Question about 2011 Nissan Frontier Cab

1 Answer

2011 Nissan Frontier radio will not turn off when ignition is turned off and key is out. I have to turn the radio itself off.

Truck is all stock no aftermarket add on. Truck bought new and I have been the only owner.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 151 Answers

I think you can fix car audio by just reset. It's not a big problem, go to ask your close dealer.

Good luck!

Posted on Mar 25, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Pattods
  • 116 Answers

SOURCE: 1998 nissan frontier 4x4

Well since the lights are controlled by the OBD (on board diagnostics), you'll have to reset it. You may be able to do this by simply disconnecting the battery for a few hours. However, a lot of newer vehicles have electronically locked radios which require the manual to be able to be re-enabled.

I'd check out the radio before disconnecting the battery.

The only other ways are to physically disconnect the lights in the dash or get someone with an OBD reader to clear the codes.

Posted on Sep 13, 2008

  • 36 Answers

SOURCE: 2005 nissan frontier crew cab won't start

Make sure you have 12 volts from the positive side of the battery to the starter. Check the small wire on the starter solenoid and make sure you have 12 volts when cranking engine. If voltage is correct, the starter is bad

Posted on Jan 03, 2009

localwonder
  • 6784 Answers

SOURCE: 2004 Nissan Xterra. Battery died and now the radio will not turn

Hi, check the fuse box for a blown fuse in the radio slot. sometimes during jumps, this fuse will blow.

Posted on Mar 06, 2009

  • 103 Answers

SOURCE: 1999 nissan frontier is idling rough the truck

This can be your Idle control valve, when you turn the air on it puts the engine under load and your computer will increase the idle automatically to prevent the engine from cutting out.
When you are standing still and the car is shaking, by touching the accelerator very softly does the shaking stop? If so check the idle control valve.
I hope this will help.
Regards
Sam

Posted on May 13, 2009

  • 21 Answers

SOURCE: 99 nissan altima 4dr. key will not turn ignition

sometimes if the steering wheel is in a bind the switch will not turn try turning the wheel a bit while at the same time turning the switch good luck

Posted on Aug 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the ignition timing for 2002 nissan hardbody 2000i 16v


Here are the 3 engines listed for this year. IGNITION TIMING

2002 Nissan/Datsun Truck Frontier Pickup 2WD 2.4L SFI 4cyl

The Ignition Timing

18-22 DegreesBefore top dead center - When throttle positionsensor disconnected and using suitably programmedscan tool.When adjusting idle speed, set parking brake & chock drive wheels, curb idle speed (750-850 RPM)transmission in neutral.

IGNITION TIMING

2002 Nissan/Datsun Truck Frontier Pickup 2WD 3.3L SFI 6cyl

The Ignition Timing

8-12 DegreesBefore top dead center - throttle position sensorharness disconnected.When adjusting idle speed, set parking brake & chock drive wheels, curb idle speed (700-800 RPM)transmission in neutral.

IGNITION TIMING

2002 Nissan/Datsun Truck Frontier Pickup 2WD 3.3L SFI SC 6cyl

The Ignition Timing

8-12 DegreesBefore top dead center - throttle position sensorharness disconnected.When adjusting idle speed, set parking brake & chockdrive wheels, curb idle speed (700-800 RPM)transmission in neutral.

Jun 05, 2015 | Nissan Hardbody Cars & Trucks

1 Answer

How to bay pass alarm for nissan frontier 2000


Impossible to bypass. YOu must fix the underlying problem

Jul 27, 2017 | 2000 Nissan Frontier

1 Answer

2005 frontier stop running


Does the truck try to start when you turn key all the way? do you have any power to it, the lights, radio etc? if not clean your battery terminals with a can of coke and wipe down with a rag after about 3 mins....
Otherwise:
Check if you hear fuel pump when u turn key on but before starter engages... if you hear it then you have ruled out the fuel pump as being the cause....
Also make sure if its an automatic transmission, that its actually in park all the way... If it is then it may be your shifter switch is bad.

Feb 24, 2013 | 2005 Nissan Frontier

1 Answer

Where can i find the starter on a nissan frontier 2004


The starter on the Nissan Frontier is a motor that is connected to the battery that runs the ignition process of the truck. When you turn the key to start the truck, this will send an electrical signal to the starter motor that turns the flywheel. The flywheel in turns moves the crankshaft. When the starter goes bad or teeth on the starter gear get chipped this will prevent the truck from starting. Locating the starter is the first step in replacing it.
  • Open the hood to access the engine compartment. Locate the battery to the passenger side of the engine compartment.
  • Identify the positive terminal of the battery. This will be indicated by the (+) symbol above the terminal.
  • Trace the red cable that is attached to the positive terminal. The cable will run from the battery down to the side of the motor.
  • Locate the end of the red cable as it is attached to the starter. The starter will be attached to a bracket by the motor with the back of the starter connected to the bell housing of the transmission.
  • Remove the front passenger side tire for easier access to the starter. This will also give you plenty of room to remove the starter.
I hope this helps.

Good luck.

Dec 03, 2010 | 2004 Nissan Frontier

1 Answer

I have a 2001 nissan frontier and the key is in the lock position in the ignition. how do i unlock and start the car.


If the wheel was turned a certain way to engage the wheel lock when turned off, turn the wheel all the way to the right or left while trying to turn the key. Chances are the column lock is catching preventing you from turning the key. You may have to use force but do not use too much force if it does not seem like it will give.

It should "pop" free while turning on the wheel.

Jun 07, 2009 | 2001 Nissan Frontier Crew Cab

Not finding what you are looking for?
2011 Nissan Frontier Cab Logo

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...