Question about 2002 Ford F150 Regular Cab

1 Answer

How to install front shocks

How do you install front shocks on a 2002 ford -150 supercab 4x4 with 5.4 triton engine ?

Posted by on

1 Answer

Are they coil overs?

If so- you remove them & have a shop put them
into a spring compressor & swap out the shocks
or rent a small spring compressor

Watch the You Tube Video

Posted on Mar 26, 2014

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

SOURCE: ford f 150 supercab

The backs don't fold down. The seats only fold up.

Posted on Oct 02, 2008

  • 14036 Answers

SOURCE: Were is my fuse box on my 2005 Ford F-150 4.6


Posted on Jul 26, 2009

  • 984 Answers

SOURCE: 2002 f150 5.4 triton 160000 miles fx4 supercab

Sounds like the transfer case is signaling the GEM OK, but best to check it.
Jack up and support the front of the truck with jack stands ( and chock the wheels, normal safety precautions )
Turn the key to the on position ( do not start ).
Turn the switch to 4H, after the clicks are done and the cluster indicates 4x4, check the front drive shaft.

If the front drive shaft will not turn, it could be a problem with the vacuum motor or the vac solenoids, or the mechanics in the front axle.

If the front shaft will still turn, the problem is in the transfer case.

I am leaning towards the vac motor on the front, the vac lines, or the vac solenoids.

After the test above, lower the truck, start the truck ( wheels chocked, person have the parking brake on, and foot on the brake, safety precautions ) , and have someone turn the ESOF switch to 4H. The vac motor is the disc on the front axle. This should move when 4H is selected.

You can check vac on the pink and blue lines.
Pink is 4WD vac on the hose.
Blue is 2WD vac on the hose.
Should be able to draw vac on the line, and have it hold with a mighty vac or other vacuum pump & gauge.

Posted on Dec 07, 2009

  • 75797 Answers

SOURCE: where are the spark plugs located in a 2002 F-150

they are under the individual ignition coils in the valve covers

Posted on Dec 31, 2009

  • 29 Answers

SOURCE: what oil should i use

Just use whatever is recommended by Ford. It should show u on ur oil cap or on the sticker that's under the hood. All Ford vehicles use either 5w-20 or 5w-30

Posted on Apr 12, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why wont truck stay running.

Check the alternator! It may be bad!

May 15, 2014 | 2005 Ford F-150 SuperCab

1 Answer

What is the recommended trailer towing weight (a suitable range would be ideal) for the F-150 4x4 Supercab XLT Triton, 5.4L EFI V8 Engine, with 17" wheels and 145" wheelbase?

Depending on the gear ratio of your vehicle you have a max capacity of 8,500 or 9,500lbs. Your ideal trailer weight for this vehicle I would say is between 5,000 and 8000lbs. For more info on towing Click here.

Dec 31, 2010 | 2006 Ford F-150

1 Answer

How to replace the window regulator on the front windowsof a 2005 ford 150 triton pickup truck

  1. Remove the front door trim panel.
  2. Remove the front door watershield.
  3. Secure the front door window glass in the full upward position with tape.
  4. Remove the front door window glass-to-regulator assembly bolts.
      • Loosen the glass clamp fasteners through the 2 vertical slots in the inner door panel.
      • To install, tighten to 9 Nm (80 lb-in) .
    1. Disconnect the front door window electrical connector.
    2. Remove the front door window regulator bolts.
      • To install, tighten to 11 Nm (8 lb-ft) .
    1. Remove the front door window regulator and motor.
    2. To install, reverse the removal procedure

Aug 15, 2010 | 2005 Ford F-150

1 Answer

Where is the strater on an F-150 triton

should be at the spot where the trans meets the engine, on the right lower side. about 4 or 5 o'clock

Feb 23, 2010 | 2000 Ford F150 Flareside SuperCab

1 Answer

I need instructions on how to set the timing on a 2002 ford super duty f 250 with the 5.4 triton v 8 n im haveing trouble setting the timing

timing chains you mean? thats complicated, you will need to have a repair shop print some pages out of a computer manual for you. Most shops can do this for a small fee.

Oct 19, 2009 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Just put a tuneup on my ford f-150 93 and mixed up

Firing order is 1-5-4-2-6-3-7-8.
On the distributor,it goes counterclockwise (CCW). Passenger side is cylinders 1-2-3-4 (front to back). Driver side is 5-6-7-8 (front to back).

Sep 05, 2009 | 1993 Ford F150 SuperCab

2 Answers

Location of cylinder 4

here is the cylinder layout diagram for thios engine.

Apr 15, 2009 | Ford F-150 Cars & Trucks

Not finding what you are looking for?
2002 Ford F150 Regular Cab Logo

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers


Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides