Question about 2006 Mazda Tribute

1 Answer

My key while in the ignition won't turn over or start car, warning light with car and a key in it flashes. What is the problem? Car is 2001 Mazada Tribute.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 4 Answers

The key is tied to the computer which controls the engine. Apparently the key you are using needs to be reprogrammed to the computer. The dealer can do this for you.

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Chev Malibu. Turn key on to start car, won't start. No warning lights on no lights on gauge panel. Radio works, dome light work.


check the ground leg to your engine.. it runs off the neg. battery terminal. will connect to frame and engine.. pull it off, wire brush it put it back.. you radio will work, 'cause it draws much less current, and is grounded in dash.

Jan 11, 2013 | 2001 Chevrolet Malibu

Tip

How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe


Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident. <br /> The flashing light on your car is telling there is a problem. <br /> <br /> <b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b> <br /> Ignition Key Method: <br /> <ul> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li> <li>Wait 4 seconds.</li> <li>Turn IGNITION on (but don't start car).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 2 seconds.</li> <li>START Car (the light may be blinking slower than before).</li> <li>Wait 3 seconds.</li> <li>Turn IGNITION off.</li> <li>Wait 3 seconds.</li> <li>START Car.</li></ul> <br /> <b>This is a little easier</b> To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away

on Dec 07, 2010 | Infiniti G35 Cars & Trucks

1 Answer

How to reset the change oil light on 2001 chevrolet suburban LS


Turn the ignition key to on position, but do not start the vehicle.
Wait for the "change oil light" to come on
Tap the throttle pedal three times quickly
Wait for the light to flash several times, then go out.
Start the car and drive and it won't come back on.

It usually works the first time, but repeat if light stays on.

Jul 28, 2012 | 2001 Chevrolet Suburban

1 Answer

I have a 2001 Olds Intrigue that won't start every once in a while. When it won't start the security light flashes so GM told me it was the passcode and I would have to change the ignition switch...


you can not bypass the security in that car, it is built into the main computer, they have problems with the ignition switch screwing up and the only way to start it while the light flashes is to turn the key to ON but don't crank engine, leave on for 10 to 15 minutes until light goes out then start car.

Sep 21, 2011 | 1998 Oldsmobile Intrigue

1 Answer

I have a 2006 I280 iszuzu pickup the antitheft was engaged and won't start how do I fix it?


MAKE SURE YOU USING THE RIGHT KEYS. TRY ANOTHER IGNITION KEY.PLACE KEY IN THE SWITCH. TURN IGNITION SWITCH TO ON POSITION UNTIL IMMOBILIZER WARNING LAMP ILLUMINATES FOR 2 TO 3 SECONDS. IF IMMOBILIZER WARNING LAMP ILLUMINATES FOR 2 TO 3 SECONDS THEN FLASHES RAPIDLY.KEY CODE NOT RECOGNIZED.REMOVE KEY AND TRY AGAIN. IF ALL FAILS TAKE CAR TO DEALERSHIP THEY HAVE TO USE DIAGNOSTIC EQUIPMENT TO FIX CAR.PROBLEM COULD BE IN THE IGNITION SWITCH,BCM,FAULT IN THE ECM OR IMMOBILIZER CODE INCORRECT.

Jul 04, 2011 | Isuzu i-280 Cars & Trucks

1 Answer

My car stopped without warning or flashing lights after it started and drove for a few second. After it stopped, I tried to restart it and it won't start, it will make a cranking noise as if its...


Have you check the fuel filter?
Is there any spark on the spark plug cable? If there isn't any spark, you might check the ignition coil and ECU

Jun 23, 2011 | 2001 Jeep Grand Cherokee

1 Answer

Ignation wont start


If your battery checks out, but the starter is still silent, it may be a faulty ignition switch. Turn the key to the on position (not all the way to start). If the red warning lights on your dash don't light up (and your battery connections are clean), the ignition switch is bad. If they do light up, turn the key to the start position. The dash warning lights should turn off at this key position (most cars). If you're not sure, turn on the headlights. When you try to start the car, the lights should either dim (a lot) or turn off completely. If they do, your ignition switch should be ok. If not, the switch will need replacement.

Jan 16, 2011 | 2001 Pontiac Grand Am SE

1 Answer

Ignition key won't turn 2001 626 mazada


did you damage your key in some way take pressure off your steering wheel turn steering wheel some while turning key could have damaged your ignition

Nov 29, 2010 | 2001 Mazda 626

2 Answers

Dasboard lights flash and warning beep operates (Seat Leon 2001)


flashing dashboard lights when the ignition is turned off

Dec 01, 2009 | 2001 Volkswagen Golf

Not finding what you are looking for?
2006 Mazda Tribute Logo

537 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...