Question about 2006 Holden Commodore SS

1 Answer

How to bleed cooling system

I am trying to bleed the cooling system of a Holden Statesman 1998 vs 2 supercharged.Can you tell me the procedure please

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 79 Answers

To bleed the cooling system on a vs supercharged statesman .

Makes sure you have coolant in the radiator and over flow botthe.

turn the heater to the on position and on high.

make sure you have plenty more coolant close by.

with the radiator cap off and the engine idling .

now top coolant up and place radiator cap on.

increase idle revs so the system pressurises.

now the system is warm and pressure .

you can open the bleeder 1 by 1 starting at the highest point.

1st couple of times you open the system you will get a lot of air ,you can stop bleeding this nipple once there is a good stream of coolant flowing.

do the same with other nipples as there is 3 bleeders in total.

Once all air is out do not open radiator cap again top coolant up in overflow bottle only.

double check coolant level again when its cold ..

Posted on Feb 19, 2015

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: what is the vaccume routing on a 98 statesman with factory supercharged engine.

Dealers don't stock the manual, said look online

Posted on Jul 23, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vacuum diagram wh L67 1999 holden statesman ?


I've just put L67 vacuum lines into "images" on bing and got all sorts of pictures, start there?

Nov 15, 2014 | Cars & Trucks

1 Answer

How to replace bonnet struts WK holden statesman


To Replace bonnet struts on a wk statesman you will need to flow the procedure below.
1.Open the bonnet fully
2.Replace one at a time .
3.Now bonnet is open grab pole and place under bonnet for extra support.
4.The strut will be mount to a ball and on the side you will also see a little rectangular clip .
5.Use a small flat blade screw drive to pop clip out once the clips out you will be able to gently work the strut off the ball on top and bottom.
6.same procedure to fit new strut

hope this helps

Jul 07, 2014 | 2006 Holden Commodore SS

1 Answer

Vs holden commodore


Best to replace battery .there should be 2 sets of keys.

Jul 05, 2014 | 1995 Holden VR Statesman

2 Answers

What is the vaccume routing on a 98 statesman with factory supercharged engine.


Go to library and see if they have repair manual for this car. Otherwise buy one at dealer.

Jun 29, 2014 | Holden Caprice Cars & Trucks

1 Answer

Holden engine


check for condition of the air intake pipes and vacuum hoses as a small split could cause this sort of symptom ,try a fuel addative to give the fuel system and engine components a good clean through ( bit like a decoke but a lot easier and cheaper) may have to repaet to get full benefit follow the makers instructions

May 21, 2014 | 1995 Holden VR Statesman

1 Answer

V6 supercharged statesman wh hard to start every morning its like its out of fuel


Is engine light on? Check for codes . Most likly Tempeture sensor is out of range.

Mar 28, 2014 | 2002 Holden Caprice

1 Answer

VS statesman no horn / airbag light on


that work should be done in a garage ,as danger of setting off the airbag .

Dec 23, 2013 | Cars & Trucks

1 Answer

Where is the bleeder valve on cooling system on 6 litre holden statesman


i got 3 bleeding valve on my car 1 on top of the pump 1 at the back on top of the thermostat and 1 on the left side of the radiator

Mar 13, 2013 | GMC Rally Cars & Trucks

2 Answers

Supercharged v6 staesman misfire and blowing smoke


cylinder head gasket or a valve stuck slightly open you can get valve cleaning spray from halfords spray in to air intake while engine running should free valve otherwise head gasket renew

Feb 20, 2009 | 1999 Mitsubishi Eclipse

Not finding what you are looking for?
2006 Holden Commodore SS Logo

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Holden Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14381 Answers

Are you a Holden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...