torrent

Open Question

P0717 torrent where is the input shaft sensor

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can the input speed sensor on a 2009 GMC Acadia be changed without having to remove the transmission


Did you do the diagnostic's that go to that code ?
DTC P0717: Input Speed Sensor Circuit Low Voltage
Diagnostic Fault Information
Circuit
Short to Ground
Open/High Resistance
Short to Voltage
Signal Performance
Input Speed Sensor Supply Voltage
P0717
P0717
--
P0716
Input Speed Sensor Signal
P0716, P0717
P0716, P0717
P0716, P0717
P0716
Circuit/System Description
The input speed sensor (ISS) is a hall-effect type sensor. The sensor faces the 1-2-3-4 and 3-5-R clutch housing machined teeth surface. The sensor receives 8.3-9.3 volts on the input/output speed sensor (ISS/OSS) supply voltage circuit from the transmission control module (TCM). As the 1-2-3-4 and 3-5-R clutch housing rotates, the sensor produces a signal frequency based on the machined surface of the 1-2-3-4 and 3-5-R clutch housing. This signal is transmitted through the ISS signal circuit to the control solenoid (w/body and TCM) valve assembly. The control solenoid (w/body and TCM) valve assembly uses the ISS signal to determine line pressure, transmission shift patterns, torque converter clutch (TCC) slip speed and gear ratio.

Circuit/System Verification
Engine idling, observe the scan tool Transmission ISS parameter while varying the engine speed. The Transmission ISS parameter should change with the engine speed and not drop out.
Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

Ignition OFF, remove the control valve body cover. Refer to Control Valve Body Cover Replacement.
Connect the TCM harness connector.
Disconnect the input speed sensor (ISS) from the control solenoid (w/body and TCM) valve assembly.
Connect the J 38522 between the supply voltage terminal B and ISS signal terminal A at the control solenoid (w/body and TCM) valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test for further instructions.
Set the J 38522 signal to 8 volts, the frequency to 120 and the percent duty cycle to 50.
Ignition ON, observe the scan tool Transmission ISS parameter. The scan tool Transmission ISS parameter should be between 100-400 RPM.
? If not within the specified range, replace the control solenoid (w/body and TCM) valve assembly.
If all circuits test normal, test or replace the input speed sensor.

Control Valve Body Cover Replacement

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement.
Remove the oil cooler inlet hose (1) from the retainer on the control valve body cover.
Remove the oil cooler outlet hose retainer nut (5) from the control valve body cover.
Remove the oil cooler outlet hose (4) from the retainer on the control valve body cover.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the left engine splash shield. Refer to Engine Splash Shield Replacement.
Drain the transmission. Refer to Transmission Fluid Replacement.

you don't need to pull thr trans .

Feb 19, 2017 | GMC Cars & Trucks

1 Answer

2010 Malibu error codes po700,po716,po717


DTC P0700: Transmission Control Module (TCM) Requested MIL Illumination

Which one of these transmissions does your Malibu have ?
Automatic Transmission - 4T45-E
Automatic Transmission - 6T40/6T45
Automatic Transmission - 6T70/6T75

Do you know how to find out look at the VIN # ?
DTC P0716: Input Speed Sensor Performance
DTC P0717: Input Speed Sensor Circuit Low Voltage
The automatic transmission input speed sensor (ISS) is a permanent magnet with a coil of wire wound around. The ISS mounts in the case cover facing the reluctor wheel of the input shaft. As the reluctor wheel is driven by the turbine shaft, an AC signal is induced in the input speed sensor. Higher vehicle speeds induce a higher frequency and voltage at the sensor. There is a fixed air gap between the sensor and the teeth on the sensor reluctor wheel. The ISS input is used by the transmission control module (TCM) in order to control line pressure, torque converter clutch (TCC) apply and release, and transmission shift patterns. This sensor is also used to calculate the appropriate gear ratios and TCC slippage. This diagnostic indicates stuck, erratic, or intermittent conditions in the system.
Diagnostic Aids
• Road test the vehicle while monitoring the Transmission ISS parameter on the scan tool. The Transmission ISS parameter should vary with engine speed changes and not abruptly drop out.
• Inspect for an open or shorted AT ISS wire.
• Inspect for a disconnected AT ISS connector.
• Inspect for a faulty AT ISS.

Trouble Code P0717 Input speed sensor

Jan 19, 2017 | Cars & Trucks

1 Answer

On a 1996 Cad. Deville, where is the tubine speed sensor located?


press the helpful button and follow me on fixya for more tips
Input speed sensor is located inside the transmission. The sensor is located next to the sprocket for the input shaft. The sensor is held in place with 2 6mm bolts, one for the sensor, one for the wiring harness.

Input Speed Sensor P0717 Replacement

P0717 ISS Speed Sensor Code Cadillac Deville Eldorado Seville Fleetwood...

Vehicle Speed Sensor Removal Installation

Feb 01, 2016 | Cars & Trucks

2 Answers

I have a trouble codes p0717 and p0700 on a 2006 Cadillac cts 3.6 the car shifts crazy and while pushing on the brake it locks up anyone know what's going on please help


P0717 is for the transmission input speed sensor , which inturn will bring up the other code P0700 for the Trans Control Module , so i would suggest having the codes cleared and see if they come back as sometimes a glitch can occour , if codes reappear and so do the symptoms i would replace the input speed sensor , it reads the primary pulley speed and sends info to the TCM and as far as i know there are no diagnostic s to carry out as this sensor either works properly or fails so get it changed and hope its not the TCM as well, keep me posted if you wish

Jul 30, 2015 | Cadillac Cars & Trucks

1 Answer

Check engine light car jerking


P0717 Input/Turbine Speed Sensor Circuit No Signal
_______________
gm tech2

Jan 23, 2013 | Cars & Trucks

1 Answer

Po717


P0717 Input/Turbine Speed Sensor A Circuit No Signal, no its not what you may think,, don't go looking for a turbo or anything, heres what it means

The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft. It knows which gear you're in because it commanded the transmission to shift into that gear. So, with the input speed, the gear selection, and the output speed, the computer can calculate how efficiently the transmission is working. If the speed is off, it knows that something is slipping inside the transmission. It can then try to boost the fluid pressure to compensate. If that doesn't work, it sets a different trouble code.

The P0717 code means that the computer isn't getting any signal from the sensor. Either the sensor is dead or there's a circuit issue (bad wiring, etc).

Sep 22, 2011 | 1999 Pontiac Grand Prix

3 Answers

I am getting a p0717 code, when i am driving and have to stop the car if i try to take off on drive it wont move, i have to shift it to a lower gear for it to move.


P0717 - Input/Turbine Speed Sensor Circuit No Signal.

P0717 code means that the computer isn't getting any signal from the sensor. Either the sensor is dead or there's a circuit issue (bad wiring, etc).

The computer wants to know if the transmission is working properly. So it reads the speed of the input shaft and compares it to the speed of the output shaft. It knows which gear you're in because it commanded the transmission to shift into that gear. So, with the input speed, the gear selection, and the output speed, the computer can calculate how efficiently the transmission is working. If the speed is off, it knows that something is slipping inside the transmission. It can then try to boost the fluid pressure to compensate. If that doesn't work, it sets a different trouble code.

Hope helps (remember to rate and comment this answer).

Dec 21, 2010 | 2003 Suzuki Aerio

1 Answer

98 Buick Park Avenue (Turbo) P0717 fault code,


CODE PO717 IS - A/T INPUT SHAFT SPEED SENSOR LOW INPUT CONDITIONS.YOUR INPUT SHAFT SPEED SENSOR COULD BE DEFECTIVE.CHANGE FLUID + FILTER IF IT HAVE NOT BEEN CHANGED IN A LONG PERIOD OF TIME.

May 29, 2010 | 1998 Buick Park Avenue

1 Answer

Engine and tcs light on car stalling and rpms


p0134 is oxygen sensor fault code
p0717 is turbine shaft speed sensor (no signal) fault code

May 27, 2010 | 2001 Hyundai XG300

2 Answers

I got a P O 717 code what is it ???


P0717: Input/Turbine Speed Sensor Circuit No Signal.
This code shows because the computer isn't getting any signal from the sensor. Either the sensor is dead or there's a circuit issue (bad wiring, etc).

The Input/Turbine Speed Sensor is the sensor the computer uses to to monitor the the efficiency of the transmission. The computer reads the speed from the input shaft and compares it to the speed of the output shaft. If the speed is off it attempts to correct it by boosting the fluid pressure to compensate. When that fails it trips the P0717 error code. In most cases either the sensor is dead or there's a problem in the wiring harness.

There are issue of intermittent connection trouble with this circuit. That would cause the on off problem.
Hope this helps.

Nov 11, 2009 | 2003 Buick LeSabre

Not finding what you are looking for?
2006 Pontiac Torrent Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...