Question about 2003 Nissan Maxima

1 Answer

My car will not go over 2,500 rpm what the problem?

Why won't my car engine go over 2,500 rpm with out kicking back or stalling

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

It's in limp mode check the mass air flow sensor then have if any codes cleared my need to have the throttle sensor re calibrated I think dealer can only do.

Posted on Apr 23, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Chrysler Pacifica won't go over 3000 rpm


When your driving or when in park?

If it wont go over in park this is normal. It is the rev limiter kicking in so that the engine will not self destruct.

Mar 11, 2013 | Cars & Trucks

1 Answer

.Engine stalls, won't idle, bucks at 3700rpm


Sounds like mass airflow sensor to me or your timing jumped. Probably high miles too, eh? Could possibly be voltage regulator but I highly doubt it.

Jan 16, 2013 | 2001 Ford Explorer

1 Answer

I replaced the camshaft sensor, the car starts but once i get up to 2,500 rpm the car stalls still, what should i do next?


if i were you i change the crank sensor but if u wanna make sure 100 percent put a scanner on the system see what it comes up to do that you have to take it to mechanic :(

May 25, 2012 | 2004 Chrysler PT Cruiser

1 Answer

Runs rough under load ,stalls and won,t free rev over 4000 rpm. Acts like rev limiter kicks on.


Hi

one of 3 faults

1 MAF sensor also Known as air mass sensor
2 EGR valve, this is most common with the 4000 rev limit and a top speed of say 50 mph
3 air leaks or tears in air pipes or poor seals.

I would be tempted to clean both the EGR and MAF sensor before spending any money though, these parts ofetn work much lonegr when clean

Regards

Dan

need more info get back to me

Jan 03, 2011 | 2000 Buick LeSabre

1 Answer

2003 Honda CR-V when the A/c compressor kicks on the engine drops 300 rpm, like it's going to stall. It's making a clunk noise when kicking on and I changed the battery thinking it was weak.


sounds like it's the iacv or idle air control valve not working due to dirt in the orifice or the iacv is burnt out and cannot turn correctly, or the wiring to it is faulty.

Good luck on the repair.

If the A/C compressor makes a clunk noise when kicking on, that could indicate a worn out compressor.

You're right, 300 rpm is way too low. It should be closer to 600 or 700 or 800 rpm and remain smooth when the a/c compressor kicks on.

Nov 07, 2010 | 2002 Honda CR-V

2 Answers

Why does my 2000 ford taurus idle so high when i start it


this is normal, if the idle wasn't high (about 2,500 RPM) the engine wopuld stall out until it warms up to normal temperature. If it is above 3000 RPM for more than a few seconds you have a problem.

Mar 25, 2010 | 2000 Ford Taurus

4 Answers

Slow reving to 2,500, then strong


Weakening fuel pump or clocked fuel filter(s)

Feb 19, 2010 | 1991 Honda Civic

1 Answer

Engine almost stalling when ac is turned on


you may have a faulyt IAC sensor not idling up enging when a/c is on

Jul 22, 2009 | 2003 Chevrolet TrailBlazer

Not finding what you are looking for?
2003 Nissan Maxima Logo

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...