Question about 1995 Toyota 4Runner

1 Answer

Transmission problem Replaced seloniods still won't work

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 133 Answers

Need more info as too what problem you are experiencing.

Posted on Mar 30, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

93 honda accord ex won't upshift at all replace tcu same issues . At first was fine now it's worse after changed tcu. Is the tranny shot . Also replaced vsp and seloniods? Any ideas ?

if there are no noises and the transmission shifts properly when it works , then a replacement transmission should be the last consideration
controls in the transmission are electronic and are shared by the VSS ( vehicle speed sensor ) . TR sensor ( transmission ratio sensor) and the TCM
the wiring may be your problem and a problem vacuum actuator is indicated as that tells the rest when to change in relation to throttle opening
if you have not changed the oil in the last 5 years or 60,000 miles , that would be a good place to start

Jun 29, 2017 | Honda Cars & Trucks

1 Answer

Why won't it engage first gear?

Check for proper transmission fluid level first.

Sep 27, 2015 | 1995 Cadillac Eldorado

1 Answer

Transmission slips

pull the trans pan of and the filter there are 2 located in the front of trans on the passenger side the 1 on the furthest on the passenger side is for first and second the other is for 3and 4 theres a roll pin holding it in pull it out with plyers twist it back and fourth it should pull out and un plug it

Apr 13, 2014 | 1994 Isuzu Rodeo

1 Answer


Check the following:
1 Transmission control rod
2. Manual valve
3. Parking lock pawl.
4. CV Joints.
5. Transmission fluid level.
6. Any dent on oil pan.

Mar 25, 2014 | 1995 Toyota 4Runner

1 Answer

94 f150 speedometer

Check speed sensor at transmission.

May 29, 2013 | Cars & Trucks

1 Answer

91 Cherokee will crank but won't fire. Replaced

how much is the RPM showing in the datatlogger while cranking?

Dec 03, 2012 | Cars & Trucks

1 Answer

99 chevy blazer idles rough when comming to a stop in drive

Could be your Torque convertor Lockup clutch Seloniod. Maybe the clutch doesn lock as it should and the transmission makes the engine bumps . if you ever drove a stick then you would know what i;m talking about as when you go to a stop light you have to push the clutch if not the car will be jumping untill it stalls. because in the automatic there is the Torque convertor lockup cluch that locks the transmission from making it stalls and in the Manual there is the clutch pedal. Hope this is clear and helps. Good luck

Dec 11, 2010 | 1999 Chevrolet Blazer

1 Answer


Bad ignition switch or starter seleniod

Sep 06, 2008 | 1991 Jaguar XJ6

Not finding what you are looking for?
1995 Toyota 4Runner Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides