Question about 2007 Lexus GS 350 AWD Sedan

Open Question

Front axle remove

Rt frt axle removal

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front axle 2002 highlander


to remove front axle.to loosen front axle nut leave vechicle weight on wheel then just loosen front axle nut because axle nut torque at 217 ft lbs torquehard to loose axle nut with vechicle weight off wheel.okay. you need a 1/2 breaker bar and axle socket to loosen axle nut dont use 12 points sockets need go auto parts store buy right socket for axle nut.okay when you loosen front axle nut you need safely raise support vechicle. need to remove wheels remove fender apron seal remove transaxle fluid remove transfercase oil if you have 4WD.remove hub nut remove stabilizer bar link remove speed sensor remove tie rod end remove lower arm from the ball joint then slide the halfshaft from the hub then carefully pry the shaft from the transaxle.then install new front axle push in make sure front axle snap ring on front axle snap in place inside transmission just pull a little on front axle make its in place. when all done tighten front axle much as you can then when done putting every thing back in place.lower vechicle need torque front axle nut to 217 ft lbs.

Jan 12, 2013 | 2002 Toyota Highlander

1 Answer

Passenger side frt. axle


thats about it drive shaft might be a pain to get loose though use a small jemmy or large screwdriver to remove from gear box side

Aug 25, 2012 | 2000 Dodge Durango

1 Answer

Rear brake line was removed and now i need to bleed the system 1997 chevy blazer any special tools needed ?


you need a 1/4 or 5/16" wrench and procedure requires bleeding all corners staring with furthest away from master cylinder working your way closer (Rt Rr, Lt Rr, Rt Frt, Lt Frt)

Mar 02, 2011 | 1997 Chevrolet Blazer

1 Answer

1999 volvo v 70 front axle removal


Don't know how to lock in the front axle (Rt) side the passenger side?

Oct 16, 2010 | 1999 Volvo S70

1 Answer

CHANGE RT FRT WHEEL BEARING 1994 BUICK REGAL ...3.8.....FRT WHEEL DRIVE


You will have to remove the wheel,of course,remove the brake caliper,pads,and the brake caliper bracket,then the rotor,and any brackets holding the brake hose to get it out of the way.Then remove the large nut on the axle,and remove all the bolts holing the bearing assembly on the spindle,and tap it out ward,and make sure the axle stays put,do not let the axle come outward with the bearing,using a two by four to tap the axle inward toward the axle while removing the bearing assembly.If this was at all helpful,please rate,thank you.

Aug 20, 2010 | Buick Regal Cars & Trucks

1 Answer

4 wheel drive wont engage to front end drive shaft is turning and actuator is moving


acuator at transfer case or at frt diff if acuator is moving then axles to wheels should be turning and you may have a hub locking problem. if axles to wheels dont turn then the acuator tofront diff is no good not strong enough or bent shaft on acuator, some of these use a small shaft in front of actuator also make sure if this truck use this shaft check it for wear, lift truck remove actuator push inside arm in see if wheels spin turn frt shaft while holding arm in wheel should turn is they do, replace actuator, if they dont turn then diff problem,

Dec 06, 2009 | 1990 Chevrolet K2500

1 Answer

How to install front axle 99 buick regal (right front)


remove axle nut, remove nut on lower balljiont seperate control arm from spindle. pull back spindle and slide frt part of axle out of hub, then pry axle out of trany . good luck.

Nov 02, 2009 | 1999 Buick Regal

1 Answer

How to remove frt bumper on 325 bmw


remove 8mm screws at r and l side splash sheils, remove t 50 torx bolts under bumper cover on either sdie of where the front lic plate cover goes, pull away from body of vehcile and disconnect the fog lights if equipped

Oct 08, 2009 | 2001 BMW 325

3 Answers

How do I change the fluid since there is not a dip stick on my 2001 Grand Am


you use a trans flush machine or drop the trans pan to answer your question----------------Or what you realy want how do i check my fluid & add. The car must be jacked up level on the passenger rt frt of trans in frt of drive axle there is a 11mm bolt you must must pull out with car running it should dribble out for proper level. To add on drivers left frt on top off trans under air cleaner tube to engine there should be a RED sometime black large plug to unscrew to fill about 7quarts of fluid

Oct 06, 2009 | 2001 Pontiac Grand Am SE

1 Answer

2001 dodge neon, 5 spd std, has whirring noise in rt frt wheel


YES THE CV AXLES DO MAKE A SIMILAR NOISE WHEN GOING BAD BECAUSE THE CAGE THAT THE BALL-BEARINGS ARE IN VIBRATE AS THEY ROTATE. A CLICKING SOUND AROUND TURNS ARE ANOTHER INDICATION OF BAD CV AXLES.HOPE THIS SOLVES THE PROBLEM. KEEP ME POSTED PLEASE. GOOD LUCK AND THANKS FOR YOUR HONEST RATING. THANK YOU NALSO FOR USING FIX-YA. WITING FOR YOUR REPLY.

Apr 25, 2009 | 2002 Dodge Neon

Not finding what you are looking for?
2007 Lexus GS 350 AWD Sedan Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...